Question about Cars & Trucks

Open Question

Craftsmen tractor model 917.273100 transaxel oil change directions

How do you drain and replace transaxel oil with transaxel filter change? What type ans weight oil and where are drain & fill holes in transaxel?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 92 4runner standard transmission oil change

Purchase a reasonably priced manual from your parts retailer it will make your life a lot easier with maintenance and small repairs of your car and remember if your still not sure about it check with an helpfull mechanic. if your vehicle has the factory books they will list how much oil and what type you need to use

Posted on Jul 14, 2008

  • 1 Answer

SOURCE: How do you change the oil filter on a Hyundai Accent 1998/99?

Replace the oil filter after draining the old oil, and" BEFORE "adding new fresh oil, otherwise you'll be dump all that fresh oil, on the ground,while you "TRY to get the new filter installed.

Step 1 Remove drain plug,Drain oil into drain pan
Step 2 Remove oil filter
Step 3 Reinstall drain plug,qnce oil has drained.
Step 4 Fill new filter with oil,lube seal on filter.
Step 5 Install new filter, Add fresh oil to proper level.replace filler cap
Step 6 Run engine check for leaks.
Happy motoring!

Posted on Jul 10, 2009

kevinj650
  • 82 Answers

SOURCE: car won't start after oil change jaguar S type

Sounds like overfill oil pressure too high. Oil level is critical. Engine can be damaged.
See my Solution for oil change.

Posted on Jul 10, 2009

  • 490 Answers

SOURCE: what type of oil to use for my Toyota Tacoma 4x4 V6 automatic

Go to any parts store and they will help you.Also you can go to your local Wal Mart auto dept,they have a book you can use for free.

Posted on Jul 24, 2009

  • 97 Answers

SOURCE: Jaguar 2003 S Type Oil change. Where's the oil

you will need to remove the plastic undercarraige panel below the engine compartment to access filter & drain plug. I have the same model and change my oil about every 2k miles what I did to my first oil change was to cut access holes below the filter and drain plug to allow for fast/frequent oil changes. Not having to remove panel will save about 2 to 3 hours removing and reinstalling panel or will significantly save $ on oil changes jag dealer charges 100 a pop do it yourself for about 20$

Posted on Aug 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do i change my oil


Drain old oil, replace filter, fill with new oil.
First find out how much oil your car holds, and what viscosity (you'll see on any new bottle of oil, 10w-30, 5w-30, 0w-20, etc.) Then find out what filter you need. Honestly walmart is your best bet. They will tell you which model your car needs. Get your car on a sloped surface, (you can buy plastic ramps cheap specially for this) and remove the plug from the oil pan Located toward the front of the car directly under the dashboard. You can google pics of an oil pan. Drain the used oil, find your old filter, remove it, replace, put the plug back in and fill it with however much yoyr engine needs. Most cars take 3 to 5 quarts. Good luck

Feb 27, 2015 | 2000 GMC Sierra

Tip

How to change the oil in your car


Attention: Read each step completely before you begin that task. Tools Required:
#1: Oil filter wrench or pliers
#2: Small wrench and sockets (Metric sizes for import cars)
#3: Oil collection device (pan or bucket)
#4: Funnel
#5: Cloth rag or paper towels
#6: Jack and stands or ramps
Supplies Required:
-Correct amount and type of oil, and thrust washer if necessary
-Correct oil filter
Step 1: Determine the correct oil type, oil filter type and size, and amount of motor oil for your car. (Information found in owner's manual)
Step 2: Park your car on level ground and turn off the engine.
Step 3: Locate the engine and make the oil pan accessible. (With the use of jack and stands or ramps) Tool #6 required.
kormega_11.jpg
Step 4: Remove oil cap. (Located on top on engine)
kormega_12.jpg
Step 5: Loosen oil drain plug. Collect oil when draining and dispose of properly. (Located on oil pan which is attached to the bottom of engine block, directly below oil cap)
Tool #2and 3 required
Caution: Oil will start to drain and may be hot
kormega_13.jpg
Step 6: Once completely drained (a slow drip), replace oil plug. Install new thrust washer with oil drain plug if necessary. Do not over tighten.
Tool #2 required
kormega_14.jpg Step 7: Loosen oil filter. Collect oil when draining and dispose of properly. (Attached to the side or bottom of engine)
Tool # 1 and 3 required
Caution: Oil will start to drain and may be hot
kormega_15.jpg Step 8: Install new oil filter hand tight. Lube the rubber O-ring on oil filter with motor oil, and make sure the O-ring from the old filter is not still on the oil filter connector.
kormega_16.jpgkormega_17.jpg Step 9: Pour correct amount of new motor oil into engine.
Tool#4 required
kormega_0.png Step 10: Check for oil leaks from drain plug or oil filter.
kormega_18.jpg Step 11: Turn on engine and continue to check for leaks. Tighten oil drain plug or oil filter if necessary.
Step 12: Turn off engine and check oil dip stick to see if the right amount of oil has been added. After removing oil dip stick, wipe clean with rag or paper towel. Reinstall oil dip stick and then remove again to see correct oil level. Then Reinstall oil dip stick again.
Tool #5 required
kormega_19.jpgkormega_20.jpg Step 13: Lower vehicle from jack and stands or ramps.
Step 14: Record the mileage of the car for future reference. (Motor oil should be replaced about every 3 months or 3,000 miles)kormega_21.jpg

