Question about 1984 Toyota Corolla

1 Answer

Are removing the rear seats good?

I have a 1984 sr5 corolla,trueno in japan, and if u know this car u know that it is godly light and removing the rear seats make it lighter. well i removed them some time ago and i was wondering is there any possible problems with this?such as handling etc.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

There shouldn't be a problem. most people here take out their seats for track/race purposes. when drifting you want to focus on lightness and suspension/brakes. check out and look at the tech referances and the forums. have fun, wish i had your car, mines the sr5 american model! :(

Posted on Jan 05, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to remove quarter windows on 1984 cadillac eldorodo convertable.

Remove plastic panel . Rear seats might have to be removed first. There are bolts and/ or rivets holding everything in place. There might also be a YouTube video on the subject. Good luck.

Jul 01, 2016 | 1984 Chevrolet S-10

2 Answers

What car is the best for drifting

Hi there:My opinnion, for beginners, the Trueno is prolly easiest to learn in; is light weight, solid rear axle, reasonably simple and reliable.
Check in THIS LINK other details and opinnions.
Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.
Thank you for using FixYa, have a nice day.

Jun 27, 2012 | Cars & Trucks

1 Answer

How replace rear wheel stud on '90 corolla drum brakes

Remove the drum,turn where it has nothing blocking to come out.Don't hit stud directly with hammer,you will cause the end to get bigger and it will damaged the hole,if you have punch that is small in diameter than stud,use that with hammer,turn drum again so next stud it is free to come out.

Jul 29, 2017 | Cars & Trucks

4 Answers

I locked my keys in the trunk of my 2000 toyota corolla ce,

Yes, or you may have to remove the rear seats to gain access to the trunk area.Roll your windows down or leave the doors open to ensure there is sufficient air flow inside of the car. You do not want to run out of oxygen.

Jul 29, 2009 | 2000 Toyota Corolla

2 Answers

Torque for head bolts for 1984 Toyota Corolla

head bolt toque specs are 40-47 ft-lbs

Mar 22, 2009 | 1984 Toyota Corolla

1 Answer

1984 Toyota Corolla Timing Problem

Do to federal regulations,emissions have to be keep at minimum.Modern cars have a computer that's sets the firing timing to control this. If your rpms are ok, then don't pay attention to it.

Feb 16, 2009 | 1984 Toyota Corolla

1 Answer

Intake manifold gasket needs replaced

it is a pretty basic job the important things to remember is to remove everything sequentially. in other words make a note of which bolts go where. remove the intake and clean both mating surfaces, usually you dont need gasket sealant for an intake manifold. reassemble in the order removed thats about it.

Jan 13, 2009 | 1984 Toyota Corolla

1 Answer

Replace rear seat belt in 1993 Toyota Corolla

OK. On the front edge of the seat bottom cushion, pull up hard, both sides. This will dislodge the 2 clamps that holds the seat cushion to the floor. Pull the seat cushion out & set it aside. You will now see the female latches bolted to the area where the rear of the seat cushion meets the rear seat back bottom. Remove the bolts (14 mm I think).

Oct 07, 2008 | 1993 Toyota Corolla

1 Answer

95 Corolla parking light

Remove the retention screw above the headlamp, and pull it straight out towards the front of the car. Note that it may be slightly difficult to pull, you have to defeat a retention tab that holds the rear of the lamp assembly.

Oct 04, 2008 | 1984 Toyota Corolla

1 Answer

Center rear seat belt not retracting

in short;
remove rear door weather strips
remove upper c-pillar trim
remove rear deck lid cover retainer screws
remove rear deck lid trim cover
and your seat belt assembly will be right there

Jun 18, 2008 | 1998 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

178 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides