Question about 2005 Volkswagen Jetta

1 Answer

Fuses voltages for fuses

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Normal domestic/automotive fuses don't have "voltage" ratings as such. They have CURRENT ratings in amps-A or milliamps-mA (1/100 of an amp). Thus 0.5A = 500mA.

Typical car "blade" fuse ratings vary from 5A to 15, 25 or even 30A. The current rating is shown on the fuse itself or the colour of the fuse body (yellow, red, green etc). I'm not sure if their is a standard between body colour and rating in Amps.

Domestic fuse wire ratings (little used these days due to circuit breakers being used) are typically 5A for lighting and 15A for power circuits.

Cheers,

Kitski

Posted on Nov 02, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Low voltage rear fuse box. 05 Trailblazer.No windows, ignition cranking power.


Low voltage rear fuse box ???? how low , how are you measuring ??? Volt meter ? Cable that supply's B+ voltage has high resistance . I/P BATT fuse #48 125 amp fuse supply's B+ voltage to the rear fuse box.

Aug 15, 2017 | Cars & Trucks

1 Answer

On a 2006 chevrolet silverado 1500, where is the back brake light fuse?


Stop Lamps
The STOP LP 25-amp fuse in the underhood fuse block supplies battery positive voltage to the normally open stop lamp switch. When the driver presses the brake pedal, the switch contacts close and battery positive voltage is supplied to both the STOP 15-amp fuse and the center high mounted stop lamp (CHMSL) 10-amp fuse in the instrument panel (I/P) fuse block, and to the turn signal/hazard module. The turn signal/hazard module then supplies voltage to both of the trailer rear turn/stop lamp supply voltage circuits. The voltage from the CHMSL 10-amp fuse is to the CHMSL and the trailer jumper harness. The voltage from the STOP 15-amp fuse is to the stop lamps, throttle actuator control (TAC) module, and the cruise control.

Apr 08, 2017 | Chevrolet Cars & Trucks

2 Answers

No power to diagnostic port or fuel or ignition or starter pulse 03 vibe any ideas


All these have different fuses, except a main fuse that supplies power to the different fuses. Check those first. Check power from the battery to the fuse panel. Could be a bad fuse panel. If you check voltage with a volt meter, does it show any voltage at the fuses? If 0, then look to the wires first. If they show varying voltage(like2,3,4.5,or 6) suspect the fuse panel. The voltage should be 0 or battery voltage.

Dec 18, 2016 | 2003 Pontiac Vibe

1 Answer

Have changed bulbs and checked fuses still no lights or turn signals in rear


Did you check voltage and ground, anywhere? Any fuse circuit has to have voltage, even if the fuse is good, if no voltage on the fuse circuit, the circuit is still dead. Use a test lite to check for voltage. Any electrical circuit needs voltage and ground.You have to start testing, somewhere.
What is year--make--model??

Apr 26, 2016 | Cars & Trucks

2 Answers

My 2011 Chevy Malibu tail lights are out, is it a fuse or bulb? Thanks


IF both lights are out most likely a fuse, check the drivers manual for location of fuse, check both sides of the fuse with a test light, must be voltage both sides, no voltage , cable from light switch to fuse faulty. voltage to only one side of fuse, fuse faulty. voltage to both side of fuse , cable to tail lights faulty, bulbs faulty or bad earth to tail lights.

Mar 03, 2016 | Cars & Trucks

1 Answer

My heater doesn't work. The blower just quit


Did you check for voltage and ground at blower motor connector, with hvac on. See what your missing, voltage or ground? In the diagram, the top wire is voltage for blower motor and bottom wire is ground, note the wire colors. Use a testlite to check for voltage.

Check for voltage at applicable fuses. Even if the fuse is good, if no voltage at the fuse circuit, the circuit is still dead. Some fuses are hot all the time, some go hot with the key on.

26046072-kefqwt3emzr0ti2xbwtbkh14-4-0.jpg

Jan 09, 2016 | 2000 Ford Expedition

1 Answer

How do i find wiring diagram for stop lights


The STOP LP 25 A fuse in the underhood fuse block supplies battery positive voltage to the normally open stop lamp switch. When the driver presses the brake pedal, the switch contacts close and battery positive voltage is supplied to both the STOP 15 A fuse and the CHMSL 10 A fuse in the I/P fuse block, and to the turn signal/hazard module. The turn signal/hazard module then supplies voltage to both of the trailer rear turn/stop lamp supply voltage circuits. The voltage from the CHMSL 10 A fuse is to the center high mounted stop lamp (CHMSL) and the trailer jumper harness. The voltage from the STOP 15 A fuse is to the stop lamps, throttle actuator control (TAC) module, and the cruise control.
Do you know what a stop lamp switch is ? If so I would check it with a DVOM digital volt ohm meter , after you check fuse .
Did

Nov 05, 2015 | 2005 Chevrolet Chevrolet Avalanche 1500 LS

1 Answer

2000 chevy astro van everything dead no power tonothing is there a mainfuse somewhere all the fuses are good


Did you check for voltage, anywhere, use a test lite follow the positive battery connections check for voltage. Did you check fuse circuit for voltage? Even if the fuse is good, if no voltage at fuse circuit, the circuit is still dead. Of course voltage is no good without ground.

The battery circuits, positive and negative good?

Mar 27, 2015 | 2000 Chevrolet Astro

1 Answer

No voltage to electric fuel pump relay?


voltage comes from fuse box, should have a fuel pump fuse, check for blown fuse, if not try jumping a fused wire from 12 volts to relay and see if fuel pump runs, hope this helps ?

Sep 03, 2012 | 2002 Kia Sportage

1 Answer

MY 95 ford ranger keeps blowing the voltage regulator fuse. the battery and alternator checks good


Well... If there is a fuse for a Voltage Regulator...then it stands that is the fuse is blowing, then the output from the voltage regulator is exceeding specs. The fuse is protecting the circuits the receive power in that circuit. Replace the voltage regulator. You should be good to go.

Jun 20, 2011 | Ford Ranger Cars & Trucks

Not finding what you are looking for?
2005 Volkswagen Jetta Logo

149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...