Question about 2006 Dodge Caravan

Open Question

Replaced egr valve engine light still wont turn off

Replaced egr valve and engine light stays on 2006 grand caravan 3.8l

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2006 Dodge Grand Caravan - EGR code

I replaced the EGR Valve ($80 after tax), problem solved, vanruns great now. Now my problem is that I can't get the light to turn off.

Posted on Oct 06, 2008

Ad
  • 1 Answer

SOURCE: Replacing the EGR valve on a 2004 Dodge Caravan 3.3L engine

I repair mine last summer,
It is on the exast port, left.
You have a tube attach to it, going in the Head Cover.
Easy to change. it cost me $105.00CND at the dealer

Good Luck
Jonathan Lévesque

Posted on Feb 28, 2009

  • 412 Answers

SOURCE: where is the EGR valve located on my 2006 dodge

IT IS LOCATED ON THE FRONT OF THE FRONT CYLINDER HEAD(BELT END) OF ENGINE..JUST ABOVE ALTERNATOR..2 BOLTS HOLD IT TO HEAD,A METAL TUBE COMES OFF IT..1 ELECTRICAL CONNECTOR..MORE LIKELY ELECTRICAL SIDE OF VALVE IS DEFECTIVE(SOLENOID)
..RECOMMEND REPLACING VALVE..ABOUT 120 BUCKS FROM DEALER..YOU WILL NEED A NEW TUBE GASKET AND NEED TO DISCONNECT BATTERY WHILE REPLACING..HAVE SEEN CODES RETURN EVEN REPLACING A DEFECTIVE VALVE..WAS A TECH TIP FROM CHRYSLER ENGINEERING..I HOPE THIS HELPS

Posted on Aug 01, 2009

SOURCE: how to install egr valve on 2006 dodge grand

You cannot clean them purchase a new one and pull the old one out of the valve cover, and disconnect the hose that runs to it. install the hose on to the new egr with a new worm clamp and push the other end into the valve cover. should take about 10 minutes.

Posted on Sep 12, 2009

  • 2 Answers

SOURCE: 2006 Grand Caravan: Can't get pcv valve from a 3.8 dodge grand caravan...

I just replaced mine and had the same problem. If you look at the new one, you should find a small hole at the base of the metal tube. Using a mirror, I located the same hole in the one in the valve cover and inserted a pointed awl into it and was able to pry it out. Do it slowly since you are prying against plastic. When inserting the new one, I found that it should not be inserted as far the original one was and has a gentle snap.

Posted on Jul 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2006 Dodge Grand Caravan check engine light has been coming on and off recently. There are no other symptoms-it seems to be running fine. The computer code indicated an EGR 404 code. Where should I...


Yes clean it. Clean the holes in the intake also. A stiff wire in the intake will break anything loose. what you break loose will not hurt your engine. First just unplug the wire connector and plug it in. clear the codes. Some times it's just a bad connection.

Jul 02, 2011 | 2006 Dodge Grand Caravan

1 Answer

Egr code what does it mean


if its the 3.3 then the code would be--0406 egr sensor A curcuit high--- the common fix is to change the egr valve assembly which includes the egr transducer. This egr valve has also a high failure rate and you can check this out by calling the Dodge parts dealer. good-luck !! once egr valve is replaced. have light turned off with scanner. because if it stays on, pcm thinks it still has the problem. it will not send right info to pcm.

Jan 29, 2011 | 2006 Dodge Grand Caravan

1 Answer

Code P0 406 engine light stays on, I disconnected the battery cable and the code disappeared but came back on 10minutes later Is this the EGR value and would you suggest cleaning or replacing.


I would suggest you disconnect the vacuum hoses,plug and road test
If issues go away,replace the valve

Todays Valves are Electronic,no cleaning to do

Nov 10, 2010 | 2006 Dodge Grand Caravan

1 Answer

EGR Valve code (check engine) then van won't start or even turn over. Battery is OK. Can EGR valve be causing this?


The EGR will not interfere with the starting of the van.
I would make sure the shifter is in Park (or neutral) and try again.

Aug 07, 2010 | 2006 Dodge Grand Caravan

1 Answer

2006 3.8 dodge grand caravan is not getting gas. fuel pump and egr valve have been replaced. after the fuel pump was replaced it worked for 4 days until i was sitting on an upgrade (hill) at a stop light...


You have a fuel pump relay that sends power to the fuel pump. Do you hear the fuel pump turn on when you start the van? If not then check the relay. sometimes you can have someone tap the top of the relay while the key is being turned. If it starts then change the relay. about 10$ from rockauto.com.

May 25, 2010 | 2006 Dodge Grand Caravan

1 Answer

2006 Dodge grand caravan 3.8L


the EGR valve assembly should be in the back of the engine near the fire wall and the brake booster

Feb 26, 2010 | 2006 Dodge Caravan

1 Answer

How to install egr valve on 2006 dodge grand


You cannot clean them purchase a new one and pull the old one out of the valve cover, and disconnect the hose that runs to it. install the hose on to the new egr with a new worm clamp and push the other end into the valve cover. should take about 10 minutes.

Sep 11, 2009 | 2006 Dodge Caravan

1 Answer

Main bolt for alternator has been removed.


a 1/4"10 mm swivel will break it loose then it sould only be finger tight i have never crossed one any tighter keep the top on tight until the bottom comes loose

Sep 04, 2009 | 2006 Dodge Grand Caravan

1 Answer

Where is the EGR valve located on my 2006 dodge grand caravan 3.8L?I was told thats why my engine light has came on and was also told to try and clean it out before I pay to have it replaced. Hard to...


IT IS LOCATED ON THE FRONT OF THE FRONT CYLINDER HEAD(BELT END) OF ENGINE..JUST ABOVE ALTERNATOR..2 BOLTS HOLD IT TO HEAD,A METAL TUBE COMES OFF IT..1 ELECTRICAL CONNECTOR..MORE LIKELY ELECTRICAL SIDE OF VALVE IS DEFECTIVE(SOLENOID)
..RECOMMEND REPLACING VALVE..ABOUT 120 BUCKS FROM DEALER..YOU WILL NEED A NEW TUBE GASKET AND NEED TO DISCONNECT BATTERY WHILE REPLACING..HAVE SEEN CODES RETURN EVEN REPLACING A DEFECTIVE VALVE..WAS A TECH TIP FROM CHRYSLER ENGINEERING..I HOPE THIS HELPS

Jul 31, 2009 | 2006 Dodge Grand Caravan

2 Answers

2006 Dodge Grand Caravan - EGR code


I replaced the EGR Valve ($80 after tax), problem solved, vanruns great now. Now my problem is that I can't get the light to turn off.

Jul 14, 2008 | 2006 Dodge Grand Caravan

Not finding what you are looking for?
2006 Dodge Caravan Logo

Related Topics:

214 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...