Question about 2001 Mazda Millenia

1 Answer

Car won't start...

Car will not start, turns over good, replaced battery and neg battery cable and crankshaft sensor.... smell gas when cranking... can hear fuel pump clicking before trying to start.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 18 Answers

CHECK THE FUEL PRESSURE REGULATOR BY REMOVING VACUUM LINE AND LOOK FOR FUEL.

Posted on Nov 02, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: rough idle when cold and hot

have you replaced coil pack? Check EGR passage through upper mainfold and make sure clean. also make sure EGR valve not stuck part way open. Also check crank and cam sensors along with MAF.

Posted on Oct 19, 2009

stormbrewin
  • 426 Answers

SOURCE: 2000 mazda MX-5 1.8l

Have you checked that you have power to the coil on cranking?You may also want to check wether you have a good strong spark at the spark plug.It could be an ignition module breaking down.If you have no power to the coil you may need to change the ignition relay.Its close to the battery.

Posted on Oct 26, 2008

  • 3600 Answers

SOURCE: cranks but won't start fuel pump not coming on

put a small amount of fuel in the intake near the throttle plate then crank and see if it fires, if it does then it's a fuel problem, if it does not fire then pull a plug wire and put a philips head screw driver into the plug wire hold it 1/4 inch away from a good ground then have someone crank it over, you should see spark and it should be blue, if not then you have a ignition problem a bad coil or cam sensor but need to know what you found out on the two tests I told you first to give you a direction to go.

Posted on May 29, 2009

  • 246 Answers

SOURCE: mazda 323 died and won't start, has fuel, spark,

it's possible you have a clogged fuel filer. change it out and try the thumb plugging again.

Posted on Feb 17, 2010

  • 557 Answers

SOURCE: i am trying to get a 1990 mazda b2600i running but

wrong vacuum line hooked to fuel regulator

Posted on Oct 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heater won't turn off. Error message on display panel says "c". Heater blowing on High.


Disconnect neg / grnd battery cable. Replace Heater Blower Resistor. This will allow the heater blower to operate correctly

Mar 03, 2013 | 1989 Cadillac Sedan DeVille

3 Answers

Died as i was driving , won't start


Fuel filter,air filter,spark plugs,crankshaft sensor,any codes.

Feb 02, 2013 | 2006 Mitsubishi Galant ES

1 Answer

Hey guys, my caravan started this morning then shut off and won't start again. Heres what I did so far checked fuel pump fuse good, fuel pump relay good swapped with other. Removed neg battery cab


If you have voltage at the fuse and relay, and at the pump, but no fuel pressure, I would say the pump has died or the tank is empty.
Have you checked for voltage at the pump yet ?

Jul 24, 2012 | 2005 Dodge Grand Caravan

1 Answer

98 gmc safari. Starts sometimes and doesn't other times. Fuel pump tests fine, new fuel filter and crankshaft sensor. Can't afford to keep doing process of elimination.


Check battery cables at battery may be loose or corroded don't disconnect unless memory is maintained always remove neg first and don't reconnect until pos is connected and tight

Apr 02, 2012 | GMC Safari Cars & Trucks

1 Answer

The car turns over like it is going to start but won't. It is still firing, has good battery, alternator and gas in it. It is a 1996 plymouth neon. Started fine when I went to work this morning, b


tell individual working on it to check the crankshaft sensor voltage and signal when it wont start also check the fuel pressure and cam sensor, these are all possible problem with that particular car. it also has wiring issues that an expert tech would have to diagnose

Feb 29, 2012 | 1996 Plymouth Neon

1 Answer

Engine cranks but,won't start, I pulled a spark plug and touched threads to ground (with cable attached) while helper turned key to start, and got no spark. fuses are good, battery is strong. how do i...


check for signal getting to coil with a l.e.d test light the coil should have 12v pos going into it and the neg side should pulse when the motor is cranked. if no input is there check c.s.p sensor.

Oct 28, 2011 | 1996 Toyota Tercel

2 Answers

2001 won't start. turns over but doesnt even act like its firing. sometimes there is a smell of gas like it is flooded. started back in jan when it was cold. replaced battery and spark plugs to no...


check the color of your spark if it is blue your good if orange replace coil dependig on your setup and if you have 1 coild or 8 coils you many have to check each cylinder seperate just pull out spark plug replace the spark plug wire have someone try to start car and lood at color of spark i should note dont hold the wire just let it rest close by

if that is ok replace your crankshaft postion sensor as it tells the cars ecu when and to what cylinder to fire spark to faulty crankshaft postion sensors 99 percent of the time wont allow car to start or very hard starts the other 1 percent

if it helps please leave good review 4 thumbs

May 09, 2011 | Chevrolet Tracker Cars & Trucks

1 Answer

93 jeep grand cherokee won't start. It turns over but doesn't start. It gets gas..i have replaced the spark plugs, coil, distributor cap, rotor, and wires.I have an optima battery which is still working...


If you have no spark, the most likely problem is a bad crankshaft position sensor. it is mounted on the bellhousing. below intake/exhaust manifold. held in by 1 bolt. A new CrankShaft position sensor should come with a small pice of heavy paper/ thin cardboard to use to set proper air gap between flywheel and sensor.

Sep 12, 2010 | 1993 Jeep Grand Cherokee

Not finding what you are looking for?
2001 Mazda Millenia Logo

385 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...