Question about Cars & Trucks

Open Question

Blower Motor Resistor subaru - Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 479 Answers

SOURCE: blower motor resistor replacement

the relays are behind the glove box. you have to take the glove box out to have access to the relay for the heating system 

Posted on Dec 10, 2008

Ad
  • 2 Answers

SOURCE: how to replace a blower motor resistor in a 2004 jeep liberty

You have to take the glove box off and it is right behind it, need a #20 Torx to take it replace it. The glove box is the hardest part of the job, I just replaced mine on an 05 Grand Cherokee but it didn't fix it for me, was well worth the $8.60 to try though.

Posted on Apr 06, 2009

  • 118 Answers

SOURCE: How do i change the Blower motor resistor on a 2005 chevy impala?

The blower motor resistor is located behind the glovebox mounted in the fan housing box under the dash.

Posted on Jul 20, 2009

  • 2 Answers

SOURCE: location on a 323i bmw station wagon blower motor resistor

please help me with location of this blower resistor n 64116923204in the bmw 318 i tank you.tonitoneves@hotmail.com

Posted on Aug 30, 2009

  • 5 Answers

SOURCE: How do you replace blower motor resistor on a 2004

Here is how to change the resistor- but also pay attention-
Did you also change the connector at the same time?
If you are changing the resistor due to overheating and melting of plastic, then you need to do the connector also, or else it will repeat fail in a very short time.

Here is a step-by-step check you can do to fix it. If you are onlygetting high speed (setting 5), then most likely you have a resistorproblem, or the wiring connector to the resistor is bad. The groundwire prong being bad is a possible cause.

Check this for step-by-step checks:

http://www.sparkys-answers.com/2008/07/2005-chevrolet-silverado-blower-inop.html

Posted on Sep 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the blower fan relay located on a 2013 subaru crosstrek?


Not exactly sure if it has relay, but your fuse panel should be in the engine compartment and the blower motor Resistor, which controls the speeds of the motor, should be right by or screwed to the blower motor itself under the dash on the passenger side.

Oct 11, 2015 | Subaru Cars & Trucks

1 Answer

2004 Subaru Imrpeza Outback Sport - Where is the heater blower/motor located in this car?


Hey Tbird,here's a link to the blower motor,right by the blower motor is the blower motor resistor,you might want to check this first,if they go out then blower motor won't work,you can straight wire blower to see if works,if it doesn't then try resister,here's what it looks like.

Jan 07, 2013 | 2004 Subaru Impreza

1 Answer

I am looking for the blower motor relay in a 93 Subaru legacy. I have looked under the steering wheel until all of the blood in my body is in my head. I even got ont from the Subaru dealership to make sure...


Let's see if we can make life a little easier for you:
Remove the glove box. Disconnect the blower resistor electrical connector. Remove the screws and remove the resistor assembly from the blower motor housing. Reverse procedure to install.

Oct 25, 2011 | 1993 Subaru Legacy

1 Answer

Where is the heater blower resistor located in a 2000 Subaru Outback? I've seen one reply in a forum saying it is to the left of the blower motor, but I don't know where that is either. I need to...


the blower motor is located under the passenger side of the dash. The blower motor resistor is located behind the glove box assembly. You will need to remove the glove box assembly and then you will see the resistor. It will have one connector with four or five wires and will be held to the HVAC unit with 2 screws.

Jun 23, 2011 | 2000 Subaru Outback

1 Answer

Where is the heater blower resistor located?


The resistor pack wires are usually attached to the same wires as the blower motor. I strongly recommend replacing the blower motor at the same time if possible. It's the blower motor that is usually the reason for the resistor pack going out. So if you put just the resistor pack in, and shortly after, it goes out again then you'll know the blower motor needs to be replaced.
I hope this info helps!~subyguru~

Jun 23, 2011 | 2000 Subaru Outback

1 Answer

1991 subaru loyale ac fan does not work fuse is ok


is the blower motor not blowing or the fan on the radiator not working? didn't say exactly which it was. If it's the blower motor and the fuse is good, it could be one of 4 things. Broken wire, bad fan speed switch, bad resistor switch (controls fan speed) or bad blower motor. Check for power to the fan speed switch, if it's good move to the resistor switch( this switch is normally located near the blower motor and is bolted to the air box to keep it cool) Pull it out and check it. It could be burnt up. If so, replace it but before doing so check to see if your blower motor works by hooking it straight up to a power source. Most of the time on older vehicles the resistor goes out due to excessive dust build-up and finally burns the coils out or it just dies of old age.

Aug 16, 2009 | 1992 Subaru Loyale

1 Answer

Subaru Forrester blowers in front not working


Since you have checked fuses and relays that only leaves the blower motor resistor pack. Here is a diagram of how to replace it. I hope this corrects your concern...
Blower Resistor (Manual A/C Model)

REMOVAL

105915171

  1. Remove the glove box.
  2. Disconnect the blower resistor connector.
  3. Loosen the two screws to remove blower resistor.
INSTALLATION

Install in the reverse order of removal.




Jun 08, 2009 | 2004 Subaru Forester

1 Answer

Subaru a/c and heater fan doesn't work


You could have a blown fuse, bad relay, bad blower motor resistor pack, or just a bad blower motor. Start with checking your fuse to make sure you have power to you blower motor.

Apr 20, 2009 | 1995 Subaru Impreza

1 Answer

Blower for Heat/AC


blower motor resistor is in the front (right?) wheel well.

Oct 12, 2008 | 1987 Subaru Gl 4WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...