Question about Cars & Trucks

Open Question

Safety or electric switch keeping gehl 5635 from starting.

My skid loader won't attempt to start but has plenty of battery. Jumper cables will cause it to start and continue for several hours before it fails again.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

autodr
  • 260 Answers

SOURCE: 1996 cavalier will not crank

when it wont crank, you will need a test lite to ck the small wire at starter for a 12 volt signal when commanded to start by the key. also make sure there is 12 volts from battery going to larger wire on starter. if so and still wont crank, starter replacement is probable. (assuming grounds are clean) they can be very intermittent. another quick test would be while trying to start, holding key in start position, rap lightly on starter with hammer to see if it kicks, if so, replace starter.

Posted on Nov 30, 2008

Louie_3006
  • 79 Answers

SOURCE: 1997 Neon dies, starts after electric fuel pump relay swapped

Hello, I would assume this is your fuel pump inside your tank. I would first however do some basics like a general tuneup. For starters I would replace your spark plugs and wires, rotary cap and button and check your fuses. Run some injector cleaner through your system. You know quick simple cheap things before you get to the fuel pump inside the gas tank which can be kinda expensive. The warm up then dies can be caused by, "blownout or fouled," spark plugs. I hope this gives you a general direction in which to go. A sidenote is that coil packs do not normally run an igntion code and I for one do not like them becuase they are expensive.

Posted on May 20, 2009

bhshark84
  • 5 Answers

SOURCE: 2002 Taurus starts & then dies. After an hour, it is OK for weeks

put a volt meter on the battery when you get the problem to occur, I have run into intermittent problems and found that when cranking the battery voltage drops below 9 volts and when the voltage drops below 9 the pcm powertrain control module does not know what to do and will cause the problem you are talking about, if it drops below 9 volts check and clean power and ground connections and have you battery tested, your local autozone will test it for free, and most likely your battery is going bad. and auto zone installs batteries for free also.

Posted on Sep 18, 2009

  • 116 Answers

SOURCE: 2007 chevy cobalt ls won't

Ignition relay or fuse could be the problem. When you turn the key to start do you hear a fuel pump kicking on and or do you have spark when you hot wire the starter (I know it's hard to check while trying to start it)? You can email me back and I might be able to pinpoint it more.

Posted on Jun 06, 2011

jgwhomeequip
  • 1902 Answers

SOURCE: the car won't start; lights,

Check the starter and the starter relay or fuse. A client of mines car was doing the same thing, it ended up being two issues, the starter not working anymore, and a relay that was bad. If I am not mistaken everything should be labeled in the fuse box under the hood and will tell you where the fuse/ relay is for your vehicle

Posted on Jun 12, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1987 GMC truck with manual trans and in order for it to start I have had to press very hard on the clutch then it starts.Now it won't start anymore, how do I bypass the clutch safety switch?


replace the clutch switch or temporarily you can unplug it and jumper the 2 wires together. make sure you tape or cover the jumper wire so it won`t short out. you can try to adjust the switch as well.

Jul 27, 2015 | GMC Cars & Trucks

1 Answer

What is the oil level for a gehl 3310 skidsteer loader finaldrive chains0 gehl oil level finaldrive chains


Consult owners manual, check for fill plug about half way up the case. When the oil get to that level that should be plenty.

Feb 15, 2015 | Cars & Trucks

4 Answers

2003 Pontiac Grand Am Gt gave a guy a somewhat jump yesterday and now my car won't start the battery tested good however it doesn't even attempt to start. Help!


i seen light flashing look like security light.look like vechicle in theft mode problem in the theft security.try to turn ignition switch to the on position 10 minutes until security goes out.then turn off ignition wait 5 seconds see if engine starts if yes problem in the theft security system.if theft security system working okay problem could be starter or starter solenoid.could have faulty neutral safety switch or clutch start switch faulty.make sure battery volts is 12.6 volts let auto parts store do load test see if battery has a bad cell plate shorting

Sep 23, 2013 | Cars & Trucks

1 Answer

2004 Mercedes c240 won't start, turned the


It is located on the transmission where the sghift cable connects to the transmission.

Jun 12, 2013 | Cars & Trucks

1 Answer

1996 Acura 3.5 RL won't start


Try putting battery voltage directly to the starter solenoid

If the starter works then the control circuit is not working,
fuse,worn ignition switch,neutral safety sw & such

If you use jumper cables directly to the starter that will eliminate
that if it works

Mar 09, 2013 | Cars & Trucks

2 Answers

My truck won't start battery is good y won't it


how can anyone help you with out knowing what our working on..

Jan 21, 2013 | Cars & Trucks

1 Answer

Truck won't start unless i jiggle wires under dash.


I doubt it unless you are moving the wires coming out of the switch.
Sounds like a bad connection or broken wire in the harness you are moving around.
It could involve the neutral safety switch and the harness you are moving could come from that switch.

Jan 11, 2013 | Cars & Trucks

1 Answer

2009 corolla hooked up jumper cable backwards, car won't start


TAKE OF BOTH CABLES AND GROUND THEM TOGETHER FOR 30 OR SO MINUTES, THIS WILL RESET THE CARS MEMORY, TEST VOLTAGE ON BATTERY WITH VOLT METER & IF IT IS BELOW 12.31V THEN CHARGE THE BATTERY , ONCE BATTERY CHARGED HOOK UP BATTERY LEADS (TO RIGHT TERMINALS) & ATTEMPT TO START CAR, IF ALL YOU GET IS A CLICK THEN LOCATE THE STARTER MOTOR & GIVE IT A FIRM WHACK WITH A HAMMER (SERIOUSLY) THIS WILL FREE UP THE STARTER & WILL ALLOW THE CAR TO CRANK

Sep 02, 2012 | 2009 Toyota Corolla LE

1 Answer

My 1988 Jeep won't start when I crank over the engine. It will turn the motor over a few times then I lose battery power. With a cold start it sometimes will start on first attempt but it has gott


it sounds like the starter is bad but first run a pair of jumper cables from the battery to the starter and the other jumper on the ground side just to make sure you don't have a bad cable larger parts stores can test it off the car if you bring it to them

Aug 31, 2012 | Cars & Trucks

2 Answers

2003 buick century won't start. Ignition switch goes clickety-clickety. Can still lock doors and the lights come on. Noticed the "check engine" light but don't know if it would stay on...


Just because the battery has enough power to operate the lights and door locks does not mean it would pass a load test. If the battery checks out OK then check the battery cables. use one side of a pair of jumper cables to bypass each cable starting with the negative cable. if the vehicle now starts, replace the cable. The positive cable is harder to check using this method. attach one end of the jumper cable to the starter terminal making sure that the end of the jumper cable is not touching the engine and then attach the other end to the positive terminal of the battery. If sparking occurs when this end is connected then the jumper cable is touching ground and must be repositioned. If the problem still exists then the most likely cause is the starter solenoid. Always wear safety glasses when working around a battery.

May 13, 2011 | 2003 Buick Century

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

139 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...