Question about Plymouth Cars & Trucks
I dont know why it decided to let the odometer work and then stop, I thought it was my battery that caused the turnover problem but it wont start after I replaced it, could it be my fuel injector orm my spark plugs? the ac dont work the turn signals nor the odometer, wtf?
That did cause your problem. there is a crank postion sensor on the top of the ******. with a bad crank position sensor you will get no spark .
Posted on Nov 01, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: turn signals and flashers
Hello I had the same problem on my 04 monte. After changing bulbs ,checking wires etc. I finally took it to the dealer and they found out it was the hazard switch. After swapping it with a new one all lights, dash etc started working again and have not had another problem
Posted on Sep 05, 2008
SOURCE: Turn Signals/blinkers
i have a 1992 honda accord and i have no blinkers or hazards but all other things work i replaced the relay and when i put it in my left blinkers come on and stay on all the time no matter what but the hazards work at that point. PLEASE HELP THANKS
Posted on Sep 14, 2008
Check to see if you are getting the correct fuel pressure at the rail. It takes at least 55psi to push past the propets in the spider assembly. Cold weather requires even more psi. You can test this with a cheap fuel pressure gauge from almost any auto part store.
I would also check to make sure the ground for your pump has a good connection, it should be located around your rear bumper in the center. A weak ground will dramatically kill your psi, but still push fuel to the rails.
There is also a problem with the "expensive" spider assembly of that truck. The spider assembly holds the single injector and has 6 tubes going to each cylinder. The lines going into the assembly are known to leak. If you take off the manifold you can easily see if there are any leaks from it, there will be wash marks where the gas has cleaned it. Instead of buying a new spider assembly, there are rebuild kits for it.
If for come to the conclusion that you need a new fuel pressure regulator, don't let them lie to you in saying you need to buy the whole spider assembly. You CAN buy it separately for around $40. If you have problems finding it at local stores, search for it online.
Posted on Sep 14, 2009
SOURCE: Beeping Noise/Blinker Noise
I thought the same thing. In the past with this car that was the case, it needed a lightbulb replaced somewhere on the car. So after replacing 4 lightbulbs on the car, it still makes the noises...question for someone: I did notice that when i open the doors on the car, the dome light does come on but there are no lights down by the floor in the front of the car...if these bulbs are burnt out too then I will need to replace these and maybe the ticking noises will stop? Are there lights for the floor area on the 2003 Alero model?
Posted on Mar 24, 2010
Tips for a great answer:
Dec 30, 2015 | 2000 Plymouth Grand Voyager
May 05, 2014 | 1996 Plymouth Voyager
Jun 04, 2012 | 1996 Plymouth Voyager
Feb 26, 2011 | 1996 Plymouth Voyager
Dec 06, 2010 | 1996 Ford Taurus
Nov 30, 2010 | 2006 Chevrolet HHR
Feb 26, 2010 | 1996 Plymouth Voyager
Apr 21, 2009 | 1991 Plymouth Acclaim
Mar 06, 2009 | 1996 Plymouth Voyager
May 21, 2017 | 1996 Plymouth Neon
65 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: