Question about Ford Cars & Trucks

Open Question

2007 ford explorer emission system warning light flashing?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 24 Answers

SOURCE: airbag light on instrument panel flashes then stays illuminated

Some vehicles you can disconnect the battery for 10-20 mins and it usually resets a check engine light. But the airbag light is different. This means there is something wrong with the airbag system and it will not go out until maintenance.

Posted on Mar 30, 2009

Ad
chuck943
  • 783 Answers

SOURCE: 2007 FORD EXPLORER SPORT TRAC 4X4 Change oil light on

Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.

The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
NEW OIL”.
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.

Posted on Apr 02, 2009

  • 218 Answers

SOURCE: code P0442-evaporated emissions control system leak.what does this mean,and how do i fix this problem on my 1998 ford explorer.

NUMEROUS THIS CAQN CAUSE THAT LEAK.U NEED TO FIL THE SYSTEM W/ A SKOKE MACHINE AND FIND THE LEAK WHERE SMOKE IS COMMING OUT.GOOD JOB FOR A SHOP

Posted on May 07, 2009

  • 30 Answers

SOURCE: 02 Ford Explorer XLT 4x4 High light flashes and

I had same problem on my 2002 explorer. Its either the computer module, or the electric solenoid on the transfer case. In my case it was both. The computer module I had done twice in 14 months.

Posted on Jul 04, 2009

  • 1 Answer

SOURCE: 2003 audi a4 1.8t ECU/emission control system warning light flash

No I am a mechanic at Audi. The problem is that the the air flow to the central tappets may be causing the air flow sensor to trip and that is why. Try putting a small amount of WD40 into the petrol and that will work, its a very common problem.

Posted on Nov 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have this DTC in my car ford Explorer 2007 C2777


This DTC is related to the ABS Brake System and is given the explanation: C2777 Sensor Cluster Bus Failure. There are some related Technical Service Bulletins issued for this DTC. I would recommend contacting your Ford dealer to see if your vehicle is covered under this TSB located here:
http://www.aboutautomobile.com/TSB/2007/Ford/Expedition/ABS+Warning+Light

Feb 12, 2016 | Ford Explorer Cars & Trucks

2 Answers

2004 ford explorer abs light constant and 4x4 blinking any ideas?


According to the manual pg 10. http://www.fordservicecontent.com/Ford_Content/catalog/owner_guides/04expog3e.pdf
Anti-lock brake system: If the ABS light stays illuminated or
continues to flash, a malfunction has been detected, have the system
serviced immediately. Normal braking is still functional unless the brake warning light also is illuminated.

Apr 16, 2014 | 2004 Ford Explorer XLT

1 Answer

2005 Ford Explorer TPS and Adavance Trac lights are on.


Yes, using a tire of a different size will likely set the lights. Not sure what your local emissions test requires, but I would not put a bunch of miles on the car with the spare.

Jul 15, 2017 | 2005 Ford Explorer XLT

1 Answer

Warning lights dash diagnosticmanuals


Try disconnecting the Battery for 10 minutes or take it to an Autozone, Oreilys, Advance autoparts for a free computer wipe.

Okay, now for the bad news. If the gas cap solution does not work, you have an opening in the Emissions system somewhere.

There is a machine and process called a "smoke test". The special machine hooks up to your gas cap opening and forces a type of tracer smoke into the system. The leak will let the smoke out.

You could have a hole in the gas tank, or Emission lines. Many times an Emission hose will get caught when the vehicle is put on a service lift. If your problem happened after the vehicle had new tires put on it, or any type or work requiring the car to be raised off the floor, the hoist could have nicked a low hanging line.

Sep 28, 2013 | 2008 Ford Explorer

1 Answer

Po453 e150 econoline


P0453 - Evaporative Emission Control System Pressure Sensor High Input
Possible causes- Evaporative Emission System (EVAP) Pressure sensor harness is open or shorted
- Evaporative Emission System (EVAP) Pressure sensor circuit poor electrical connection
- Faulty Evaporative Emission System (EVAP) Pressure sensor
- Damaged fuel tank pressure sensor

Sep 05, 2012 | 2007 Ford Explorer Eddie Bauer

2 Answers

2007 Ford Explorer Eddie Bauer edition - when turn key on message flashes across top center of dash "passenger airbag off". How do I turn it ON?


most of these new day pass air bags are in the off possition untill weight is applied to pass seat. Sit in pass seat and start vehicle and see if this activates the air bag on.

Jan 12, 2011 | 2007 Ford Ranger FX4 Off-Road

1 Answer

Ford explorer limited '07 check engine light problem


that seems to be the tire pressure monitoring system warning light.

May 15, 2010 | 2007 Ford Explorer Eddie Bauer

1 Answer

Airbag light on instrument panel flashes then stays illuminated


Some vehicles you can disconnect the battery for 10-20 mins and it usually resets a check engine light. But the airbag light is different. This means there is something wrong with the airbag system and it will not go out until maintenance.

Mar 29, 2009 | 1999 Ford Explorer

1 Answer

96 FORD EXPLORER XLT 4X4 LIGHT FLASHING


Does the 4x4 "actually" work because this is a signal that the system has a problem. Its like a check engine light that comes on or flashes when there is a problem with the engine or emission system.

Jan 01, 2009 | 1996 Ford Explorer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

112 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...