Question about Cars & Trucks

1 Answer

I recently had a bumper to bumper now my speedo has stopped working could this be due to the accient or something else

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

  • Contributor
  • 2 Answers

Its most likely to be impact of the accident,try replacing the sensor of the speedometer on the swith box .

Posted on Oct 31, 2012



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Speedo stopped working, abs and brake waning light are on. Stuck in 1st gear. Spoiler stuck up

Try checking for speedo with other problems usually vss (vehicle speed sensor) shot

May 20, 2016 | 2004 Chrysler Crossfire

1 Answer

The speedo in my Vauxhall corsa c has recently stopped working. All other dials still seem to be working fine.

It might be a transmission to speedo cable, or electrical connection. But most likely a broken gear inside the Speedo. You may find this defect affects many of your model. Google your model "clubs" They may have a solution.

May 04, 2015 | Vauxhall Cars & Trucks

1 Answer

Speedo stopped working. Have an audi 90 done 255,000 miles oops

need to check speedo sensor or drive gear in gearbox is connected,may have been disconnected after work was done,or the sensor has packed up,unlikley to be speedo itself if its been ok in the past

Oct 22, 2009 | Audi 90 Cars & Trucks

1 Answer

98Civic speedo malfunctioned a bit, now fine, but engine light on

you can drive the car

should have the code read at a shop

possible cause is speed sensor problem???

Jul 01, 2009 | 1998 Honda Civic

1 Answer

Speedo interment not working and Odometer lites diming

possible short in wiring, dash panel, or sending units

Jun 25, 2009 | 1995 Chevrolet Cavalier

1 Answer


Well, it sounds like the loose cable goes back into the transmission -- that would be your speedometer cable.

This cable would not cause electrical problems, but something pulled it from the transmission and may have, at the same time, pulled an electrical wire loose. I would check the transmission and surrounding area for loose wires.

May 28, 2009 | 1987 Ford Ranger

1 Answer


I expierenced the same type of problem recently, I found through a process of elimination that the problem was in the electric shift motor assy. there is a bumper stop on the electrical switch portion of the shift motor, it was completely deterioated and gone. i don't know what type of material is was made of because all i found were shavings. I made a new bumper assy. out of a high quality piece of neopreme and slid it on, (tight fitting, with glue), and note it must be the correct size to operate the internal switching. I have had no trouble since and it seems to operate quieter and smoother than previously. I can't say this is your problem, but I do believe all of these bumpers are going to fail due to the material used in this application.

Jul 12, 2008 | 1993 Ford Ranger SuperCab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14479 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides