Question about 1999 Chevrolet Malibu
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
It is much easier, and cheaper to find a steering knuckle or "hub assembly" in a salvage yard.
To begin, jack up the car and remove the wheel. Be certain the car is stable and will not roll off jack(s)!
Remove the spindle nut. Remove the brake caliper (hang on a wire). Remove the bolt for lower ball join. Remove the bolt that goes thru strut. Now, pull assembly off while prying to ease pressure from the lower control arm.
Depending on how many miles you have on the car, you might want to head-off some future trouble by replacing the half-axle while you have the front end disassembled.
Posted on Jun 25, 2008
SOURCE: 1999 chevy malibu
That engine does not have a timing belt, it has a timing chain and therefore much easier to work with as it can only go on a certain way, the primary focus being getting the dots on the timing chain sprockets lined up properly.
I believe, with the engine at Top Dead Center on cylinder #1, the dots will be facing each other. That is to say, the do on the cam sprocket will be facing the dot on the crank sprocket.
Posted on Jan 02, 2009
bring the piston no 1 on the top position check the cam shaft si moving freelyon the outer side of the shaft there are 2 gear with 14mm bolts and 1 extra whole, put a long bolt in the empty space and try to turnthe engine the bolt will go further in the space than the timming is set put the chain on that should do
Posted on Feb 08, 2009
Everything worked as mentionned. Be carefull with the plastic in the winter. Make sure to use a flat screw driver and get it close to the slider and not on the edge. I cracked one of the tongues. Those L shaped slots are under the plastic cover with the two big plastic plugs that you also remove with the flat screw driver
Pierre Godin, Boissevain Manitoba.
Posted on Feb 10, 2009
Tips for a great answer:
Jan 23, 2011 | 2001 Pontiac Grand Am SE
Jun 01, 2010 | 1999 Chevrolet Malibu
May 24, 2010 | 1998 Chevrolet Malibu
Apr 16, 2010 | 2004 Chevrolet Malibu
Jan 01, 2009 | 1999 Chevrolet Malibu
Dec 08, 2008 | 1999 Chevrolet Malibu
200 people viewed this question
Usually answered in minutes!