Question about Cars & Trucks
I have the same jeep,and there is none on a jeeps only on fords. there is a fuel pump relay on the jeep. it is located under the hood
Posted on Nov 01, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
ok it has nothing to do with the gear box
no ower to your injectors check engine fuse
if and wen u took the gear box out did take the positive lead off?
if u did unplug the computer or try the reset so the computer can no the car is back togeather
Posted on Jul 19, 2008
C1 & C2 in your panel are most likely one of the culprits, if no power at heater at seat. Sounds like testing for power at seat switch is easier to do than get at these circuit breakers in the panel. If you have power at switch at seat, then it's not the fuse/circuit breaker. Good reading at this link for you.
Posted on Dec 29, 2008
If you have the owner's manual look up fuses in the index, good illustration. If you don't, I do. It shows a relay and a 15 amp fuse. Look at the passenger kick panel, pull the cover, and it is #2 fuse (second from the top on the left) The see the relay you may have to pull the panel (two screws and a clip) the relay is the third cavity down, third row from the firewal side.
Let me know if this works for you?
Posted on Apr 03, 2009
The idle air control valve is located on the back of the throttle body. It has an oval electrical connector and two torx screws holding it in. Unplug the connector, remove the two screws then lightly tap the body with a soft faced mallet to loosen it from the body.
Once you have it out and prior to installing a new valve clean the seat inside the throttle body where the idle control fits. This must be very clean! Installation is in the reverse order.
To save some cash, pull the valve out and clean it with throttle body cleaner, this usually fixes the problem for quite a while.
Good luck and hope this helps.
Posted on May 28, 2009
You don't have one on there. Pump is turned on and off by the automatic shutdown relay and the pump relay. The crank sensor signal keeps it on. If the asd relay does not get a signal from the computer (from the crank sensor), it turns off the pump relay (and spark).
The pump should run when you first turn the key on. When you start the engine, if the computer gets no signal from the crank sensor it will shut the engine off (no fuel, no spark = off)
If when you first turn the key to on, you can't hear the pump, likely either the pump has failed (check power at the pump harness) or the relay is bad.(swap relay for a known good one and try it).
Posted on Apr 17, 2010
Tips for a great answer:
May 31, 2012 | 1995 Jeep Grand Cherokee
Jun 24, 2011 | 1996 Jeep Grand Cherokee
Apr 17, 2010 | 1996 Jeep Cherokee Sport
Feb 25, 2010 | 1996 Jeep Cherokee Country
Jan 16, 2010 | 1994 Jeep Grand Cherokee
Jan 11, 2010 | 1996 Jeep Grand Cherokee
Nov 14, 2009 | 1996 Jeep Grand Cherokee
Nov 08, 2009 | 1996 Jeep Grand Cherokee
Oct 09, 2009 | 1996 Jeep Grand Cherokee
May 09, 2009 | 1996 Jeep Grand Cherokee
36 people viewed this question
Usually answered in minutes!