Question about Nissan Cars & Trucks

1 Answer

No power to ignition

Has new battery lights and horn work but when key is turned in ignition nothing happens

Posted by on

  • gillian fisher Nov 04, 2012

    wasn't crank but found 1 blue fuse burn;t out and 1 brown fuse missing under bonnet at ttttthe back left hand side still no dashlights or ignition.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,101 Answers

Crank position sensor is bad

Posted on Nov 02, 2012


6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 76 Answers

SOURCE: 1988 Doge Ram will not turn over.

check your starter relay in the power distribution center. if you are not getting any crank. with a test light or dvom you can check the small signal wire on your starter solenoid when the key is in the crank position there should be power on this wire. it sounds like you are not getting signal to the starter from the ignition switch

Posted on Apr 16, 2009

  • 26 Answers

SOURCE: 1990 ford f-150 nothing happens when ignition is turned on

Solenoid was not mentioned as replaced.

If it was not part of new starter...that's the culprit.

Ignition switch (smaller wire) activates the solenoid (heavier wire) which in turn activates the (high current) starter.

Posted on Feb 28, 2009

  • 6 Answers

SOURCE: motor does not start when i turn on ignition

did u have the alternator tested to see output get a jump if the car starts takeit to a auto zone have him test the battery and alternator for free

Posted on May 03, 2009

roniecon
  • 6826 Answers

SOURCE: When I turn the ignition key in my '90 Cressida

Do the dash lights come on with key on?Try starting it in neutral.Turn key on,and foot on brake,and shift the gear shift into drive,and back into park,kind of hard,Now try to start it.Let me know right what happens,we will go from there.

Posted on Aug 29, 2009

co7196
  • 3433 Answers

SOURCE: car won't start. horn works, lights work but when

It appears the ground cable on the battery is not making good contact. Resmove and clean the connection. Good luck

Posted on Nov 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

When I turn the key, the lights go on, windows work, sunroof works... but when I turn it to the start position, nothing happened. If I jump it at the started with the key on, it runs OK.


Try another battery. Sometimes a battery might have enough amp to turn the lights on, open and close the windows, and even beep the horn. Sometimes it might even display that it have the right amp, but in reality the battery is damage giving you the wrong information.
Test with another battery, you could borrow one from a friend. Being there, done that.

May 14, 2017 | Cars & Trucks

1 Answer

2004 silverado died while going down the road at 55mph


i need more info. could be a bad ignition switch

Mar 02, 2013 | 2004 Chevrolet Silverado

1 Answer

Dash dead ,turn key nothing happens,no click,battery good,ignition switch is new,starter turns over when jumped with screwdriver,lights,horn,acc.work.


It there is a problem with the dash, there is probably no power to the anti theft module in your ignition. The car is in anti theft mode due to not being able to read your key transponder. Basically if it cant read the key, it thinks its being stolen. Either fix the dash lights, or fully bypass the security. All the security info you need is on here including how to bypass it.
http://vatspasslockpasskeysecurityhelp.yolasite.com/

May 03, 2011 | 2000 Chevrolet Cavalier

1 Answer

When you turn key nothing happens,lights,horn,radio works


check the battery conections for tightness then check continuaty to starter motor.. if power is getting to starter , could be starter. however if any of the dash lights go dim when turning key , suspect the battery.

Feb 02, 2011 | 1993 Jeep Grand Cherokee

1 Answer

1989 ford truck f350 diesel. head lights,hazard lights, and horn have power and work, batteries are charged but truck will not crank. when i put key in and turn the key over nothing happens....no buzzer,...


1989 f250 4x4 lighting problems. i replaced the floor mounted dimmer switch ,the lights worked fine for an hour untill i turned them off.Now the lights will not turn back on but i have park lights.

Aug 09, 2010 | 1989 Ford F 350

2 Answers

I turn the key and get all battery power to sterio and everything but when i turn the key to start it nothing happens the engine doesnt even try to turn over... would i need to just get a new starter or...


If you hear a click then nothing happens then 1- Either the battery is weak. Stereo doesn't need a lot of current. You can turn on the head light and horn at the same time so see if your battery could deliver all current needed to justify the battery. 2- Or your starter solenoid is bad, its poor contacts inside could not carry enough current to the starter to turn over. If you hear nothing, everything is quite then there is a problem with the safety switch at your transmission shifter. This switch is to recognize the Park position before enabling a circuitry to the solenoid starter.

Nov 22, 2009 | 1998 Volkswagen Jetta

3 Answers

I have a 1997 Grand Am 2.4 SE that won't start


Check battery full charge, battery terminals are clean, cables aren't cracked, broken or corroded and alternator first.

Which your having replaced your starter with new already. If you're still getting nothing it sounds like a bad ignition switch.

They wear normally and need to be replaced. But as a helpful hint don't place excess keys or weighty trinkets on your ignition keys.

They wear on the seating of the key in the ignition and often promote failure in the ignition from bearing the dangling weight.

Jul 27, 2009 | 1997 Pontiac Grand Am

1 Answer

Ignition key turns on but car will not start


I suspect the ignition switch is malfunctioning.

Nov 19, 2008 | 2000 Ford Focus

1 Answer

Engine does not start?


Make sure that the connections at the battery is clean and free of acid built up. Take the terminals of and clean them propperly

It could also be the ignition switch at the wiring end not making proper contact anymore, try and wiggle the ignition wiring if possible and see if there is any change in the status when the ignition is switch on

Oct 26, 2008 | 1988 Nissan Pulsar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...