Question about Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Rear Axle Bearing Replacement
That absolutely sounds like an axle (wheel) bearing. Jack up that corner of the truck and grab the top and bottom of the wheel, and shake like crazy. If you have any play whatsoever, it's a sign of a bad bearing (although you could have a bad one and not have any play - it would only mean the bearing isn't worn badly enough to cause looseness in the wheel).
You should be able to remove the axles without opening the diff up. If the axles have c-clips or snap rings on the ends inside the diff, you can usually get the axles out by dismounting them from the hubs and getting them free of all attachment except the diff, and then use a large flat-tip screwdriver as a pry bar. Use it right where the axle body mates to the diff, and lever it while you pull/yank/shake/swear at the axle, and you'll manage to pop the axle out of the diff. Sometimes it takes some time and profanity, but so far it's worked for me everytime.
Posted on Aug 02, 2008
Go to my profile I have just explained how to change a cv boot on a Trooper. The axle needs to be taken out to change the boot so the same solution. What you call an axle I have refered to as a drive (short for driveshaft) It takes a lot of explaining so save me a lot of writing if you read the solution I gave for changing the CV boot. Cheer's
Posted on Sep 28, 2009
wheels, drums or rotors, the cover for the differential (You will need a drip pan)
remove the "pin" (usually a 5/15" or 8mm head) that secures the spider gear pin. Remove the long spider gear pin, as it should slide out without a lot of force.
Push both axles inward, and remove the left and right "c" clips that hold the axles in.
Note... if you have a limited slip, it may be a little different of a set up due to clutches in the differential.
Posted on Nov 05, 2009
Jack up the rear of the vehicle. Remove the rear end cover. Usally there will be a bolt that holds a round steel pin thru the differential. Remove the pin, you should be able to then push the axle towards the middle of the rear end to remove the c type clip that prevents the axle from coming out, then side out the axle.
Posted on Mar 06, 2010
Tips for a great answer:
Jun 09, 2016 | Isuzu Cars & Trucks
May 04, 2016 | Isuzu Cars & Trucks
Feb 01, 2016 | Isuzu Cars & Trucks
Jul 20, 2015 | Isuzu Cars & Trucks
Aug 17, 2011 | Isuzu Axiom Cars & Trucks
May 01, 2010 | 2001 Isuzu Trooper
Mar 09, 2010 | Isuzu Pickup Cars & Trucks
Feb 05, 2010 | 2001 GMC W3500
Dec 08, 2009 | 2001 Isuzu Trooper
Dec 15, 2017 | Chrysler Cars & Trucks
670 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: