Question about Cars & Trucks
The common cause would be a worn out and compressed rubber door seal or seals.
Posted on Nov 01, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Are you hearing any noises from the pass door when you activate the lock switch? If not, the power door lock solenoid has failed, and prob needs to be replaced. Pull the door panel & check to see if it is getting power to the solenoid in lock & unlock. If it has power, the solenoid is def bad.
Posted on Sep 19, 2008
I was a manager at a Mitsubishi dealership.
There was a "secret warranty" on certain Galants where the firewall seam would fair and leak water into the interior. Call your local dealer to see if your vin qualifies. The fix is to simply reseal the firewall crimp seam with silicone sealant.
Alternatively, sunroof equipped cars sometimes get the drain channels clogged in time. Make sure to clean drain holes and use forced air if necessary.
Lastly, some cars have heaters with pollen filters. If those filters become clogged, condensation can accumulate and overflow into the interior.
If any of these solves your issue, please rate my answer
Posted on Jan 09, 2009
SOURCE: fuel pump for 2000 toyota celica
Yes, remove the rear seat cusion and then lift up the padding. Take the screws out of the cover and them you can access the top of the fuel tank and remove the pump and fuel level sending unit.
Posted on Mar 02, 2009
You should be able to access the buld holder from the rear of the headlight. It's a nylon bulb holder with a lock thing on it. You squeeze the lock part and turn it counterclock wise, and it should come out. Remove the old bulb and install the new one being careful not to touch the glass of the new bulb with bare fingers. The finger print you will leave can cause the bulb to prematurely die on you.
Posted on Jun 15, 2009
i would suggest getting a replacement e/w motor from the breakers yard and swithing it over. much cheaper then paying for a diagnostic!! its not a big job and shouldt cost much. id def use breakers for new motors as toyota charge a massive price for everything!!!!
Posted on Jun 29, 2009
Tips for a great answer:
Sep 11, 2012 | Toyota Celica Cars & Trucks
Mar 19, 2011 | 2000 Toyota Celica
May 31, 2010 | 2000 Toyota Camry
Nov 11, 2009 | 2002 Toyota Celica
Sep 07, 2009 | 2000 Toyota Celica
May 08, 2009 | 2000 Toyota Celica
21 people viewed this question
Usually answered in minutes!