Question about Cars & Trucks

1 Answer

I have a 2001 Chrysler voyager . Ihave a replaced pcm that was pre programmed. The car not starting now. It just will not turn over. The code p601 is no longer on. I see the code p1864. And flash then done. What does this mean and what's a solution? Thank you!

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 271 Answers

The code p1864 means Data Bus Powertrain Missing message from ADR control module. You can use the car diagnostic tool to help you find out the problem.

Posted on Nov 02, 2012

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3640 Answers

SOURCE: chrysler voyager 2001 error code p1281

this code is--manufacturer control fuel air metering

Posted on Nov 12, 2009

roniecon
  • 6927 Answers

SOURCE: ihave 02 grand caravan sport 3.3 code p0204 i

Check the coil itself,or replace it.The e c m sends power to the coil,12 volts,but it also breaks the ground side of the coil to load it,to fire on time.

Posted on Jan 25, 2010

  • 20 Answers

SOURCE: 97 plymouth voyager. no spark to cylinders

It sounds like you're on the right track with the crank sensor.Does the car have injector pulse? A bad crank sensor will also cause no pulse.

Posted on Mar 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Trouble codes 1391,0622


Sounds like you have 2 different issues. the p01391 is and intermittent loss of cam or crank sensor without a scope guess work is your only hope. Start by replacing cam sensor. easiest and cheapest. Then crank sensor if cam sensor doesn't fix it. If neither one of those fix it your looking at some very expensive repairs (pcm,wiring or flex plate)
The p0622 is a charging system problem possible causes are pcm,alternator or wiring.

Apr 03, 2013 | 2001 Chrysler Voyager

1 Answer

2001 Chrysler Voyager will not start


does it crank. if so then the starter is good. when you turn the key but not start it do you hear the fuel pump running. do you know if you have spark to the spark plugs. is there any codes

Nov 23, 2012 | 2001 Chrysler Voyager

1 Answer

What does P1684 mean


Here's a link to the code.Trouble Code: P1684

Battery Has Been Disconnected

Possible Causes:


Quick Learn procedure was performed with scan tool.TCM battery direct (B+) circuit is open or disconnected..TCM power ground circuit is open.PCM/TCM was disconnected or it has been replaced.

Oct 28, 2012 | 2001 Chrysler Voyager

1 Answer

Code p0601 on 2001 grand caravan


A doozy! And common to Chrysler Dodge products. The code means the computer detected an internal fault in the PCM. There have been many reported failures of the Program Control Module in Chrysler products.
However, if you took off the connector to the PCM while battery was connected, you may have set the code yourself.
It's pretty much a dealer fix: In most cases, the fix is to replace and reprogram the PCM. In a few instances, the dealer may be able to reflash the PCM and get it working again, but usually it needs replacing and reprogramming. It's probably not, but ask if it's still under emissions warranty.
If you use an independent shop to replace the PCM, make sure they can also program it. Good luck.

Nov 25, 2011 | 2001 Dodge Caravan

1 Answer

I got a P0601 DTC on my 2001 Chrysler Voyager 2.4. I replaced the PCM and immediately got a P0172 with a rough idle. I replaced the O2 sensors but still have the same problem with same DTCs.


OK. Let's see here...with the code P0601 you had no choice but to replace the PCM. Now here is the kicker...Was it properly programmed before you started the engine up? I just have to ask because I have seen things like this happen with PCM replacements when the PCM did not get programmed properly or when people switch out used PCM's from other vehicles that are not programmed with the correct software for the vehicle it is going into.

Now, with all that said:
P0172-1/1 FUEL SYSTEM RICH
The O2 sensors are RARELY - IF EVER the cause of this code. It does not surprise me that replacing the O2 sensors did not fix it.

Either the O2 sensor signal circuit is shorted to voltage, or you have something wrong with your engine that is causing the engine to run extremely rich. Any way you look at it, your O2 sensor signal voltage is way too high. This is why O2 sensor failures do not usually cause this code. When O2 sensors fail, they do not produce voltage like they should and you will get LEAN codes, not RICH codes.

Anyway, this code is more likely to be caused by a bad engine coolant temperature sensor (ECT), a bad manifold absolute pressure sensor (MAP), a leaking fuel pressure regulator diaphragm, leaking injectors, etc. or something could be shorting out the reference voltage to the MAP sensor and the Throttle Position Sensor.

Please also review this article:

What Else Could Be Wrong?

Sep 20, 2011 | Chrysler Voyager Cars & Trucks

1 Answer

I have a GMC Envoy that is giving me p601 code which I know is a PCM memory problem?? can this computer be fashed to get rid of this problem or do I need to replace the PCM ??


You will have to replace the PCM and it will have to be reprogrammed or your vehicle will not start.You will need to take your vehicle into the dealer and they will replace the PCM and program it in the vehicle.Hope this helps.Good luck.

Sep 14, 2010 | 2004 GMC Envoy

1 Answer

No start chrysler voyager


so you have no drivers for the injectors.... every thing is connected, no shorts..... the main thing that comes to mind is the computer....

Feb 22, 2010 | 2001 Chrysler Voyager

1 Answer

Engine management light code p601 What sensor is it ?


that code is with computer problem PCM need be reprogramed or bad PCM

Jan 20, 2010 | 2006 Chrysler Neon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14398 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...