on May 03, 2011 | Nissan Maxima Cars & Trucks

1 Answer

Transaxel gear oil leaking after five miles driving


If this is automatic you can be leaking at the banjo bolts,for manual the oil fill plug or oil drain plug,lift up the front wheels put the E brake on,do this all safetly,run the vehicle in gear wait and watch

Mar 09, 2012 | 1992 Acura Legend

1 Answer

How to change the oil on a 2004 dodge ram 1500


Go under the car and locate the oil pan directly beneath the engine and use a wrench to remove the drain bolt after placing a container under it. If you need to change the oil filter, that is also accessed from underneath, and you will need an appropriate sized oil filter wrench to remove it. (It is not always necessary, although desirable, to change the filter with every oil change.)

Replace the filter by dipping your finger into fresh oil and coating the rubber gasket then simply screw it on and tighten it 3/4 turn beyond hand-tight using the filter wrench. Replace the drain plug and pour in the amount and type of oil specified in your owner's manual. Run engine a few minutes and check for leaks at the filter.

Sep 05, 2010 | 2004 Dodge Ram 1500

1 Answer

Where is the transaxle oil filter or is the not one on this model?


The filter is located inside the transaxel - it's non-serviceable (meaning it's not replaced).

Jul 07, 2010 | 2004 Hyundai XG350

1 Answer

Change the oil on a 2000 Dodge Caravan


Jack up pass side.Put cardboard, BIG piece under engine just in case. Using a pan to drain the oil in put under oil pan drain plug. Remove drain plug with socket wrench. Let drain 5 min. Check the gasket on the drain plug, if bad replace with new gasket .99 cents to replace gasket only on plug. Put plug back in DO NOT OVER TIGHTEN the plug. Slide drain pan with drained oil to the front to remove oil filter. Using a filter wrench remove oil filter. Let drain. When installing new filter put a little new engine oil on the rubber gasket on the filter with your finger. Screw filter back on tighten with filter wrench. Fill van with oil from front valve cover opening.

Nov 21, 2009 | 2000 Dodge Caravan

1 Answer

I'm changing my oil on a ford 2001 escape where is the tank to drain the oil


directly underneith the engine, is called an oil pan, use 5w20 oil there should be a plug, dont misktake the transaxel plug as the oil pan plug though

Aug 20, 2009 | 2001 Ford Escape

1 Answer

Jaguar 2003 S Type Oil change. Where's the oil filter and drain plug and how's the best way to get to it?


you will need to remove the plastic undercarraige panel below the engine compartment to access filter & drain plug. I have the same model and change my oil about every 2k miles what I did to my first oil change was to cut access holes below the filter and drain plug to allow for fast/frequent oil changes. Not having to remove panel will save about 2 to 3 hours removing and reinstalling panel or will significantly save $ on oil changes jag dealer charges 100 a pop do it yourself for about 20$

Aug 03, 2009 | 2003 Jaguar S-Type

2 Answers

Car won't start after oil change jaguar S type


Sounds like overfill oil pressure too high. Oil level is critical. Engine can be damaged.
See my Solution for oil change.

Jul 10, 2009 | 2001 Jaguar S-Type

3 Answers

Change the transmission fluid on a 98 Diamante?


Look in the owners manual it should give you a time line or at about 60k

Jan 07, 2009 | 1998 Mitsubishi Diamante

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...