Question about Chevrolet Cars & Trucks

Open Question

How do you remove power window switch from 1988 chevy truck

Posted by Anonymous on


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 21 Answers

SOURCE: how do I remove the brake drum on achevy 1 tone

depending on the axle type you may have to remove the bolts on the axle and (small bolts on the outer end should be eight or ten depending on the axle) slide the axle out then remove the lock clip on the bid axle nut ,the nut inside the drum assembly reqiures a special soket that you can get at any auto parts then you pull the drum and hub assembly off be carful not to damage grease seal on the inside of the drum install in reverse order when assembly is done check axle fluid level by removing fill plug by using a 3/8 rachet if fluid run over threads dont add any after that install plug and jack up axle one side at a time to let the fluid fill the bearing housing in the drum then on level ground check fluid level again it should just barely come over the threads of the filler hole

Posted on Jul 04, 2009

  • 407 Answers

SOURCE: removal of 1976 chevy truck ignition switch

need a special tool to remove the locking plate behind steering wheel then pull turn signal switch back a little then remove screw that keeps lock cylinder in place

Posted on Oct 22, 2009

  • 1 Answer

SOURCE: hydroboost brakes on 1988 chevy truck

does the 88 chevy 1\2 ton 4wd pickup have antilock brakes on it???

Posted on Jan 19, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Can I get a manual window door from the salvage yard and replace the power windor door on my 1988 chevy c1500 that doesnt work?

Yes, you can get a Manuel operated window and install it in your present door you just have to disconnect and remove the present window motor and the elec. You may have to change the door pad as well so you have a hole in the panel for the manual crank for the window.

Feb 23, 2013 | 1988 Chevrolet C1500

1 Answer

Switch not switching tanks on my 1988 chevy dually

I'm pretty sure the switch on the dash controls an electric valve and power to each pump. Have you checked the control valve for voltage ?

Sep 25, 2012 | 1988 Chevrolet C/K 3500

1 Answer

How to replace a power window channel guide on a 1988 chevy cavalier 2 door coupe

No it doesn't

The window has no track to jump off of

You may need a new window regulator
You determine that by removing the inner door panel

Jun 12, 2012 | Chevrolet Cavalier Cars & Trucks

1 Answer

1988 chevy suburban door panel how do you remove it

I have a 1988 GMC pickup,should be simular,my windows are power windows,the switches can be carfully removed ,(which will have to be done),by depressing clips holding them in carefully tilt them out.
remove wires noting where they go on switch .
remove two screws from arm rest, located underneath arm rest.if you have manual windows there is a wire like clip inserted into a slot in crank handle holding it on to the regulator shaft, you may be able to get it with a screwdriver, but you can get a tool from part store that works much better.
after that gently work around the door pannel with flat screwdriver poping the plastic retainers out of the door, be carefull not to rip them out of the pannel.
I hope this helps!

Oct 07, 2011 | 1999 GMC Suburban

1 Answer

1988 volkswagen golf gt light problems. The low beam headlights do not work along with brake lights and reverse lights. Bulbs are good and all fuses are good. No power to any of the bulbs. I think it has...

Same thing as the Chev. Check the dip switch on the combination switch. Also sheck reverse light switch by removeing the connector and jumping. Do the same check for the stop lights be it pressure or contact switch.

Oct 05, 2011 | 1988 Volkswagen Golf

1 Answer

1988 chevy truck door panel removal. can not get electrical connections apart

on the 98 some are direct conected to the switch panel by a srew some are pop ribbited and you take the switch panel out with it

Jul 31, 2011 | 1988 Chevrolet C1500

2 Answers

1988 chevy 2500 5.7 no por to fuel pump fuse

is there an anti theft system installed ??
if yes it is ingauged

Jan 03, 2010 | 1988 Chevrolet K1500

1 Answer

Where is the window fuse for a 1988 Chevy Celebrity

look in fuse box for pw fuse ,power window, most have fuses,should look like regular fuse in fuse box. hope to help,robert b.

Jun 20, 2009 | 1988 Chevrolet Celebrity

2 Answers

88 Chevy Power Windows

Get a can of electrical cleaner or brake cleaner,and take your switches apart and clean them. 9 times out 10 that's all you need, especially a truck that old, they are bound to be dirty, and not making connection.

May 27, 2009 | 1988 Chevrolet C1500

1 Answer

Removing a door panel on a 1988 chevy C15 truck

There should be a couple of screws on the arm rest that you need to remove and probably one on the door handle then you need to find something to pry the panel off with, without breaking the plastic clips. They make a special tool for this that you can buy for just a few dollars at any auto parts store. If attempting to do it without the right tool be careful not to break the clips.

May 15, 2009 | 1988 Chevrolet C1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

260 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides