Cars & Trucks Logo

Related Topics:

Brian Swinley Posted on Nov 01, 2012

My mitsubishi lancer key wont open or close my car remotely although the battery is ok

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Jun 27, 2008

SOURCE: BMW remote control problem

I have a e60 525i that I just brought and it has the same problem, the owners manual suggests driving with the key in the ignition for a long time as the batteries are rechargable and may have gone flat, i have tried this and it doesnt seem to work

i also read something about getting water in the aerial about the rear window and that wrecks the receiever. My car isn;t under warranty so not looking forwarding to taking it to bmw

Ad

Anonymous

  • 2004 Answers
  • Posted on Aug 05, 2009

SOURCE: fuel pump in a mitsubishi lancer 91.

The fuel pump is located in the fuel tank and you can reach it by removing the back seat.

Rate this fixya!

Anonymous

  • 984 Answers
  • Posted on Nov 04, 2009

SOURCE: Ford F150 remote key does not work after car battery

Should not have happened,
For the Factory RKE ( Remote Keyless Entry ) have you tried reprogramming the key fobs to your truck. The procedure is in the owners manual ( need all of them at programming time ).
This is stored in NVR, and should not need to be done, but worth a try.

If this is an aftermarket Remote start / alarm, check the owners manual for t on battery replacement. Have seen some off brand with strange battery ( truck's battery that is ) replacement steps.

Anonymous

  • 13 Answers
  • Posted on Apr 10, 2010

SOURCE: can not lock car by key remote . toyota rav 4 53 plate

If your car has an alarm with a separate remote, it is a separate system and it is probably self-arming. When you lock the doors with the key central lock, the alarm gets armed by the RAV4 being OFF and the door locking action. When you unlock the doors with the key, the alarm is still armed because the key is not comunicating with the alarm just the cars factory keyless system.

Anonymous

  • 1 Answer
  • Posted on Sep 24, 2010

SOURCE: my car bmw 320d wont lock with remote does open

ive just discovered this same problem with my bmw 320d this morning! any theories why it wouldnt lock? would be very helpful

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

Car wont start battery seems ok first time turnkey today engine made some notice then nothing happens when turning the key

With out seeing the vehicle it could be a number of reasons, battery, wiring fault, starter motor, earth fault
0helpful
1answer

Keyless remote wont work

Many times if you purchase a used vehicle, the car lot only provides the key because they do not want to spend the money to purchase a key fob. A 2006 Lancer either has a 2 or 3 button keyless entry remote which you can find here: http://replacemyremote.com/
Keyless Entry Remote Fob Replacement
1helpful
1answer

I replaced my remote battery now car won't start or close doors or open doors. with spare key .i can only start the the car by taking the spare key out of the remote putting it into the ignition and...

If you need to be that close to the car to start , you still have a bad to low battery.,You notice that you had to get close to it.If you are sure absolutly have a new battery enter the car put key in regular position leave key in for 2 minutes cylce it off there see if it will start back in it normal range.
0helpful
1answer

+Mitsubishi Lancer GLS 1996 The STOP lights will not come on

are you useing a test light to see where you have power and where you do not.check the fuse with a test light there are times you can not see a bad fuse.
0helpful
1answer

Key less entry stopped working

poss low charge in battery in keys..... nearer you get lower the battery life.....
3helpful
1answer

The battery in my key fob for my 2004 Mitsubishi Diamante went flat. How do I reset it now that I have replaced the battery?

1-insert and remove key from ignition two times

2-close and open driver door two times

3-insert and remove key once from ign.

4-close and open drvr door twice

5-insert key into ign.,then close driver door

6-turn key to on (not start) then off, twice this is rewrite mode,have all remotes to reprogram it will clear any lost remotes.

7-remove key from ignition,the door locks should cycle twice.if not start over.it may take a few tries.

8-press lock/unlock together and hold for a second

9-release,and press lock on remote,the door locks will cycle confirming program.continue to do other remotes you have,steps 8 and 9.if only one in possession,you are done. To end mode open door or insert key into ignition.

You'll need to follow the steps with no more than a 1-2 second delay between each step.. hope it works
0helpful
1answer

Hi i have a mitsubishi lancer 1.3 petrol 2006, i

wow ok i am from australia our lancers only come in a 2.0 or 2.4 i was shocked to see a 1.3 lancer
now with the key
every time you incert the key into the ignition it reads the key as there is a chip in the orignal keys so thatway the immobiliser knows thatit is safe for the car to start
if the cra can not read the key it will not let the car start evan if it is twisting to start etc
you need to go to mitsubishi and have them copy some new keys and let them reset the codes on the immobiliser if you try to do so your self it may trigger a cold shut down
this is when the immobiliser its self needs to be replaces as well as the keys
hopes this helps
ricko
0helpful
1answer

Remote not working how to manually disarm alarm

did you get a different key for your alarm box if not thy the ignition key. joe
Not finding what you are looking for?

136 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...