Question about 1994 Chevrolet S-10 Blazer

1 Answer

Transmission not shifting

Truck will go into R-1-2 but will not shift beyond that,just starts slipping trying to shift

Posted by on

  • robert3571 Jan 10, 2009

    Thank-You for all the assistance and info, I ended up taking it in and the trans was shot,clutch rings and the 3-4 plates were burnt up,just went for the total rebuild

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 146 Answers

First thing you should do is smell the fluid. If it smells burned, have the trans. rebuilt. If it smells fine, pull the trans. pan off, see if you have a loose or broken solinoid. Hope this helps.

Posted on Jan 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rodeo wont shift right from winter drive


well you need tranny service.?
right?
did you scan the PCM first to see if there are DTC errors for the trans. seem not and that is first. after.
1: checking levels in box.
2: checking fuses.


older post missed by me.

Mar 09, 2015 | 2001 Isuzu Rodeo

2 Answers

Can the TCCM on a 96 blazer 4.3 cause transmission to not shift properly from 2nd into drive and overdrive


It sounds like when you accelerate it downshifts and acts like it is in neutral, when you let off, it shifts back to coast like it is in drive. I would question shift solenoid first. I know this is what 1-2 shift solenoid can act like if you have no low 1 and starts in low 2 or 2nd. There are two solenoids, 1-2nd and 2-3rd. You can drop pan and change them easy.

Jan 17, 2015 | 1996 Chevrolet Blazer

2 Answers

What causes 1996 Dodge Neon SOHC automatic transmission to delay or slip shifts?


that is a hum dinger, largest ever posted, in one shot.
very good.!
one word , the transmission slips. (never drive a slipping tranny)
overheat indicator.! that is key.
many newer cars will change the transmission shifting any time
the engine over heats.
and overheat wins over transmission , every time.
if the engine burns up, what good is any transmission.? nada.

solve overheat first.

slip or flare.
is when the engine RPM rises fast and the car dont go faster.
SLIPS.
and slipping burns up trannyclutchs and increases the damage. inside the transmission, dont do that. dont allow it,
park it and fix it.

on some tranny there is a temperature sensor that the TCM
watches and changes shift patterns based on AFT fluid temps.
and if the ATF fluid gets too hot , it takes actions. to keep the tranny from harm.

why not get a scan too and see what DTC errors there are..
DTC, engine overheate.
DTC< tranny overheat (caused by above)

Jun 14, 2014 | 1996 Dodge Neon

1 Answer

97 eclipse


Starting in about the mid 1980's automatic transmissions changed from fluid shifting to electronic shifting. In other words, your shift is by an electronic solenoid controlled by the computer. There is no Shift cable gong to the transmission. Just wires. You need to look for a loose or dirty electronic connection to the transmission.

Mar 30, 2014 | 2001 Mitsubishi Eclipse Spyder

1 Answer

Transmission not shiftin



For car not changing gears it can be shifter assembly issue, or it can also be transmission issue. Get the shifter assembly inspected with ignition OFF.

For more troubleshooting, I suggest you to get the Following help link checked, its complete step by step procedure to inspect gear shift issues: -----

GEAR SHIFT ISSUES

http://alltypesofpartsreplacing.blogspot.com/2012/11/gear-shift-issues.html

==========


TRANSMISSION GEARS SLIPPING AND FLUID LEAKING ISSUES

Transmission gear assembly and transmission needs inspection. Also check the transmission fluid level. Also is the fluid getting leaked or its low.


There are few very helpful links with solutions to troubleshoot this problem.


========

I suggest you to refer these links.


Click the link below:-----


2000 Toyota Camry: Transmission slipping and Stuck up?

http://whatisbyme.blogspot.in/2012/05/2000-toyota-camry-transmission-slipping.html

-----------

Transmission Slips out of 2nd gear?

http://repairhelpcenter.blogspot.in/2012/02/transmission-slips-out-of-2nd-gear.html

----------

Car engine Overheats and transmission starts slipping?

http://schematicsdiagram.blogspot.com/2011/12/car-engine-overheats-and-transmission.html

-------------

2006 Ford Explorer: Engine Vibrates and gears slipping?

http://whatisbyme.blogspot.in/2012/06/2006ford-explorer-engine-vibrates-and.html

---------------

Clutch slipping problem?

http://howtobyme.blogspot.in/2012/03/clutch-slipping-problem.html

----------

Dodge Anti slip System is not operating?

http://whatisbyme.blogspot.in/2012/07/dodge-anti-slip-system-is-not-operating.html

----------

OD light flashing and transmission fluid leaking?

http://repairhelpcenter.blogspot.in/2012/02/od-light-flashing-and-transmission.html

------------

Transmission fluid leaks near radiator on ford windstar?

http://repairhelpcenter.blogspot.in/2012/02/transmission-fluid-leaks-near-radiator.html

-------------

Ford Windstar transmission fluid leaking?

http://technoanswers.blogspot.in/2012/02/ford-windstar-transmission-fluid.html

-----------


These details will help.

Thanks.

Feb 15, 2013 | 2002 Jeep Grand Cherokee

1 Answer

I have a 1999 Chevrolet Silverado with automatic transmission. When the transmission is shifting from first to second gear it jerks really hard like a thrust when changing.


have it scanned, probably has a code 1870 (transmission component slipping)
means torgue converter is slipping beyond specs, actual casue is valve body is wore out causing pressure problems

Jun 03, 2011 | 1999 Chevrolet Silverado 1500

1 Answer

1993 4l60e - Shifts hard on the 1-2 shift, works fine otherwise.


Did you change the transmission filter and gasket as well as the transmission oil before running your truck.

Sep 28, 2009 | 1994 Chevrolet C1500

2 Answers

96 honda accord ex transmission shift problem transmission does not slip stop at light leave light transmission shift find no problems next stop and start again shift 1 st 2 nd when it shift to third gear...


the first common possibilty would be to check fluid level, if the fluid level is good, I would recommend changing the transaxle fluid and filter. if this does not correct the issue, a professional transmission repair person will need to diagnose for you, good luck!

Aug 25, 2009 | 1996 Honda Accord

1 Answer

Transmission slipping


do u have any transmission trouble codes? u should if the OD light is flashing, the light flashes to alert u that a electronic malfunction is occurring in the trans controls, u may just have a bad trans connector or a shift solenoid starting fail due to a shorted field closing coil.

Jan 24, 2009 | 2001 Ford F350 Super Duty SuperCab

3 Answers

Transmission wont shift into 3rd gear.


I had this exact problem on my 2005 5.3L Suburban... It would shift into 1 and 2 and reverse, but not 3 and 4.

I took it into a transmission shop, and he said the 3-4 shift solenoid was burned up. Wanted 1500 to fix it. Far from home, so I have to pay it.

Nov 30, 2008 | 1999 GMC Suburban

Not finding what you are looking for?
1994 Chevrolet S-10 Blazer Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...