Question about Cars & Trucks

Open Question

How to install snapshot by Progressive on 2011 Nissan Sentra

I looked underneither the steering wheel and the connection piece doesnt fit. Where else would I install it?

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2000 Nissan Sentra

This is probably not an isolated problem, but a bad design, bad engineering and/or bad construction. There is an interlock between the ignition and the gear shift on automatics that needs adjusting at an exhorbitant cost. This should be a callback by the manufacturer.

Posted on Sep 02, 2008

Ad
  • 95 Answers

SOURCE: nissan sentra gxe 03 rear wheel hub bearing problem

Easy job ! just rem to get a gear puller for the antilock gear and install same as came off old one Parts around 100$ each apx 1/2 hr each side

Posted on Oct 15, 2008

  • 2 Answers

SOURCE: power steering reservoir for 2008 Nissan Sentra 2.0 S

I had this question initially. However, the Nissan Sentra (starting in 2007) has an electric Power Steering. It DOES NOT need any power steering fluid. The electric power steering is suppose to give you better fuel efficiency and lower maintenance cost.

Posted on Feb 28, 2009

USfalcon
  • 175 Answers

SOURCE: locked steering wheel

try to spray inside the key lock cylinder (the place where u put ur key ) by PB puster or WD40 then turn the steering wheel lift and right with try to turn the key to position on
i hope this will help

Posted on Mar 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On a 1997 nissan sentra do you have to remove steering wheel to install light&blinker switch I .


Once you remove the plastic shrouding around the steering column it will be clear in that case whether it will be possible to remove the old unit and fit a new one without steering wheel removal. As it is likely you will need to remove the steering wheel, make sure that you disconnect the battery before you do any work and remove the SRS airbag fuse(s) as well if you are messing with interior wiring in the vehicle.

Nov 25, 2015 | Nissan Cars & Trucks

1 Answer

Where do you plug in the snapshot in a 2011 nissan sentra


How to install snapshot by Progressive on 2011 Nissan Sentra

www.fixya.com/.../t14849289-install_snapshot_progressive_2011_nissa...
Nov 1, 2012 - I looked underneither the steering wheel and the connection piece ... This is probably not an isolated problem, but a bad design, bad engineering ...

Nov 01, 2015 | Nissan Cars & Trucks

1 Answer

I have a 2011 Nissan Sentra. It has developed a loud hum and vibration to the steering wheel from the front end .it has 180,000km. Any ideas?


How are the tires? New? Old? Rotate them and see if noise goes away. Possibly front wheel bearing in the front drive axle where it goes thru the hub and rotor.......goes the noise get worse if you turn right or left slightly when driving it? If it gets worse on one side that is the side with the bad bearing.....replace as needed.

Aug 31, 2014 | 2011 Nissan Sentra 2.0

1 Answer

Where do i plug in a progressive snapshot in a 2003 cadillac


Under the dash/ steering wheel there is a DTC port. It will look and be in the general location as in the photo.




10_16_2012_4_07_35_am.jpg

Oct 16, 2012 | 2003 Cadillac CTS

1 Answer

Where do i plug in the progressive snapshot on a 2002 hyundai accent?


most hyundais are a 16 pin conector located under the steering wheel somewhere (fuse box, under dash, behind panel right hand side of steering wheel) or in the centre under the handbrake or just behind park brake under a cover.

Oct 09, 2012 | 2002 Hyundai Accent

1 Answer

My 2011 Nissan Sentra makes a slight creaking noise whenever I back out of parking spaces by turning the steering wheel to the extreme right or left. Specifically, the noise comes after I start rolling...


is the creaking coming from the front or rear of the vehicle? if its in the front, it could be a bad strut. 2011? the vehicle should be under manuf. warranty. take it into the dealer and they should fix it for free and even put you in rental car if the vehicle has to stay for an extended period of time. make sure you are under 36,000 miles for the manuf. warranty to apply. good luck!

May 12, 2011 | 2008 Nissan Sentra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

188 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...