Question about Cars & Trucks
After replacing the alternator the car has lost power to the fuel pump, dashboard, power locks, and the power windows.
It sounds like the battery terminals and/or alternator wasn't hooked up properly. Try checking all connections once again.
Posted on Nov 01, 2012
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
the fuel pump is in the gas tank. you can replace just the pump once you get the unit out. be carefull not to bend the sending unit when getting it out or back in
Posted on Mar 19, 2009
wudyzpp2003: To replace the fuel pump entails removing the rear seat bottom to expose an inspection hole cover which is in the floor. You remove the inspection hole cover and that gives you access to the top of the fuel tank and the place where you remove the pump.
On the drivers side near your knee and the hood release, is the fuse block. Remove the cover and look at the box.
If you are facing the box from the driver's seat, the second row in from the out side and the third fuse up is a 15 amp fuse. REMOVE it. That is for the fuel pump. If the pump was running and you were wanting to remove it, you need to relieve the fuel pressure. You do this by starting the engine with the fuse out, any residual pressure will be bled off.
If you look at the top of the tank where the fitting is, the collar is threaded on there like a bottle cap. A special tool is called for in Nissan's instruction's however, most Nissan tech's as well as those in the aftermarket use large channel lock pliers and exercise care in rotating the collar.
Obviously there are fuel hoses and electrical connectors to address prior to removing the collar. Once the collar is removed, you can lift the pump and sending unit right out of the tank.
NOTE: There are some match marks or alignment marks on the tank and on the top which the collar hold down. Look for them before you remove the top.
Once the pump is out of the tank it should be pretty evident how to transfer the new part.
Posted on Apr 23, 2009
Tips for a great answer:
Oct 19, 2017 | Nissan Cars & Trucks
Feb 18, 2013 | Cars & Trucks
Aug 16, 2012 | 2002 Pontiac Sunfire
Mar 24, 2011 | Nissan Altima Cars & Trucks
Apr 13, 2010 | 2002 Nissan Sentra
Oct 24, 2009 | 2002 Nissan Sentra
Jul 25, 2009 | 1997 Nissan.5 Altima
Nov 18, 2008 | 2002 Chevrolet Blazer
Jul 22, 2018 | Cars & Trucks
79 people viewed this question
Usually answered in minutes!