SOURCE: Keyless Remote 2008 RAV4
You can take it back to the dealer, and have them change the battery, or go to Autozone, buy the battery and do it yourself. They can show you how to do it. And which battery it takes. It's not hard to do. Good luck.
SOURCE: BACK DOOR HANDLE BROKEN.. HOW CAN I OPEN?..OR REPAIR?
I have had the same issue twice...My mechanic was able to open the hatch from the outside using an offset screwdriver. When the handle breaks you have a small opening that you can insert the offset screwdrive in...You can feel around and find the actual trigger that releasese the lock....You have to push down on it...and puff it will open..
The reason this happens is that the lock gets gummed up and rusts...It is a porr design...I make sure I lubricate at least once a month to enssure it does not get gummed up
SOURCE: 1997 Toyota Avalon Key Fob is not working
you can take it to a dealer and they can reprogram it for you.. good luck keith...
SOURCE: 2001 toyota rav4. how do you deactivate the alarm
Followed your recommendation of holding the valet (red) button for 6 seconds. It deactivated the alarm system and I was able to start the vehicle. This solution saved me from buying another key from the dealership (139$) and a programming charge of (100$). And not to mention the time saved from towing the vehicle to the dealership. I can't thank you enough for time and money saved with this valuable service. Will be signing up with your service when I get back from Orlando.
SOURCE: replacing tail light bulbs on 2001 Toyota Sequoia
Remove the two screws holding the tail light cover in place along the edge of the tail light assembly.
After you remove the two screws in the back panel, you have to pull the assembly out towards the side of the vehicle. You
cannot pull it straight back from the trunk or you will break the pins that hold the lens cover onto the side
of the SUV.
There are two pins that allow the light cover to be secured against the
back of the truck. One pin is towards the top, the other pin is towards
the bottom.
Twist out the bulb assembly.
Pull out the bulb
Insert the new bulb
Twist back in the bulb assembly
Place the pins over the pin holes in the light cover mold on the side of the truck
Push in gently Replace screws and you are done.
40 views
Usually answered in minutes!
×