Question about Chevrolet Cars & Trucks

1 Answer

Where is oil pressure sending unit on 2005 malibu maxx

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 776 Answers

Hi,you will normaly find a sensor switch near where the oil filter is situated,if you see a wire going to the sensor pull it off then put ignition on and check if that the gadge if its stoped working.
hope this was some help.

Posted on Apr 16, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Pontiac Bonneville(2000) oil pressure sending unit

The oil pressure sending unit is located behind the oil filter, Threaded into an aluminunm housing. It has wiring that plugs into the sending unit. The oil filter has to be removed and you will need a deep well socket and a 6 inch extension. Change the oil and the sending unit together.

Posted on Feb 02, 2009

farroutideas
  • 78 Answers

SOURCE: oil pressure sending unit

Hi there;

Your looking foer the oil pressure sensor on the 2004 8.1L.
You will find it located directly behind the EGR valve threaded into the block just to the drivers side of the center bolt for the transmission to block connection.

Thanks
Farrout!

Posted on Mar 17, 2009

  • 118 Answers

SOURCE: where is the oil pressure sending unit located?

The pressure sending unit is located on the passenger side rear of the engine just above and slightly to the left of the filter and filter housing.

Posted on Aug 01, 2009

  • 247 Answers

SOURCE: 02 cherokee losing oil pressure when accelerating, fine at idle.

Was the sending unit an aftermarket part?We like to install the original part back into most vehicle, but because of people price shopping, this can cause some issues. If the switch is working properly, the gauge should rise as the engine RPM's increase as you stated. With the key on and the engine off, disconnect the sending unit wire and ground it. The gauge should go to the highest reading, and that checks the wire, and the gauge. I suspect that the sending unit is failed or not the proper one for your vehicle.

Posted on Jan 07, 2010

  • 753 Answers

SOURCE: 2005 Chevy Malibu Maxx cd changer error

You will need to have the radio reset or checked out at the dealer.Ther could be a cd stuck in it.Or the radio/CD player may have be on when the battery power got to low.

Posted on Jan 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i change oil pressure sending unit on a 2005 chevy malibu


Hi Viv,here's a link to the oil pressure switch,it is located by the oil filter,it is screwed into the block,to remove, just remove electrical connector,then get a wrench and take off,very easy to do. Oil Pressure Switch at AutoZone com Best Oil Pressure Switch Parts for... HERE'S A VIDEO TO WATCH. FIX OIL LEAK How To Replace Oil Pressure Switch Oil Sender etc POV

Oct 01, 2015 | 2005 Chevrolet Malibu

1 Answer

Fuel/temp gauge not working on my 2005 Malibu classic


Fuel gauge is the sending unit in the tank. The temp gauge is the sensor. Usually by the thermostat/upper radiator hose

May 10, 2014 | 2005 Chevrolet Malibu Maxx

1 Answer

How to change the oil pressure sending unit for a 2007 Chevy malibu


I know this this is awful old, but seriously It was hard to find and now having replaced the Oil pressure sensor in my 2007 Malibu Maxx Hatchback (3.5 L Engine). I can assuredly tell you where it is.

It's right above the Oil Filter on the front bottom side of the engine. I accessed it from under the car. It's cramped, You'll find removing the starter motor useful. There is a heat shield over it, but I couldn't get to the nuts easily, but found I didn't need to remove the heat shield. The sensor took a 22mm deep socket (mine was 1/2" drive). to get it out, and back in.

It's number 1 in the figure below that was a screenshot from the Ebsco Automanual website - the only source that actually knew where thing thing was located. You can see the filter below and the starter motor.


capture-wrzw0canhac5hkh035fz3bi0-2-0.png

Mar 12, 2013 | 2007 Chevrolet Malibu Maxx LTZ Hatchback

1 Answer

How does one check transmission oil in 2005 chevy malibu maxx


You don't yourself. The lube change shop or garage can do this (requires special tools or removal of the pan). for a 2005 you're likely in need of a flush. some models can have a dipstick installed, but its not necessary. Unless you have a serious leak of fluid or shifting issues, it's rare to lose fluid. If you are having issues, then start with a flush and inspection BY A REPUTABLE GARAGE. do not use a dealer or transmission shop, they will always find ways to seprate you from your $$$

Jan 22, 2013 | 2005 Chevrolet Chevrolet Malibu MAXX LS

1 Answer

Where is the oil sending unit located on a 2002 chevrolet malibu


V6 ENGINE OIL PRESSURE SENDING UNIT LOCATION NEXT TO OIL FILTER. THE 4 CYLINDER ENGINE OIL PRESSURE SENDING UNIT LOCATION IS FRONT CAMSHAFT HOUSING ON THE LEFT DRIVER SIDE OF THE ENGINE COMPARTMENT.

Mar 20, 2011 | 2002 Chevrolet Malibu

1 Answer

Speedometer goes up and down while driving at a set speed 05 chev malibu maxx


mite want to have your auto scanned at a parts place 1st to see if there are other issues-the old days are gone. now your speedo sending unit or sensor could be bad or wiring also. the whole cluster may need removal and sent to a specialist for repair

Dec 26, 2009 | 2005 Chevrolet Malibu Maxx

1 Answer

My malibu's oil pressure light came on while driving and then when i hit the gas pedal it acted like i ran out of gas but had a full tank and then shut off


Oil pressure sending unit shuts off fuel pump if there is a problem with the unit (Oil pressure sending unit maybe malfunctioning)

Nov 24, 2009 | 1999 Chevrolet Malibu

1 Answer

2005 chev Malibu maxx


Great design!!!! There is a plug on the right side of the unit.(like the ones on a stickshift trans) you need to remove it on level ground and fill through the hole you mentioned. It's full when fluid begins to run out of the hole on the side.

Sep 18, 2009 | 2005 Chevrolet Malibu Maxx

1 Answer

Engine light is on. is this serious?


It means something isn'nt at peak.
Not immediately serious just make sure your water and oil are proper, The dealer would be your best bet for diagnostics. and resetting the light. Good luck

Jun 01, 2009 | 2005 Chevrolet Malibu Maxx

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

524 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...