- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Charlie, 1st thing is to check your fuses. I will post some links to help you see and solve problem. May not be your exact model but steps are basically the same.
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
CHECK BLOWER MOTOR FUSE AND RELAY.SEE IF POWER GOING TO BLOWER MOTOR YOU HAVE FAULTY BLOWER MOTOR.IF BLOWER MOTOR FUSE AND RELAY OKAY.IF NO POWER GOING TO BLOWER MOTOR BUT POWER AT AC AND HEATER CONTROL SWITCH. BLOWER MOTOR HAS POOR GROUND OR AC AND HEATER CONTROL SWITCH IS BAD.
If this occurs in all positions, check fuse, check for power at the fan motor, if power in all positions replace motor. if no power at fan and fuse is good, check blower motor resistor and blower motor control switch. Replace as required
The blower motor is located under the hood on the passengers side next to the hood hinge on the firewall. But, check your blower motor resistor first. The resistor is usually the trouble maker. It is located next to the blower motor. It should have 2 screws holding it onto the heater housing. Also an electrical connector. I sincerely hope that this will get it working again. Best wishes to ya.
that cliking you hear is most likely the heater relay. but i don't think thats it, i would be checking to see if there is a resister, for the blower motor, it should be someware around the blower motor along with the relay in the same place. it will be on the heater box held in with a couple of screws, and a plug going to it with 4 or 5 wires.when they go bad, blower may only work on one or two speeds or not at all.
If the blower is totaly not working it could be a bad motor or a loss of power (or ground) to the motor. There is a blower motor relay on the power distribution box on the right innner fender. There may be a fuse for the heater circuit, also. Power also goes through a blower motor resister that controls blower speeds. If any one of these are bad it will (can) cause the blower motor to not work. I would first check all your fuses. If you have the ability to check for power continuity (with a test light or multimeter) I would check to see if the motor is even getting power. It is also possible that your heater control switch is not sending power to the relay. Electrical can be hard to track sometimes. Good Luck.