Question about Buick Cars & Trucks
The low beams do not light up now just have high beams. recently replaced th low beam lights so they are good. checked all fuses. do i need to remove steering wheel to get to dimmer switch.
The dimmer switch relay for a 2000 Buick Century is Located under dash right side of the fuse box.
Posted on May 10, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: no high-beam headlights
It may not be the switch; most hi-lo changes are via relay to prevent the higher currents from flowing through light-duty switches.
Locate the relay cluster (it might be near or with the fuses) and if they aren't marked, pull wach one of them and plug back in several times to wipe possible corrosion from the blade contacts.
If they are marked, look to see if the same relay is used elsewhere (part number should be visible) and swap them temporarily to see if the relay is at fault.
Some vehicles will use separate relays for hi-lo beams and another for flashing since that often turns on both beams momentarily.
Posted on Aug 26, 2008
This will involve removal of your steering wheel and a couple of special tools, a steering wheel puller and a steering wheel lock ring compressor. If you have these are can rig your on, remove ground and wait ten minutes so the airbag system capacitor has time to discharge. Remove drivers air bag and detach wiring, remove steering wheel nut and notice align marks on wheel and steering wheel shaft and remember them. Remove the steering lockring retainer after compressing spring. from there you should remove Blinker stick, by turning shaft to line up to slot on hole and pull out, Remove clock spring and then switch, reverse to install. Hope this helps you some you can get complete instructions at www.alldatadiy.com, Hope this helps you and Merry Christmas!
Posted on Dec 23, 2008
On the 03 Accent, there is only one relay which supplies power to both circuits. The 'distribution' of power is controled by the multi-function switch (turn signal switch).
As you can see in this wiring schematic/diagram.
Posted on Sep 07, 2009
Tips for a great answer:
Oct 28, 2015 | Buick Cars & Trucks
Aug 16, 2014 | 2000 Buick Century
Jul 01, 2013 | Cars & Trucks
Jan 31, 2013 | 2001 Hyundai XG300
Aug 04, 2012 | Buick Rendezvous Cars & Trucks
Feb 04, 2011 | 1999 Buick Century
Jun 21, 2010 | 2001 Buick Century
Apr 28, 2009 | 2001 Buick Century
Mar 02, 2009 | 2001 Buick Century
233 people viewed this question
Usually answered in minutes!