Question about 2001 Alfa Romeo 147

1 Answer

Alfa 147 won't fire

Key turns, code ok, engine turns over, no firing occurs. Does anyone know how to access the fuel pump for this model?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Alfa Master
  • 75,822 Answers

The following are the general instructions on the start of diagnosing any electronically controlled engine or transmission problem.

The engine and the automatic transmission (transmission control is only for automatics, engine is still computer controlled no matter the transmission type) in this vehicle are computer controlled and in most cases when a fault occurs a fault code is stored in the memory of the computer control module. There are exception to this, such as the Mass Airflow Meter and fuel pressure problems. What must be done is to have all the basic testing done such as a scan of the system for fault codes as well as a check with a live data scanner tool for engine functions that are not within range of normal, a trained technician is required to know what is correct and what isn't, then based on careful diagnostics done from a factory repair manual the correct part is replaced or the wiring repaired or the computer replaced (known as the PCM or ECM,ECU), which is very rarely the problem. Other basic checks must be done as well such as mechanical problems with the engine as well as engine state of tune and mileage on the engine. The transmission can have mechanical issues as well such as no gear engagement at all or a failed pump or other pressure related problems. Also engine mechanical problems can and do cause many drive-ability related problem such as rough idle and other symptoms.

Posted on Nov 02, 2012

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

phil_hick883
  • 890 Answers

SOURCE: hi I have a 2008 Alfa Romeo 159 jtd I bought the car with no key I order a new key from overseas and when I got a key programmer out he tried to program but his scanner won't go into the system un

Ask local Alfa Romeo Dealership, the Service Manager will know the answer.

Posted on Jul 23, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 Nissan Pathfinder won't start, fuel pressure ok, spark plugs not firing


make sure you have fire at the coil if not there will be no fire to the plugs

Feb 08, 2013 | 2001 Nissan Pathfinder

1 Answer

Alfa Romeo 147 t-spark motor control system failure car just died in the middle of the road and won't start again.


Hello
The engine and transmission in this cars drive train are fully electronically controlled by a computer called the PCM (Power Train Control Module). Whenever a problem like this occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant teperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL THE DIAGNOSIS & TESTING IS COMPLETED.

Jul 11, 2012 | Cars & Trucks

1 Answer

Have a 2000 GMC Yukon Denali. Won't fire.


Make sure that the belt isn't extremely tight and they the belt tensioner isn't liked up by pulling in the belt. It should move and spring right back. Make sure engine isn't locked up. And please explain what happen with the vehicle. The fact that you replace plugs and wires and fuel filter for a car that's not turning is throwing me off. So right now we are going all over the place. But definite look at belt and tensioner I've seen a few times that a bad tensioner will make the belt wrap around tighter inhibiting the engine from turning.

Jun 26, 2012 | GMC Yukon Denali Cars & Trucks

1 Answer

94 caravan, fuel pump will not run and engine will not fire over. Help please!!!


I think the right direction will be a repair shop

Too many possibilities to guess, & we do a lot of that
as is.

Has to be diagnosed using wiring diagrams & other
reference material, you won't have access to.

Jun 20, 2012 | 1994 Dodge Caravan

1 Answer

I have 1986 Alfa Spider that won't start. Car has been sitting for a year. I replaced battery, fuel tank, fuel sender unit, both fuel pumps. I seems that the in tank pumps is not getting any po


Could be the main or fuel run relay located in the compartment under the luggage rack, passenger side, main relay also, fuse for the fuel relay 8amp. Electronic Control Unit is also located there.

Could be electrical, Hook up a timing light, three leads: Power, Ground, and one that goes around the wire to #1 cyl. Turn the engine over and see if there's firing. Note: u can check all 4 spark plugs this way.

