Question about Mercury Cars & Trucks

Open Question

P1701, p1704 stalls at warm temperature at idle, check engine codes p1701/p1704

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

wyatt1582
  • 453 Answers

SOURCE: 1998 FORD CONTOUR CHECK ENGINE

sounds like EGR valve and sensor this controls idle speed when at a stop. the po171 is a burn lean or rich code need to know what bank 1 or 2. also check for a vacuum leak from one of the hoses.

Posted on Aug 07, 2010

  • 34 Answers

SOURCE: ENGINE STALLS DURING COLD STARTS.

Sounds like an IAC motor, If you look near the trottle body there is a long cylinder with two bolts holding it on, the only other suspect would be a vacuum leak. -Jared

Posted on Nov 14, 2008

chuck943
  • 783 Answers

SOURCE: 2000 Ford Explorerer rough idle When cold

what codes are present? If it is lean codes P0171/P0174 problem is most likely the orings leaking between upper and lower intake manifold if this is a 4.0L

Posted on Feb 11, 2009

  • 218 Answers

SOURCE: 2001 toyota echo engine light is on. Car idle is rough and sometimes stalls. Is there a way to clean the idle air control valve without removing it?

NO U HAVE TO REMOVE THE IAC TO CLEAN.DO U KNOW WHET CODE THE LIGHT IS SETTING?

Posted on May 05, 2009

  • 98 Answers

SOURCE: 06 f-150 5.4L low idle code and warm ac at idle.

should idle around 700

Posted on Jun 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1989 pontiac grand prix keeps stalling once it is warmed up after about 15 minutes of idle.


No, not the oxygen sensor. A couple of things you need to make clear. What light flickers, then stays on? That can't be a sensor light, it would have to be the "check engine light" or an engine temperature light (for like when your cluster has no temperature gauge, but just the "red light").
At any rate, the sensor you changed is not the engine temp. sending unit for the instrument panel. I believe on your '89 there would be two sensors for temp. One is the CTS for the engine computer, and the other is a sending unit for the dash, probably a 1 wire connector. It could be at fault, but it wouldn't cause stalling, I do not think anyway.
If it stalls and won't restart until cooled, this is a symptom of loss of ignition (spark) caused by either a faulty coil, or faulty Ignition Control Module (the coil controller), or last a faulty Crank Position Sensor (this sensor used by computer to determine ignition spark timing). You could test if ignition is lost, by checking for spark right after the engine warms and then stalls. If you have no spark to a spark plug right after it stalls, this is the reason for stalling. Usually it is the crank sensor, rather than the ignition control module or an ignition coil. Your car has 3 coils anyway in a "coil pack", so if one coil went bad, you'd still have two good coils, but engine would only be firing on four of the six cylinders-could easily stall a car.
You should check for trouble codes whenever you have a problem. A code might have been set. Easy to check for codes on your car, just ask if you don't know how-only takes a jumper wire or even a paper clip works. good luck.

Jun 16, 2016 | 1989 Pontiac Grand Prix

1 Answer

Chevrolet Caviler 2.4 - 2000 Stalls at idle (stopped) once car is fully heated up.


Check coolant temp sensor. These fail often and cause all kinds of mystery problems. This unit acts much like a choke on old carb engines and can fail in different ways. Most common (I think) they fail such that the ECU thinks the engine is cold when it has begun to warm and thus the ECU delivers too long a pulse to the injectors so that the engine runs way too rich. I think it is also possible for the sensor to fail at any point between cold and warm such that the fuel mix is wrong except for the particular temp at which the sensor is stuck. Also O2 sensor has some fuel "trim" input.

