Question about Toyota HiAce

1 Answer

Hi, At least once a day when I'm driving I hear a loud banging noise (clunk). It only happens once, but when it happens you feel it under the passenger side. The noise only happens when I'm dr

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had a noise like that once in a full size van it turned out to be the ball joints onthe passenger side might want to get them checked it could have been fatal for us

Posted on Nov 02, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 59 Answers

SOURCE: Acura Integra '92 loud clunking when accelerating

you can check the wheels make sure there on tight and make sure you tie rods and wheel bearings are good

Posted on Dec 30, 2008

  • 66 Answers

SOURCE: Strange raddling noise from front passenger side

if the noise only happens when the vehicle is in motion...check the front suspension. place the jack under lower control arm ,then get a bar and lift up on the tire..ball joint issues are well known in blazers and cause this condition. if it does the rattle noise when its idling and to op temp--could be the cat converter causing the noise on pass side directly under passenger seat. when cold, smack the cat with rubber mallet and if any rattle is present, cat should be replaced so it dont cause further damage .hope that was helpful !!

Posted on Jul 07, 2009

SOURCE: Hi, peugeot 206 clutch/engine problem..

It seems like the clutch pressure plate has given in. Best would be to replace the clutch pro-kit.( Clutch pressure plate, clutch plate and release bearing)

Posted on Sep 03, 2009

Testimonial: "A mechanic said basically the same to me today, so I'll be getting it replaced. Nice one knight :)"

  • 1986 Answers

SOURCE: Passenger window makes loud noise when rolled down

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Pull back the weather seal and you should be able to see what the window is catching on.
I've seen cases where the lock cylinder comes loose and hits the window

Posted on Oct 07, 2009

seanpwright
  • 2030 Answers

SOURCE: hi i just put petrol in my subaru impreza 97 sport

Sounds like your timing belt went bad.....HAVE IT CHECKED NOW>>>AND DO NOT DRIVE IT ANYMORE AS YOU MAY CAUSE FURTHER DAMAGE TO YOUR ENGINE.

Posted on Dec 12, 2009

Testimonial: "thanks 4 the advice,i thought it could have been the belt."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi i have a 88 toyota hilux and it is mayking a loud clunking noise from near the rear diff and you can also feel it it happens all the time even at low speed but it seems to stop under slight power but as...


Sounds like a drive shaft knuckle barring or something around that. I had a ranger that made a noise like that turned out that I needed to repack the barrings. Hope this helps

May 19, 2014 | 1986 Toyota Pickup 4WD

1 Answer

On my 1998 ford contour my windshield wipers wont work and a loud banging noise is happening even when they are off


It sounds as if the wiper linkage has come adrift, normally will require renewal of a link arm

Oct 20, 2012 | 1998 Ford Contour

1 Answer

My ZJ hopps and rear end clunks and skips when flooring it


Hi Simon, Check the suspension mounts and those for the diff. Also have a look at the UJ's on the propeller shaft. I believe you'll find the problem will be there. Regards John

Apr 28, 2012 | Jeep Grand Cherokee Cars & Trucks

2 Answers

Everytime i turn the steering wheel i hear a loud clunking noise, i know its not the strut mounts, i know both tie rod ends are brand new within the past year plus they dont make a clunking noise like...


clunking noise may be bad steering rack. either the bolts that hold it to the frame may have worked loose,the center of your vehicle is where the steering racks located,just under the center of floorboard.under dash but on floorboard.make sense? try turning the steering wheel with engine running,place your hand under the radio,but on floorboard,when you turn the steering wheel from side to side,do you feel a thump? if so,then your steering racks loose or bad. the only way to know for sure is to have someone who knows about the steering rack to inspect it visually. thank you for choosing fixya.com

Apr 03, 2011 | 1997 Pontiac Sunfire

1 Answer

"I hear and feel "Clucking noises when I drive me


If it is clucking then someone has hidden some chickens in your trunk, open it and let them out. If it is clunking then I would suspect rubber bushings on any of the several suspension components have reached the end of their life and metal is banging into metal as the suspension moves up and down.
You need to take it to an alignment shop and have them give you a list of what is worn out. Consider replacing those parts and getting it aligned. If the clunking is reserved only to times when you shift from D to R and back, then I would suspect U joints and CV joints in the axles. If it is reserved to times when you are turning, check the CV joints and wheel bearings. Everything on the car is 14 years old and each part will eventually fail from use and age.

Feb 03, 2011 | 1997 Ford Taurus

1 Answer

Very LOUD banging noise from front left wheel


the right outer tierodending needs replaced.

Apr 03, 2010 | 2001 Chevrolet Impala

1 Answer

When coming to a full stop in my tahoe i hear a banging from tran


The trans have issues. If it is a 4 speed automatic. I have seen dozens over the years with failing gear sets making clunks and noises.

Take it in soon.

Apr 06, 2009 | 2007 Chevrolet Tahoe

1 Answer

Acura Integra '92 loud clunking when accelerating


you can check the wheels make sure there on tight and make sure you tie rods and wheel bearings are good

Dec 30, 2008 | 1992 Acura Integra Hatchback

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

303 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...