Question about Toyota Cars & Trucks

1 Answer

Troubleshoot distributer distributer

Posted by on

  • yadayada
    yadayada Oct 31, 2012

    What is year,model Toyota and exact problem.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 14,381 Answers
Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why won't my car start after replacing distributer?


have you checked tthe timing and also make sure the shear pin on distributer gear is not broke

Dec 01, 2014 | 2004 Nissan XTerra

1 Answer

How to fit a morris minor distributer


Hi The distributer should have an offset drive so it can only go back in the same way it came out,
As to no spark:
Check the contact points
Condenser
Tiny earth wire from breaker plate to distributer body.
Coil
Ignition supply and ballast resister.

Morris cars originally had a positive earth system on the battery if you change to negative earth you must check the coil connection the Neg - terminal on the coil goes to the distributer and the Pos+
is ignition supply

Apr 16, 2014 | 1969 Morris Minor

1 Answer

Leak under distributer


The most common cause is the heater hose coming off the head, below and behind the distributer. Usually the distributer is leaking oil, which gets on the hose and damages it. If you don't fix the oil leak, which could be the distributer "o" ring, (inexpensive) or the distributer shaft seal, (expensive) cut a piece of the old hose and use it to protect the new hose from the oil.

Apr 12, 2014 | 1998 Honda Odyssey

1 Answer

Should my distributor base (not the distributor itself) move back and forth by a 1/4 inch? It's a new cap but not the base for it, which is where the most movement is coming from.


check the bolts bolting the distributer down. shouldn't be any movement from either the distributer itself or the cap. check all bolts and make sure the distributer isn't cracked. i had a chevy truck with a cracked distributer and it moved the same way.

Oct 27, 2013 | Cars & Trucks

1 Answer

How to put in a distributor in a 88 chrysler conquest


Make sure the timing mark on the harmonic dampner is at tdc. drop the distributer in the hole so as the distributer gear engages with the cam gear , it will rotate slightly. You want the rotor to end up lined up with the number one spark plg wire position on the distributer cap. If the car doesn't fire and you are sure you have power to the distributer, then you will need to pull the distributer out and turn the rotor 180 degrees and reinstall. The motor should then fire.

May 12, 2011 | Chrysler Conquest Cars & Trucks

1 Answer

What are the steps to follow when youre going to install a 1991 Toyota Camry 2.0l Distributor,


Take the screws out of distributer cap, mark exactly where the rotor is pointing with paint pen on distributer cap and distributer. Loosen bolts holding down distributer. Lift out distributer after you unplug electrical wires. Place new distributer in place making sure rotor is pointing to exact same place where the old one pointed. Replace distributer cap and electrical wires and your done, try to start the car.If car starts your ok.If it doesnt start andd backfires it means rotor is in wrong place,take back out and restab it.good luck

Sep 25, 2010 | 1991 Toyota Camry

1 Answer

Does the 2006 dodge magnum have more than two sets of fuses?


THERE ARE JUST TWO.
Power Distribution Centers/FUSE BOXES
1. Front Power Distribution Center
A power distribution center is located in the engine
compartment. This center contains fuses and relay

2. Rear Power Distribution Center
There is also a power distribution center located in the
rear compartment under the spare tire access panel. This
center contains fuses and relays.
Opening The Access Panel
Rear

Jun 04, 2010 | 2006 Dodge Magnum

1 Answer

I need a fuse box diagram for a 1992 Ford Ranger. Any idea where I could find one?


owner manual.

here's the big ones for 1994 ranger. all i have
Section 18-01: Wiring and Circuit Protection 1994 All Ranger, Explorer and Aerostar Vehicles Workshop Manual
SPECIFICATIONS Specifications

High Current Fuses And Circuit Breaker — Ranger 2.3L, 3.0L And 4.0L
Circuit Size Location Electric Fuel Pump 20 Amp Fuse Power Distribution Box Headlamp Switch Feed 40 Amp High
Current Fuse Power Distribution Box #36 Circuit Alternator Output #2 15 Amp Fuse Power Distribution Box Fuse Panel 60 Amp High
Current Fuse Power Distribution Box Power Locks 20 Amp High
Current Fuse Power Distribution Box #38 Circuit Alternator Output #1 12 Ga Fusible
Link Integral with 14305 W/A Powertrain Control Module and Power Relay 30 Amp High
Current Fuse Power Distribution Box 4x4 Electric Shift 20 Amp High
Current Fuse Power Distribution Box Ignition Switch Feed 60 Amp High
Current Fuse Power Distribution Box High Beams and High Beam Indicator 22 Amp C.B. Integral with Headlamp Switch Front Wiper and Washer 6 Amp C.B. In Fuse Panel Power Windows 30 Amp C.B. In Fuse Panel Cigarette Lighter, Flash to Pass and Power Lumbar 20 Amp C.B. In Fuse Panel


29af2f7.gif
e4cf291.gif

May 13, 2009 | 1992 Ford Ranger

1 Answer

1985 4100 distributer shaft problem


Sounds like the clip came off the shaft and it fell inside bock. Get a new distributer and get number one cylinder up on compression stroke and drop distributer in pointing rotor at number one on distributer cap.

Jul 05, 2017 | 1985 Cadillac Eldorado

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...