Question about Cars & Trucks

1 Answer

What would cause the engine not to run higher than 2000 rpm

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 271 Answers

If the engine seems to be running normal it could be a problem with the gauge itself. Consult a mechanic and drive safe! Auto diagnostic tools for cars @http://www.obd2express.co.uk

Posted on Nov 02, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 10 Answers

SOURCE: Engine sounds like its working hard

if it does it then stops then sounds like your fan clutch working and is normal

Posted on Aug 17, 2008

  • 63 Answers

SOURCE: 1994 Buick LeSabre engine dies when cold at 2000 rpm

have your temp sensor checked and does any of your warning lights come on?

Posted on Mar 23, 2009

  • 72 Answers

SOURCE: 2000 Ford Focus Sputtering / Speedometer Needle Jumping

It could be a spark plug, plug wire, or a coil. Sometimes thay break down intermittently. If it needs a tuneup, that would be the first thing to do.

Posted on Jun 20, 2009

lemmingleejn
  • 173 Answers

SOURCE: knocking in the engine

Has the car recently been serviced?
Check your oil level, or anything different under the hood, ie, new oil stains, or signs of leakage.
This could possibly be the hydraulic tappits, that are in need of adjustment.
You'll need to hand over some green, to a descent mechanic tho.
But look for the obvious signs.
Hope that fixe'd'ya!


Posted on Jul 23, 2009

Gort007
  • 1187 Answers

SOURCE: 2000 Ford Explorer A/T downshifts unexectedly

The vacuum modulator on the side of the transmission has a leak (rubber diaphragm inside has ruputred. ($15 AutoZone).
Or other major vacuum leak (hose to the modulator may had come off or brittle, or clogged, or broken.

The downshifting is now being done by the "mechanical backup" to the vacuum system

Hope this helps!

Posted on Sep 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 2000 4 cylinder wrangler tj idles above 2000 rpm after it warms up. Engine light is on. What could be causing it?


There is an idle control air valve in the fuel injection that will cause that issue... precisely.

Better to read the OBD (ON BOARD DIAGNOSTIC) outputs
rather that to speculate...

factory+workshop+manual... troubleshoot BBB Industries Premium Alternators Starters Power Steering Products

Apr 18, 2016 | Cars & Trucks

1 Answer

2000 ford windstar stalls at 2000 rpm some times dies i no its not the dpfe


Good Evening, I have had a few of these on the car lot and noticed a few inherited problems that can cause what you are talking about. First thing is a coil going bad, second is those darn plenum and intake gaskets which cause a vacuum leak which causes the engine to develop a miss not only at low rpm but also at higher. I cannot say that it is your problem without coding it, but give you some insight into possibilities. Hope this helps.

Nov 02, 2010 | 2000 Ford Windstar

1 Answer

Why are the lifters of my pajero io noisy


those engines are known for lifters draining in order to restore them you must run the engine rpm about 2000 rpm for 5 minutes .they shoudld quiet down mitsubishi says to run them at 4000 rpm for 10 min,but i rebuild *** engines for 20+ years i dont recomend this with out causing damage to eng just hold the rpm to 2000 until the get quiet make sure you have fresh oil and the engine as good oil press

Aug 28, 2010 | 2000 Mitsubishi Eclipse

1 Answer

What would cause my 2003 ford escape to idle around 2000 to 3000 rpm after it has been running for a while. it runs fine when it is first started up.


If your A/C is on , or you are running the climate control in the defrost windshield mode , the engine will idol higher than normal.
A Vacuum leak could also cause a high idol.. check the vacuum lines and be sure they are in good condition and all plugged in.

Jul 15, 2010 | 2003 Ford Escape

1 Answer

My 2003 suburban seems to run at a higher rpm.


Hummm, 2000 rpm does not seem high, really. But another item to look at is your FAN. The clutch fan fails and drives the fan full engauge. Sounds like a jeep...massive sounding, relating to engine RPM, but not necessarily different.

I mentiont his because a trans does not typically fail and give a few hundred RPM. Usually a slipping sensation is described....

Jul 12, 2010 | 2003 Chevrolet Suburban 1500

1 Answer

2.2L 2000 s10, AC blows hard at idle but when rpms go up air blowing out goes down., not sure why


Two ideas--either the alternator loses efficiency at speed causing voltage loss (may be bad brushes) or the engine is losing vacuum at higher RPM's causing an air flow control valve to change position.

Oct 12, 2009 | 2000 Chevrolet S-10

1 Answer

2000 Ford Focus Sputtering / Speedometer Needle Jump


Only 1000-2000 RPM? Does it do that in any gear?

Jun 20, 2009 | 2000 Ford Focus

1 Answer

1994 Buick LeSabre engine dies when cold at 2000 rpm


have your temp sensor checked and does any of your warning lights come on?

Mar 23, 2009 | 2000 Buick LeSabre

1 Answer

Engine miss above 2000 rpm


sounds like a valve problem. check compression running and non-running. valve sealing at higher rpm is usually a valve spring problem is if runs ok at idle.

Oct 22, 2008 | 1990 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...