Fuse lead goes to pin 30 of the fuel relay, u can jump 30 across to 57 and check for the pumps running, if not, change-I suggest both relays, main and fuel run relays. Both pumps get their 12v DC from the fuel run relay, both should be running when you switch ignition switch to on, then a tachymetric signal is fed from the coil to the relay to keep it running.

Jun 10, 2012 | 1986 Alfa Romeo Spider

1 Answer

94 gmc sierra 4.3 v6 manual, won't turn over, can hear fuel pump start when accessories turned on..won't fire, girl who needs help


The first thing I would check is fuel pressure. This type of fuel injection requires a minimum fuel pressure in order to operate. If fuel pressure is as little as one psi below minimum the vehicle will not start. You can try squirting a couple of shots of carb spray into the air snorkel while somebody cranks the engine over. If the engine starts and then dies you now you fpdeffinetely have a fuel issue. If the engine still won't start check for spark. Let me know what you find. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

Feb 07, 2012 | GMC Sierra Cars & Trucks

1 Answer

Turns over and won't start, replaced fuel filter and just turns over and almost fires


Almost fires? Do you mean it does fire some, that you know the plugs are getting spark? If so, then you probably need to have your fuel pressure tested to see if pump is working properly. Can you hear the pump buzz on briefly when you turn key to on? It should come on for a couple of seconds to pressurize the lines. If you don't hear it, then your pump may be bad, or something not turning pump on. Good luck.

Nov 09, 2011 | 1995 Buick Regal

1 Answer

GMC 2000 sierra pick up 1500 sounds like it wants to start but won't turn over. Battery sounds good so I guess battery and alternator are ok. For several years fuel gauge doesn't work and...


It sure could be. But, first...by "won't turn over" you do mean it cranks at normal speed but won't start?
A simple test of the fuel pump is to stand by tank and listen as someone turns key to on. When first turned to on, your pump will activate for 2 or 3 seconds, pressurizing the fuel system, and then shut off if the engine computer doesn't get a cranking signal. Do you hear it come on? If not, then something's not turning your pump on. If you can hear it buzz on briefly, then maybe it's your filter. Another test: Spray a little starting fluid into your intake manifold (remove the big hose going into intake manifold) while someone tries starting it.If it doesn't fire and try to stay running, then it's probably an ignition problem. But if it does fire off, then you know it's a fuel problem-likely your pump or filter. good luck.

Nov 07, 2011 | 2000 GMC Sierra

1 Answer

Stop on stop sign engine died


If the engine won't fire up, but your starter turns over, you may want to check your timing unless you have a check engine light on. If the CEL light is on, have the codes scanned.

If the engine won't turn over with the starter or it clicks, have your battery tested at autozone or advanced auto parts. Replace the battery if it is bad. Else, have your starter tested.

If the engine still won't turn over and the battery and starter are tested fine, you may have a blown fuse, bad ignition switch, or a failed relay.

If the engine fires up but randomly dies and starts back up, you either have a failed sensor, failing fuel pump, clogged fuel filter, bad plugs or wires, or a failing ECU.

Sep 06, 2011 | 1996 Nissan Quest

1 Answer

The dash gauges all work , fuel pumps are both good , the fuel pumps wont come on and the truck trys to fire when i turn the ignition on but wont , could this be a fuel regulator


did you check the fuel pressure pump on the frame rail for power and ground? have you verified no ignition spark to the spark plugs? have you checked for fire from the coil to the distributor cap? does the check engine light come on when you turn the key on? have you check for injector pulse and power at the fuel injectors? if the fuel pump won't come on and you have no ignition fire and no injector pulse, all of these systems are triggered by the ECM.

Aug 12, 2011 | 1990 Ford F150

Not finding what you are looking for?
2001 Alfa Romeo 147 Logo

346 people viewed this question

Ask a Question

Usually answered in minutes!

Top Alfa Experts

old marine
old marine

Level 3 Expert

1975 Answers

David Harrelson
David Harrelson

Level 3 Expert

5316 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Are you an Alfa Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...