Question about 2011 Ford Escape

Open Question

Rear coil spring replacement/ford escape

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: ford escape Rear Suspension With Coil Springs - out of joint?

It is a 4x4. The "yellow" looking item in between/inside the black spring coil seems to be out of its joint. When I compare the left vs the right, the left side is sitting up high, while the right side appears to be settled into place.

Posted on Nov 13, 2008

Ad
  • 39 Answers

SOURCE: I cannot find a diagram to show the pressure

Have you tried going to the dealership service dept. They should be able to help without charging anything granted you do the installation. If the spring has slipped out of position there is a good chance the spring and/or wiper assembly may be bent, damaged or stretched.

Posted on Apr 03, 2009

  • 258 Answers

SOURCE: No spark on2cylinders replaced coils get 1spark 2005ford escape

ohm test the wires or just replace let me know if u need more advisegood luck

Posted on Jan 07, 2010

SOURCE: Need to change the rear coil/spark plugs on Ford escape 2006. Need engine diagram to do it.

Need to remove upper intake manifold

You can see the coils on the front or left bank

I'm referring to a V6

1,2,3 right side of motor -next to firewall
4,5,6 left side of motor-next to radiator

If you have a v6 do the 3 coils while your there & intake is off
& save them for some time you need them on the left side


We have no diagrams

A code PO301 thru PO306 does not mean a coil is bad

Watch" Wayne"on Real Fixes Real Fast ---on You Tube

You get the plugs & coils from Rock Auto.Com unless
you like spending more at the parts store

Spark Plugs--every 3 years
O2 Sensors--front ones only--100,000 miles
Gas filter & Air Filter -3 years
Trans & Power Steering Fluids -3 years or failure isn't far away


Try to use th OE Brand Plugs on a ford
The tip configuration etc is important
Because it show ten plugs that fit they may
not work well


I would have the motor checked with professional
scan tool software in Mode #06 & look for cylinder
misfire on a road test of 20 miles,before I did any
of the work your going to do. That may show you some
failing coils. Codes are next to uselss
I have had to walk new coils form one cyl to the next
even when the scanner didn't pick up anything

Posted on Oct 04, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the name of the coil spring to purchse for Coil Spring for a Ford five hundred AWD


I would be taking this to a suspension specialist for good after market springs of the right length. The struts used may be too short in travel and that is what is holding the rear down or it may be just weak springs

Apr 25, 2014 | 2005 Ford Five Hundred

1 Answer

2004 Ford Escape 3.0 V6 - I had the spark plugs replaced when first experienced misfiring, and code said misfire on #4 cylinder. Right after replacement, things were fine. About a month later, starting...


If you had a scan tool you would be able to see the cylinder misfiring, i would try replacing the coil boots on the coil, there like replacing sparkplug wires but there small boots that pop on the end of coil with steel spring inside them, run truck and if misfire continues then you have a coil thats going bad,hope this helps. note if you could find out which cylinder it was you could swap coil with another cylinder and if skip move to that cylinder then you would know if its a coil this is after replacing boots.

Aug 25, 2010 | 2004 Ford Escape

1 Answer

How to replace front struts and coil springs 4 cyl. front wheel drive


first do you have a spring clamp. you need that to do the job . answered... there are some inexpensive one you can buy

Aug 01, 2010 | 2003 Ford Escape

1 Answer

My 2003 Escape has a history P0351 and P0301. This vehicle is also surging at times, at idle or around 40mph. I've changed the affected coil and intake gaskets. Spark Plugs recently replaced. Any...


I had the same problem and replaced the spark plugs, and also the tubes that run from the coils to the spark plugs. there is a spring inside the tubes that was brooken and that fixed the problem.

Aug 24, 2009 | 2003 Ford Escape

2 Answers

Ford escape Rear Suspension With Coil Springs - out of joint?


you didnt say if it was 4x4 but here is a pic
can you7 tell me what socket is out of joint?
cdf09f2.jpg

Nov 13, 2008 | 2003 Ford Escape

Not finding what you are looking for?
2011 Ford Escape Logo

Related Topics:

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...