Question about Dodge Cars & Trucks

1 Answer

The clutch on my 99 dodge ram 1500 seemed as if it were slipping, the next day I could push the clutch in, put it gear, but nothing happens after releasing the clutch..... Please help I need my truck back Details

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 44 Answers

Sounds like a bad pressure plate and that's a big job

Posted on Nov 03, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: 99 Dodge Ram 1500: Engine starts but then immediatly dies.

Sounds like a fuel issue. If it only does it when it's cold try putting some heet in your tank?

Posted on Jan 22, 2009

Monster80
  • 460 Answers

SOURCE: 99 dodge ram 1500 4x4 5.9l tranny problems

Take a look at the down shift cable and make sure its not broken especially were it connects to the throttle linkage.And maybe try cleaning the electrical plug that plugs into the trans.Its about a 7 to 9 wire plug.They tend to collect water and short the wiring out.

Posted on Mar 31, 2009

rockitman187
  • 2559 Answers

SOURCE: 1998/99 Dodge Dakota clutch and manual transmission problems

clutch needing replaced, very common on all manuals

pedal travel adjustment,yes
gear shift adjustment,no

Posted on May 12, 2009

Molson02536
  • 3854 Answers

SOURCE: Dodge Truck Transmission

It could be the Vehicle Velocity Sensor (VVS) or it could be the Transmission control module (TCM). Check all the wire harness, V.V.S and T.C.M. The best thing to do is to check the truck for any DTC code. Auto Zone scan free of charge and hope we can find out why the transmission is not working properly. Keep me posted, be glad to help.

Posted on Jun 30, 2009

  • 2 Answers

SOURCE: 99 dodge ram interior lights wont come on

I had the same problem and could not understand why I THOUGHT I checked all the fuses, but there is a fuse on the drivers side which is covered by a black thing (no idea why). It is listed as IOD or something. If you lift the black thing up and remove the fuse you will notice it is blown. Replace this and all will be well again.

Posted on Oct 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1997 dodge ram 1500 4x4 abs light on runs fine idles good but put it into gear wont go past 35 mph engine running smooth even at 35 mph


Bernard's Blog: Dodge Transmission Output Speed Sensor

bernardsblog.blogspot.com/.../dodge-transmission-output-speed-sensor.h...
Sep 8, 2009 - My 99 Dodge 2500 Ram won't accelerate..transmission is NOT slipping,.... It has been running fine and the check engine light even cleared itself yesterday.... So it wouldn't go into first gear and then 3 minutes later my check engine ... I have a1997 Dodge Ram 1500 with a 5.9L instead of the stock 5.2L. It ...

Dodge Ram Idle and Stalling Problems - Car Forums at Edmunds.com

forums.edmunds.com > Dodge > Dodge Ram Pickup 1500

Aug 17, 2011 - 30 posts - ‎25 authors
Learn more about Dodge Ram Pickup 1500 at the Edmunds.com ... The crank sensorwas put on however it started stalling again. ... The truck starts fine, but will only runat 2000's RPM and only then if .... Then as I start driving about 1/3 of a mile go dead again, I knockout of gear, crank back up immediately.

WILL NOT GO OVER 30MPH WITH PEDLE TO METAL ...

repairpal.com > Questions > Dodge > Charger > 2006 Dodge Charger
I WAS DRIVING FINE AND THE CAR ACTED LIKE IT GOT STUCK IN ... Then the transmission didn't want to change into 2nd gear. .... Whenever i start up my car theabs and esp light turn on and when i try driving it doesnt go over 30 mph even .... in neutral but not it just wont go up hills and i think it has something to do with

Jan 07, 2016 | Dodge Cars & Trucks

1 Answer

I have a 1999 dodge ram 1500 when you push the clutch in all the way there is a grinding noise and tough to engage into gear and there is a high pitched squeeling noise that comes and goes as the pedal...


you need to replce the cluch and preasure plate. the clutch is gone, its hard to shift because there is nothing left to pushout on the plate and the squeeling is from the same problem, the clutch works like brakes, when the pads are gone and you step on brake you get asqeeling sound from it being metal to metal the same thing is happening with your clutch

Mar 26, 2012 | 1998 Dodge Ram 1500 4WD

1 Answer

Tranny acts and feels like it is going in reverse but but seems like it slipping 99 dodge ram 1500 1/2 ton


i was told this is normal that it take a few sec to pump the fluid back to the torque converter

Mar 15, 2010 | 1999 Dodge Ram

2 Answers

1997 Dodge Ram 4x4 1500 transmission shifting problems.


good day, you may try replacing your automatic transmission fluid, a good run will be noticeable, hope this helps, have a nice day

Feb 08, 2010 | Dodge Ram 1500 Cars & Trucks

1 Answer

1998 dodge ram 4x4 transmission problems


You will need to get the transmission rebuilt. With the info that you have provided the direct clutches are welded together. Becareful about getting it rebuilt, most shops see Dodge transmissions and they see dollar signs. You should be able to get it rebuilt for around $800.00 to $1000.00 depending on amount of damaged hard parts. Thanks and good luck with your repair.

Jun 20, 2009 | 1998 Dodge Ram 1500 4WD

2 Answers

Rear end slipping?? 2001 dodge ram 1500


Some limited slips use an additive, available at the dealers parts department.Otherwise,it's a rebuild.Good luck. (Are you sure it's not the trans?)

Jun 10, 2009 | 2001 Dodge Ram 2500 Truck

1 Answer

1997 dodge ram 1500 5.9L getting hot


My best guess is your fan clutch has gone bad and your fan is slipping and turning too slow. I have a 1997 Dodge Ram 2500 van with the 5.9 liter engine and I just replaced my fan clutch a few days ago. It cost me about $60 since I did the work myself. If you plan on replacing it yourself I can give you fairly detailed instructions. Just post a comment here if you want the instructions and I will provide them in another comment.

Jun 01, 2009 | 1995 Dodge Ram

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...