Question about 2007 Ford F-350 Super Duty XLT

1 Answer

How do i bleed fuel lines - 2007 Ford F-350 Super Duty XLT

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 2,101 Answers

Youo do not bleed fuel lines

Posted on Nov 01, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bleed fuel lines


James, If it is a fuel injected car, probably no air in fuel lines, have car scanned for trouble codes to assist diagnosing problem, could be dirty fuel injectors.

Apr 12, 2016 | Cars & Trucks

1 Answer

How do you bleed a diesel pump jeep Cherokee turbo diesel 3.1 5 cylinder 2001


we dont have this engine here, USA.
but i have the WG jeep book,
starting page 12 , chapter 14


FUEL INJECTION PUMP BLEEDING
(1) If the fuel injection pump has been replaced,
air should be bled at the overflow valve before
attempting to start engine.
(a) Loosen the overflow valve (Fig. 18) at the
rear of the injection pump.
(b) Place a towel below the valve.
WARNING: WHEN CRANKING THE ENGINE TO
BLEED AIR FROM THE INJECTION PUMP, THE
ENGINE MAY START. PLACE THE TRANSMISSION
IN NEUTRAL OR PARK AND SET PARKING BRAKE
BEFORE ENGAGING THE STARTER MOTOR.
CAUTION: Do not engage the starter motor for
more than 30 seconds at a time. Allow 2 minutes
between cranking intervals.
(2) Crank the engine for 30 seconds at a time to
allow air trapped in the injection pump to vent out
the fuel injector drain tubes. Continue this procedure
until the engine starts. Observe the previous WARNING
and CAUTION.
(3) Tighten overflow valve.
HIGH-PRESSURE FUEL LINE BLEEDING
WARNING: THE INJECTION PUMP SUPPLIES HIGH-
-PRESSURE FUEL OF APPROXIMATELY 45,000 KPA
(6,526 PSI) TO EACH INDIVIDUAL INJECTOR
THROUGH THE HIGH-PRESSURE LINES. FUEL
UNDER THIS AMOUNT OF PRESSURE CAN PENETRATE
THE SKIN AND CAUSE PERSONAL INJURY.
WEAR SAFETY GOGGLES AND ADEQUATE PROTECTIVE
CLOTHING AND AVOID CONTACT WITH
FUEL SPRAY WHEN BLEEDING HIGH-PRESSURE
FUEL LINES.
WARNING: DO NOT BLEED AIR FROM THE FUEL
SYSTEM OF A HOT ENGINE. DO NOT ALLOW FUEL
TO SPRAY ONTO THE EXHAUST MANIFOLD WHEN
BLEEDING AIR FROM THE FUEL SYSTEM.
Bleed air from one injector at time.
(1) Loosen the high-pressure fuel line fitting at
the injector (Fig. 19).
(2) Crank the engine until all air has been bled
from the line. Do not operate the starter motor
for longer than 30 seconds. Wait 2 minutes
between cranking intervals.
(3) Start the engine and bleed one injector at a
time until the engine runs smoothly.

end quote.
pump timing is on next page
or tank filter line priming before. above.

Mar 22, 2016 | Jeep Cars & Trucks

1 Answer

Why fuel does not go through pump? Toyota rav 4 d4d engine


1 Blocked fuel filter = fit new filter and bleed fuel lines
2 Air in fuel lines = check fuel lines for cracks, repair and bleed fuel lines
3 No fuel = fuel car, bleed fuel lines

Dec 29, 2014 | Toyota Cars & Trucks

1 Answer

Bleed fuel lines


you do not need to bleed the fuel lines . turn the key on for 30 sec then off do this several times and the pump should prime the sys . if not , you might have a fuel pump problem

Mar 04, 2014 | 2001 Volkswagen Golf

1 Answer

My Pontiac Sunbird 96 ran out of fuel. I need to know how to bleed the system of air. Where is the bleeding line??


you shouldn't need to bleed the air out-if you filled back up with fuel and its not starting you probably have a bad fuel pump-sorry- to bleed the fuel line look where the fuel line connects to the fuel injector rail-on the rail there should be a thing that looks like a tire inflator valve-turn the key on and push in the center of the valve and fuel should come out of it -if not then for sure pump isn't working- cheers Denny

Nov 27, 2013 | Cars & Trucks

1 Answer

Where can i bleed the fuel system under the hood


This is the simplest way to bleed your fuel system short of trying to explain to you where to find an actual bleed port. Loosen any fuel line under the hood until a constant flow of fuel is coming out then tighten the line. Of course ensure you properly prepare the area for the free flowing fuel prior to opening the line.

Jul 11, 2013 | 2007 Chevrolet Uplander LS Minivan

2 Answers

My 5.9 dodge cummins diesel won't start, I've replaced the fuel lift pump, and the fuel filter, turns over. But will not start?


Most likely you just have air in the lines.Crack them open one at a time and bleed them with the fuel pump off and on till you get fuel.If it fires dont hit the throttle let it sit and idle and close the line.Does it fire up with a small whif of starting fluid?

Mar 17, 2013 | 1999 Dodge Ram

1 Answer

How do i bleed the fuel line on 1994 toyota 4runner


There really is no way to depressureize the fuel line as long as the battery is disconected theres no power to the fuel pump hints no pressure

Jul 21, 2012 | 1994 Toyota 4Runner

1 Answer

Bleeding Diesel Fuel line


how to bleed fuel line on a 86 f800 for 8.2 powerbuilt

Nov 16, 2008 | 1992 Isuzu Pickup

Not finding what you are looking for?
2007 Ford F-350 Super Duty XLT Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...