Question about 2009 Chrysler Town and Country

1 Answer

The instrument panel all works, lights/chimes work too, but car will not start. I tried to jump it and will not do anything.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 444 Answers

Get a new battery for it,Battery is shot.

Posted on Nov 02, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 39 Answers

SOURCE: 2002: Engine turns over but does not start; instrument panel dead

you might have a bad instrument cluster, when you try to start the van next time, try to bang on the dash on top of the speedometer, hope this helps

Posted on Jul 24, 2009

  • 412 Answers

SOURCE: 2002 PT Cruiser CRD theft alarm light on

TRY REMOVING IOD(IGNITION OFF DRAW)FUSE FROM UNDERHOOD FUSE BLOCK FOR 30 SECONDS OR SO..IT SHOULD RESET IMMOBILIZER MODULE..IF THE SAME,REMOVE COVERS FROM AROUND STEERING COLUMN AND CHECK WRING NEAR IMMOBILIZER MODULE..FOR BREAKS,PINCHED WIRING,ETC...HAVE YOU TRIED ANOTHER KEY?YOU MAY A BAD TRANSPONDER IN KEY..;ET ME KNOW IF THIS HELPS

Posted on Jul 27, 2009

  • 109 Answers

SOURCE: Instrument panel lights

Did this happen after the batt was replaced, the BCM controlls the cluster illumination, radio, evic, might be issue there, there is a software update for this module 2001-2002, if not , only half of lights work, sounds like the rest are burnt out, R+R the cluster and replace the bulbs, get them from Dodge, GOOD LUCK, RDJRP

Posted on Aug 17, 2009

  • 1 Answer

SOURCE: instrument panel lights don't work

please advice, have you solved the problem? I have the same one on my Sebring. Many thanks.

Posted on Apr 06, 2010

  • 2926 Answers

SOURCE: I have a pt cruiser, the instrument panel has

The PCM is not a computer chip, it is the Powertrain Control module (engine computer). What needs to be done is a code reader needs to be connected to the diagnostic link of the vehicle, and checked for fault codes relating to this condition. I'm not sure how it was checked initially, but what I can tell you is if the PCM is found to be the issue, your not going to be able to repair it yourself. An expensive scan tool is needed to program the PCM when it is replaced, and is not available to the average person or technician. A Chrysler dealer will be the best option. It may also be related to the BCM (Body control module) since this problem seems to be related to the interior lights also.

Posted on Dec 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The door ajar chime goes off whenever it rains in my 2003 kia spectra, so i tried tape and it didnt work . How do i disconnect the chime under the dadhboard


re align door at hinges and catch
replace door seal or door sensor

chime soldered into instrument panel
and does other warnings

Jan 22, 2017 | Kia Cars & Trucks

1 Answer

How to Eliminate annoying Intermittent Warning Chimes from a 1994 Continental Instrument Cluster?


This is the simplest & easiest fix, to make your '94 Cont. drivable, without having to listen to incessant CHIMES beeping every five minutes, due to faulty sensors and electrical glitches from the junk message system. Go under the dash, on the right side of the steering column and remove the plug (10 wires) from the 'warning chime module.' There is a tan/yellow wire in that plug on pin #7--that is the "tone generator" wire. CUT IT.!!! Now, when all of those faulty inputs try to get to the warning chime module--they CAN'T! Problem solved--no more beeping. This does not disrupt the chime from sounding if you open the door with your keys in the ignition, or with the lights still on--it continues to protects you from THAT. Remember to watch your OWN coolant & oil levels--to make sure no REAL problems exist--and you're good to go!

Dec 29, 2014 | 1994 Lincoln Continental

2 Answers

97 buick century was running after jump started, when put in reverse it died and wont start when jump start, no chimes or lights come on at all


Dangerous practice to try & jump a near dead battery

Always try charging a battery, that is only a couple years
old & not run down more than two or three times

If the battery is dead & reads less than 12 volts, have a parts
store test it or just replace it.

Jumping a cars battery is not a fix for anything,so I fail to
see how your lost & have not addressed the battery issue,
so you can continue on with other testing,if needed

Sep 24, 2014 | 1997 Buick Century

1 Answer

No instrument gages work,0n 2002 dodge caravan se/3.8 engine. what is problem


Start with fuse inside of car. See if its blown. Anything hooked up recently, like radio, tried to use cigarette socket and now doesn't work. Or anything electrical.

Jan 29, 2013 | 2002 Dodge Grand Caravan

1 Answer

2000 chevy tahoe z71 (old style) with ignition off the buzzer started chiming with key out of ignition and headlight switch off. noticed daytime parking lights front and rear and license plate light still...


Park lamp relay contacts maybe stuck closed .
Body Wiring Harness Junction Block
Under the left side of the instrument panel near the left kick panel

Apr 24, 2017 | Cars & Trucks

2 Answers

2006 honda accord wont start. nothing happens when i turn it on, just a click. radio, lights and door chime work.vehicle will not jump start


First make sure the shift lever is properly in the park position. Hondas tend to have little problem in that area after a few years.
Second make sure battery terminals are clean and secure. Next you should try jumping the battery. A low battery may produce enough electricity to run the radio, lights, chimes etc but not enough to crank engine.

Apr 10, 2011 | 2006 Honda Accord

1 Answer

When trying to start the van, I had no panel lights. the radio works and the dome lights work. The door chime works and head lights work. but will not do anything else. Nothing lights up on speedometer...


Check under the hood and look at the fuses. The fuse box is located on the passenger side above the battery. If the fuses test good, reseat the fuses. I hope this helps.

Nov 01, 2010 | 1999 Oldsmobile Silhouette

2 Answers

Won't turn over - rapid clicks - panel lights flicker


Check the battery condition - it may be flat,
check battery terminal posts are clean and connection cables are not loose or corroded.

Aug 29, 2009 | 2001 Volkswagen Jetta TDI

1 Answer

2002: Engine turns over but does not start; instrument panel dead


you might have a bad instrument cluster, when you try to start the van next time, try to bang on the dash on top of the speedometer, hope this helps

Jun 13, 2009 | 1999 Chrysler Town & Country

1 Answer

Wont crank or do anything.


I have 1994 for escort 1.9 5speed doing the same thing. Will not start with the key but will start if you jump the starter

Apr 26, 2009 | 1998 Ford Windstar

Not finding what you are looking for?
2009 Chrysler Town and Country Logo

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...