Question about Volkswagen Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: CD Player does not eject CD
Just took one apart tonight. Same problem, put in cd-played fine-push eject then click click click.
2004 nissan sentra 140 watt single cd player/radio.
This dash comes apart by pulling the top of dash (with the tray) straight out the clips should release. the bottom part had to be pried a little, then remove four screws and slide out the radio still attached to the mount and dash etc. One screw holds on the top of the stereo. After removing the screw you must pry the top off. Now it gets a little tricky, you must remove the cd player portion, however there are 5 tiny springs holding it down to some pads. The two springs in the rear are under a piece of the stereos frame held on by two screws, I had to use various sizes of tweezers to get the springs off. Lift the player out of the radio about an inch, you will see one 1/2" ribbon in a connector, the top of the connector slides out along the ribbon to release. The other ribbon about the same size plugs into a small daughter board in the radio, it just pulls out and pushes in (you can feel it is reinforced). once out turn it over and you will see what would be considered a gearbox, (small white gears in a see through case) one of the corners of this case has a screw through it. This corner has broken away from the board letting the gears come apart when trying to eject (this is the clicking). I took a soldering iron and melted the plastic back together and put a small amount of 5-min epoxy on for good measure. When putting back into case you can hook up the ribbon cables before all the spring grief and test it out. Mine worked perfectly again. Be care full when putting back together, there are a lot of little micro switches that must be in the correct position) Example, if the cd is ejected the white arm on the right side must be in the correct position. the read head (laser) must be away from the center of the cd. I believe it was easier to put together with it in the cd-in position (without a cd in it) so the laser must be toward the center of the cd. Don't force the laser, use the worm gear to move it in or out. I couldn't put one of the springs back on but it still works fine Good luck, it's not as hard as it sounds
Posted on Sep 29, 2008
I had the same problem when I first got it. I realized that the problem was the CD I was putting in. The CD player will NOT read burned RW CDs. I hope that helps! But it will read burned R CDs and ones from the store.
Posted on Mar 05, 2009
I'm assuming the radio works. If so,the player is jammed & unfortunately the only solution is to remove the radio & try to take it apart to retrieve the disk. Usually you end up destroying the radio,but it's shot anyway.
Posted on Jul 14, 2009
SOURCE: CD STUCK IN CD PLAYER
The case needs unscrewing to reveal more of the internals. Go carefully and peer inside wherever you can to fiddle the CD back into place or out of the box. It's in there somewhere, removing panels will get there.
Posted on Sep 07, 2009
Tips for a great answer:
Feb 20, 2014 | Mercedes-Benz Cars & Trucks
Jan 03, 2013 | 2006 Lincoln Zephyr
Nov 12, 2012 | 2004 Kia Sorento EX
Aug 10, 2012 | 2004 Lexus RX 330
May 23, 2012 | Cars & Trucks
Mar 22, 2012 | 2005 Nissan Sentra 1.8
Jun 17, 2011 | 2005 Chevrolet Tahoe
May 03, 2011 | 2004 Mazda 3
Jan 06, 2010 | 2001 Lincoln LS
277 people viewed this question
Usually answered in minutes!