Question about Peugeot Cars & Trucks

1 Answer

Heater resistor on 806 - Peugeot Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Peugeot Master
  • 76,132 Answers

The blower motor resistor is located right next to the blower motor under the dash.

Posted on Oct 31, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i change the heater matrix on a peugeot 806


Clamp the hoses to the matrix or drain the coolant but you will still get a bit off leakage when you disconnect the hoses in the footwell
remove the glovebox door and the panel below and you can then see the blower housing

Jan 10, 2017 | Peugeot Cars & Trucks

1 Answer

2004 canyon no voltage at heater resistor


The resistor provides the ground circuit for the blower motor. So you would need to have power at the blower motor first. Grounding the motor or resistor should make the motor run.
The blower motor gets power from a 30amp fuse which gets power from a relay.

Jan 18, 2014 | 2005 GMC Canyon

1 Answer

Heater fan resistor


Remove the Glove Box assembly. The heater fan and the heater fan resistor are behind the glove box. It is on my 90 4-cylinder Camry.

Oct 14, 2012 | 1990 Toyota Camry

1 Answer

Remove heater control switch


Before removing the heater switch on this 2006 citroen hdi I would first have the blower motor checked and the most common reason for this and other blower problems would be the blower resistor.

Your blower works on and off at times, first locate the blower motor and the resistor. the blower motor is located on the heater box, look under the pass/side of the dash, you may have to remove under dash cover to see blower.
When you have located the blower now look to the side on the heater box, there you will see a connector plug, it plugs into a connection on the heater box, this will be the resistor, the resistor slides into heater box and the end of it bolts to box to hold it in place and then the connector plugs into it, if you can not locate it then follow wires that plug into blower , follow wires back they will lead you to resistor,
next time blower does not work wiggle connector to resistor and see if blower turns on, if it does then resistor is the problem. also unplug resistor plug at resistor and check for any burning of connectors at plug and inside resistor.

I would bet its a bad resistor or the plug is brunt due to high draw from bad connections, if plug has burn damage to connectors then replace the plug along with resistor.

Jul 08, 2012 | 2006 Citroen C5 HDi

1 Answer

The heater fan on my 1993 f-350 has become really loud. I only have hi speed which I understand may be a resistor issue but how do I remove the fan and motor assembly to inspect it?


A heater blower motor resistor is an electronic device with three or more progressive resistors that allow the heater blower motor to operate at slower speeds. The highest speed of the heater blower motor is not controlled by the resistor, so when the resistor fails, the fan will often work on the highest speed setting, but not the lower speeds.
To resistor is generally located under the dashboard and under the hood, near the blower motor . The resistor's electrical connector is disconnected, the resistor is removed and the new resistor is installed. On some vehicles it may be easily accessible, and on others it may take partial dashboard removal to replace the resistor.
Look under the hood, generally the wiring for the Blower resistor is attached to the wiring to the blower motor itself
It's inboard & below the motor, near the accumulator. You can see it standing beside the passenger fender. it's the off-white connector behind the L heater hose above the vacuum reservoir & the white WARNING sticker

Feb 12, 2011 | 1993 Ford F350

1 Answer

How do you replace the blower motor speed control resistor on a 1998 F-150 Ford?


located on passenger side of truck in cab under glove compartment.remove plug to resistor. remove two screws that secure resistor to heater housing. remove resistor, rreplace with new resistor. inser screws and replace plug also make sure fuse for heater is ok.

Jun 13, 2010 | 1998 Ford F150 Regular Cab

1 Answer

Fuse diagram for a 98' E-150 van specifically for heater fan


owner manual will tell you fuse layout. If you have only high speed, you have a bad resister. 4 wires.

Resistor —Heater Blower Motor Switch Removal
  1. Remove the battery (10655) ; refer to Section 414-01 .
  1. Remove the battery tray.
    1. Remove the screws.
    1. Remove the battery tray.
  1. Disconnect the heater blower motor switch resistor connector.
  1. Remove the heater blower motor switch resistor (18591).
    1. Remove the two screws.
    1. Remove the heater blower motor switch resistor.
---------------------------------

0f120f5.gif

Feb 26, 2010 | 1998 Ford Econoline

1 Answer

How to find the heater resistor for a nissan


the majority of heater resistors are on the heater box under the passenger ide of the dash, on some very few models it is part of the actual ac control panel

Oct 28, 2009 | 2003 Nissan Altima

1 Answer

Heater wont work a fuse maybe? some how I doubt it. the rear window heater works. fan dead perhaps? no fan at all. not sure about heat.


Hi: Sounds like a possible heater resistor problem. First check to see if heater fan working, unplug heater under hood and put 12 volts to it from the battery with a wire (single black wire running to back of fan). If works then problem probably the resistor which is located on the fan housing under the hood to the right of the fan. The resistor has wires to it running from the heater fan, 2 - 7mm screws holding resistor in place, check resistor to see if any of the 3 elements are melted off, if so replace. Note: Rear window defrost has nothing to do with heater fan. Hope this helps...

Feb 26, 2009 | 2002 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

scj103

Level 2 Expert

81 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...