Question about 1995 Mazda 626

Open Question

Where is my diagnostic module located in mazda 95 626 lx

Posted by Anonymous on


3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 12 Answers

SOURCE: location of 2006 mazda 3 airbag module.

look under the cup holders in the center console - should be simple to take out once you lift the emergency brake handle up.

Posted on Sep 30, 2010

  • 44 Answers

SOURCE: My 2002 Mazda Protege Lx

Look near the driver's area under the dash for a an OBD-II port and borrow a scan tool from Autozone (they do tool rentals, cheaper than buying one). Pulling the codes will give you an idea of what is going on, you can then work from there.

Posted on Aug 01, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Location of vacuum modulator for transmission 1995 Ford Crown Victoria LX

There is no vacuum modulator valve , this transmission is all electrical controlled . What seams to be the problem ? no shifting , shifting hard ETC....... shift solenoid inside the transmission maybe , input or out put speed sensor bad . Do you have a check engine light lit ? There probably is a DTC - diagnostic trouble code .

Dec 05, 2015 | Ford Cars & Trucks

1 Answer

I have a 98 Mazda protege Lx that will not start. I purchased a new radiator and thermostat. Coolant and radiator completely flushed. Car check engine light started flashing two days later.

Readout all stored codes with an ODB-II reader.
Aside from that, there is no magic "fix" button, so you will have to perform standard diagnostics on the fuel and ignition systems to determine the source of the problem.

May 11, 2015 | Mazda Cars & Trucks

1 Answer

I've got a 2000 mazda protege lx 1.6 I'm trying to find the location of the computor for my car or computors if there are more then one I have no clue. Anything will help!

mazda has typically put them one of 3 places.

1. passenger floor board. there is a panel under the carpet on the passenger's side where they have put it on some models.

2. under the dash. it will be kind of obvious but don't confuse it with any of the other control modules.

3. under the center console. there are very few with them located here, but it will be in the center console in front of the shifter if applicable.

Check these places and you will find it.
Best wishes!

Nov 06, 2013 | Cars & Trucks

1 Answer

My 2002 Mazda Protege Lx will buck while traveling along, not too often. I suspect the Electronic Control Module for the Transmission or possible sensors for the module. Where is the module and sensors...

Look near the driver's area under the dash for a an OBD-II port and borrow a scan tool from Autozone (they do tool rentals, cheaper than buying one). Pulling the codes will give you an idea of what is going on, you can then work from there.

Aug 01, 2011 | 2002 Mazda Protege

2 Answers

Where is the fuel filter located on a 2001 Mazda Protege 2.0 LX?

A 2001 Mazda Protege (actually, all models from 1999-2003 including the DX, LX, ES, Mazdaspeed, and Protege 5) does not have an inline fuel filter. The only fuel filter it has is a "strainer" or a "screen", which looks like a nylon mesh "sock". This strainer is connected to the fuel pump, located in the gas tank. Although this fuel strainer does not require periodic replacement, it is recommended that it be changed if you are replacing the fuel pump.

Jun 15, 2010 | 2001 Mazda Protege

1 Answer

Wheres the starter located on 1997 mazda 626 lx,4cylinder?

where is the starter located on a mazda 626 1997

Jun 11, 2010 | 1997 Mazda 626

1 Answer

Just bought a mazda 626 LX hatchback. Noticed

This can be caused by few things but most likely by moisture. Mazda's immobilizer has this weekness that if it gets some dampness it can kick in. But to be 100% sure what was it it is best to get diagnostics test done.

Apr 29, 2010 | 1992 Mazda 626

Not finding what you are looking for?
1995 Mazda 626 Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8732 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides