Question about Nissan Cars & Trucks

1 Answer

Reset check eng. light

Replaced filler hose on gas tank but will not reset

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Nissan Master
  • 76,164 Answers

To turn it off disconnect the battery negative cable for 5 minutes. If the light comes back on after driving you did not fix the issue.

Posted on Nov 01, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
frcs68
  • 1605 Answers

SOURCE: fill gas tank

have toyota or any machanic check the filer in the gas filler tube.

Posted on Nov 03, 2008

canbruce75
  • 1776 Answers

SOURCE: Serv. Eng Light mystery

The evaporative emission system is designed to prevent fuel vapors from being released into the atmosphere. The vapors are absorbed and stored by a fuel vapor (evap) charcoal cannister until certain engine conditions are met, then the vapors are purged and burned in the combustion process. I would lean toward a faulty purge solenoid based on the condition that you describe. I would also look at a faulty gas cap. The gas cap is an integral part of the evap system and will cause these kind of problems if faulty and not venting properly. Hope this helps and that you find a resolution to your problem.

Posted on Jul 23, 2009

  • 3 Answers

SOURCE: 2001 Hyundai Accent - gas tank slow to fill

http://www.hyundaiforum.com/forum/showthread.php?t=5971

This has detailed instructions and diagrams (scroll down a couple posts to see the images.)

Posted on Apr 09, 2010

  • 1 Answer

SOURCE: check eng light trouble code PO420 bank 1 on

My 2002 Camry V6 is having some issues. Went in for an oil change that turned into a front struts, springs and mounts job. Then I was having some problem in the higher speeds waiting for the car to shift, so had a tune up done, which meant new spark plugs, and of course, the gasket! So now I am out about 1K and now the check engine light comes on. Had it checked out and and a catalytic code came up. They fiddled with it and got the check engine light off, but now the VSC and TRAC OFF lights are on. What does all this mean? Should I take the plunge and get the cat converter done now?

Posted on Aug 18, 2010

  • 5522 Answers

SOURCE: how to reset engine check light for loose gas

Just disconnect the NEG battery terminal for 10 minutes and the Code should clear. Or you can get a free scan at Autozone or Oreillys and they will use their scanner to clear your computer.

The advantage with the scanner is you will not lose radio station Presets or security codes.

Posted on Sep 13, 2010

Testimonial: "quick response. "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i remove the hoses from my gas filler neck


I do not have experience with a Durango. I have experience with a Chevrolet. The hose on the filler line was large diameter and very hard. It would not slip off. I had to empty the gas tank, cut the large hose, and remove the small hose. Then I had to jack up the car, and lower the gas tank to the ground to have room to work. From there is was simple to remove and install parts, install the gas tank, and tank up.

Nov 30, 2014 | Cars & Trucks

2 Answers

I can smell gas outside car. No gas drips on ground. I Just filled gas tank and as I went around a sharp turn, a car in back of me reported gas comming from rear of car. When air is on max, we can smell...


Have the filler hose checked for a break. The hose that connects the filler tube to the gas tank. Sounds like it is loose or broken, when you turn the corner the gas slops out of the tank cause the filler tube is not connected good.

Jul 17, 2011 | 1997 Mercury Grand Marquis

3 Answers

P0456 error code on a 2003 Mits. Galant


P0456 = "Evaporative emission (EVAP) control system leak detected (very small leak)."

Feb 25, 2011 | Mitsubishi Galant Cars & Trucks

1 Answer

My service engine soon light was on. I took the vehicle to a mechanic and the code came back po422. A smoke check was performed and they said it had a leak in the filler neck and the entire gas tank needed...


If they forgot to tighten the hose clamps on the hose from the tank to the filler cap it could be setting it off. If they are all tight it was probably just the gas cap. The gas cap is usually ALWAYS the culprit. Let me know if this helps

Jan 19, 2011 | 2004 GMC Envoy

2 Answers

Gas takes forever to drain into filler tube when gassing up at the pump


check to see if theres any objects in the filler tube. If you have small children they can find a million things to do to that van

Feb 03, 2010 | 2005 Dodge Caravan

1 Answer

Gas filler neck replacement


open the fuel cover and remove the bolts.Remove the ground strap from the filler tube from under the car.Remove the hose clamps to the rubber hose going into the tank and pull off the hose.Now the filler tube will come out[ if has'nt already fallen out and hit you in the head].

Nov 18, 2009 | 1997 Oldsmobile Cutlass Supreme

2 Answers

How do i get the filler pipe on my 99 mercury cougar to disconnect from my gas tank?


I guess you failed the low pressure EVAP emission test.

GATE HOSE sell bulk gas tank filler hose.

Check out Kragen,com or similar auto part stores for bulk gas line hose.

Jul 15, 2009 | 1999 Mercury Cougar

1 Answer

P0442 code on 02 ram 1500


It is a vacuum leak from the engine to the gas tank. Did you leave of the gas cap. May just be a faulty gas cap. Filler neck could be cracked. Check hoses going to tank for cracks. To test the gas cap you can place a plastic bag on it and screw it on. You have to drive 20-50 miles to clear code.

Jun 15, 2009 | Dodge Ram Pickup 1500 Cars & Trucks

1 Answer

Gas tank filler hose on Ford E Super Duty Motor Home


Look again into the fuel filler there should be a metal hose which is where the tank gets it's air from, ensure when your filling up your not pushing the fuel filler gun fully home when filling up, suggest you don't fill the tank right up to the very top as your correct it's a big job & you will need parts before you take the tank off. http://passionford.com/forum

Jul 03, 2017 | 2007 Ford E-350 Super Duty Length XLT

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...