Question about 2000 Buick LeSabre
Where is the crank sensor on 2000 buick lesabre and how do u replace it
It is located behind the harmonic balancer. you will need a harmonic balancer puller
Posted on Nov 01, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.
Posted on Jan 04, 2009
assume this is a 3800,pcv is on pass side of plastic intake manifold,small plastic locking collar has an arrow on it ,says pcv
Posted on Mar 01, 2009
first disconnect the battery then check how the serpentine belt is lined up so u can take it off and put back on. Then the pump should be on the side of the motor with 9or12 bolts there could be more! after taking out take razorblad and skrap the old gasket clean wipe of then put new gasket and pump back on dont over tighten the screws cuase the pump my be aluminum.
Posted on Mar 19, 2009
the mass air flow sensor is located under the top plastic engine cover. to remove this un screw the oil filler tube by hand and remove the top cover. its just to the right of center engine. unplug this sensor. next it has two screws to take this off. It is not standard screws so look at it. remove them and replace sensor. After install go to autozone and have the warning code removed. This is done free. 2000 buick lesabre
Posted on Dec 03, 2009
kind of tricky, took me an hour to get it figured out, but you got to opend the trunk and take out the 10 or so 10mm nuts sticking out of the backside of the lid, then the whole solid piece where the lights are on the back will slide off, then you can change the bulbs above the license plate and put it all back together
Posted on Mar 20, 2010
Tips for a great answer:
Mar 25, 2012 | 2000 Buick LeSabre
Apr 23, 2011 | 2000 Buick LeSabre
Jan 08, 2011 | 1994 Buick LeSabre
May 17, 2010 | 1994 Buick LeSabre
Jul 15, 2009 | 2000 Buick LeSabre
Jun 27, 2009 | 2000 Buick LeSabre
Oct 21, 2008 | 2000 Buick LeSabre
Oct 17, 2008 | 1997 Buick LeSabre
597 people viewed this question
Usually answered in minutes!