Question about Jeep Cars & Trucks

2 Answers

Engine is moving alot and causing the car to shake. check engine flashes when i step on the accelerator. lacking some power. any ideas?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

  • Contributor
  • 3 Answers

Maybe not running on all cylinders or timing is out,hope this helps

Posted on Oct 31, 2012

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 14,036 Answers

Sound like engine surging lacking enough fuel to run check fuel pressure problem could be faulty fuel pump or faulty fuel pressure regulator.code scan for faulty PCM.

Posted on Oct 31, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 2003 2.5l v6 landrover freelander has recently had a major decrease in power when accelerating and shake at certain speeds exaust has gotten louder has the ecatalytic gone bad


Is the check engine light on / flashing? You may have a cylinder misfire. This will cause lack of power and the engine to shake. If light is on, have the codes scanned to point you in the right direction. If light not on, you may have a problem with the exhaust system getting plugged and not breathing correctly causing high back pressure. Most trained technicians can test drive the vehicle and tell if there is a restriction in the exhaust as well by performing a back pressure test to verify.

Jan 20, 2016 | Cars & Trucks

1 Answer

Will a egr valve cause rough idle


Yes the car won't run properly with a bad EGR valve and will use a lot more gas as well.

Jul 01, 2014 | Oldsmobile Cutlass Ciera Cars & Trucks

1 Answer

2004 Ford expedition check engine soon light is flashing and car shakes hard when stepping on the accelerator


Your car is misfiring. You should not drive the vehicle while it is misfiring. If you want to DIY it you can start with you ignition system. Make sure all spark plugs, plug wires, and ignition coils are secure and in good condition.

Apr 07, 2013 | 2004 Ford Expedition

1 Answer

Misfiring, shaking when in gear, lack of power while accelerating on my 1997 Camaro V6 3800 series. I've replaced alot of stuff already but still can't figure out the problem. Any help would b


tell me what you done is check engine light on go to auto zone they will put a code reader on it for free tell me what codes come of it dont let them sell you anything ok get back to me i can help you im a mechanic

Nov 17, 2012 | 1997 Chevrolet Camaro

1 Answer

We where parked outside an mall and we started up our Honda Pilot 2004 then the car started shaking like if a pipe or a tube was clogged. Then when we started to move The VTM-4 light turned on red aswell...


you may have purchased some bad fuel only. it happens alot. pay attention to the fuel that you purchase as hondas are known for rejection of ethynol based fuel. or you bought bad gas that had water in it. be loyal to the place that you purchase your fuel! if it sounds to good to be true,well you know. the best fuel is 93 octane at the place that you can trust to sell 93octane right? i can't recommend a certain buisness,but oil spills are never good. good luck and thank you for choosing fixya.com.

Jan 13, 2011 | 2005 Honda Pilot

1 Answer

Car violently shakes when I start moving and stops shaking when it kicks into second gear (automatic transmission). It also shakes a bit when coming to a complete stop and it jerks front and back if...


A lack of power or a vehicle running rough can caused the vehicle to "shake" and also a broken motor mount or transmission mount can cause the problem.
If it's running rough it could be because of one of two fairly common problems. One is a leak in the air duct between the air filter and the throttle body. The other is a leak from rubber hoses connecting the intake to the PCV valve at the crankcase causing a vacuum leak. More serious problems such as a misfire from a bad coil pack or a blown head gasket can also cause the vehicle to lose power and run poorly but these are not as common.

Jul 25, 2010 | 2002 Ford Taurus

1 Answer

93 Lumina 6cyl 3.1 engine shaking @ overdrive gear


check your camshaft and crankshaft sensors. When defective, it may cause stalls, misfires, loss of power. Also have check the engine for vacuum leaks. Hopefully this helps!!

Apr 14, 2010 | 1993 Chevrolet Lumina

3 Answers

Would an idle control valve cause a car not to accelerate?


no, idle air control valve is literally to control your idle speed.
what happen when you press on gas? car shakes, RPM goes up, or engine just bogs down?

Mar 09, 2010 | 2004 Infiniti I35

1 Answer

Check engine light illuminated, cruise light flashing; lack of power and "moaning" sound when engaging accelerator


is probably your o2 sensor. measures amount of fuel to oxygen ratio.causing lack of power. depending on v6 or 4 depends on wether you have 2 sensors or not hope this helps,ones by the header pipe and other just behind your catalytic converter on exhaust.

Nov 22, 2009 | 2005 Subaru Legacy

1 Answer

Check engine light flashing


if it shaking it could be suspension. tires bent axel and rim. but that wouldnt cause to lose power...
fuel air spark ratio isnt right. that is just what it sounds like.
ignition time could be off.
in proper fuel adjestment in the carb/ or if fuel injected..
thats a breif idea of what i got from it..

May 29, 2009 | 2002 Chevrolet Express

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

154 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...