Feb 26, 2015 | 2000 Chevrolet Cavalier

1 Answer

Camshaft sensor problems


If the sensor detects a problem, it sends a trouble code to the ECM and your "check engine" light will come on. IMO, your symptom sounds like "cold engine" issue. Myself, our 98 Toyota Rav4 will idle rough and engine stalls when put in drive, but the problem goes away when temperature shows the engine had warmed up to operating temperature. FYI the temperature sensor monitors the radiator coolant temperature. Normal engine temperature is when coolant reaches 120 degree fahrenheit. At around 130 to 140 degrees fahrenheit, the coolant thermostat opens to let radiator coolant flow from "bypass" mode to "enter radiator" mode. If it takes longer than 10 minutes for your engine to warm up, its possible the coolant thermostat is stuck in open "enter radiator" mode. When thermostat is close, coolant radiator bypass the radiator to speed up engine warm up, but if its stuck in open, it will take longer to warm up the engine. Another factor is ambient temperature. If its cold below 50 fahrenheit, it will take longer to warm up the engine.
d034c766-1274-4037-bb71-825db11c8d9f.gif
a7fc16ff-36c8-4b62-baf3-0205417dc688.gif

Nov 29, 2013 | Cars & Trucks

2 Answers

Rough idle and stalling


it will have codes but the scanner in use doesn't have the right protocol for reading them
Indicates a faulty ambient air temp or BARO sensor so there will be codes

Aug 01, 2017 | 2008 Acura Rdx

1 Answer

1994 Mercedes c280 check engine light is on.code reads p1701 what does it mean ?


P1701 refers to a automatic transmission shift solenoid failure

Oct 08, 2010 | 1994 Mercedes-Benz C-Class

1 Answer

Error code po0117. Vw beetle


16501/P0117 - Engine Coolant Temperature Sensor (G62): Signal too Low Possible Symptoms
  • Difficulties with starting a cold engine.
  • Starting the engine when engine is warmish or warm, idle rpm immediately is 1200 - 3000 rpm.
  • RPM at idle is irregular.
  • With all engine temperatures seldom idle rpm will vary between 900 - 1000 rpm.
  • With engine warm (90 °C) the engine temperature suddenly drops (70 °C) and slowly comes back to 90 °C.
  • Bad acceleration during warming up.
    • Diesel: an indication is extreme long time burning time of the glow indication light.
Possible Causes
  • The electrical signal coming from G62 is too low
  • Wiring and/or connections faulty (short circuit?)
  • Engine Coolant Temperature Sensor (G62) faulty
Possible Solutions
  • Check wiring and connections
  • Check / Replace Engine Coolant Temperature Sensor (G62)
Special Notes
  • In MY 1995-2002 (?) in Europe at VW-cars the G2/G62 had the bad reputation of breaking down often. The default G2/G62 is black and all replacements are green.

Mar 21, 2010 | 1999 Volkswagen Beetle

1 Answer

The check engine light on a 2001 beetle read code PO118 engine coolant temperature circuit high input. what do i do?


16502/P0118/000280 From Ross-Tech Wiki Jump to: navigation, search Contents [hide] if (window.showTocToggle) { var tocShowText = "show"; var tocHideText = "hide"; showTocToggle(); } 16502/P0118/000280 - Engine Coolant Temperature Sensor (G62): Signal too High Possible Symptoms
  • Difficulties with starting a cold engine.
  • Starting the engine when engine is warmish or warm, idle rpm immediately is 1200 - 3000 rpm.
  • RPM at idle is irregular.
  • With all engine temperatures idle rpm will often vary between 900 - 1000 rpm.
  • With engine warm (90 °C) the engine temperature suddenly drops (70 °C) and slowly comes back to 90 °C.
  • Bad acceleration during warm-up.
  • Diesel Engines: Glow plug indicator may be on for a longer than normal time or at ambient temperatures where it shouldn't come on at all.
Possible Causes
  • The electrical signal coming from G62 is too low
  • Wiring and/or connections faulty (short circuit?)
  • Engine Coolant Temperature Sensor (G62) faulty
Possible Solutions
  • Check wiring and connections
  • Check / Replace Engine Coolant Temperature Sensor (G62)
Special Notes
  • In many cars between MY 1995-2002 the G2/G62 had a bad reputation for failing often. The original G2/G62 sensor is black and the improved replacements are green.

Jan 26, 2010 | 2000 Volkswagen Beetle

1 Answer

Low idle and stall when warm 1991 nissan 2.4 l d21 4 cy 2 wd


I feel the codes may be the answer here, idle should be around 8-900 rpm. There are a lot of possibilities for this kind of issue and the codes would be a great place to start.

Jul 07, 2017 | 2003 Chevrolet Silverado 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

fordexpert

Level 3 Expert

5495 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...