Question about Honda Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Sounds like a short to ground. Get a wiring diagram and trace the circuit that keeps blowing the fuse...Look for burnt or bare wires...Good Luck!
Posted on Oct 08, 2008
Fuses nearly always blow because of a bad earth. The switch only needs to short for a moment and the fuse will blow.
See if you can find a replcement swtich from a local breaker's yard or ebay and go on from there.
Posted on Apr 13, 2009
That leaves only two probablities: 1) a possible short in the wiring to the alternator, or 2) the alternator itself, particularly the voltage regulator inside it. Voltage regulators can be changed, but virtually nobody does that. Since you have to take the alternator off to do it, most people simply replace the alternator as a unit.
I would take a good look at the wiring to see if there are any worn-bare places. I doubt that that's the problem, but it could be. There is also a fusible link (flat single piece of metal which melts under too high a charge) in SOME models of your car in the wire that goes from the starter solenoid to the alternator (I doubt that your car has one since it probably would have blown rather than the fuse you indicated).
Next (you won't be delighted by this) change the alternator. It might look difficult, but if you take your time and you have or can borrow the appropriate wrenches, you can do it.
Detach the negative cable from the battery.
Mark and detach all of the connectors from the alternator (do not trust your memory).
Test the tension of the drive belt (you’ll have to get it roughly back to that tension when you change the alternator)
Loosen the alternator adjusting bolt (the one that goes through the oblong hole so you can tighten the alternator against the belt).
Loosen the pivot bolt (the only other bolt holding the alternator in place).
Detach the drive belt (push the alternator away from it, but do not take the belt off, unless you have a diagram indicating how it goes on).
Remove the adjusting bolt and the pivot bolt, then the alternator should be free.
Take the alternator with you when you go to get a replacement (some place like Autozone would be okay. Ask for a rebuilt alternator (they are cheaper and usually reliable).
Make sure the rebuilt alternator has the same connections as the old one. Look at it carefully.
Alternators usually don’t come with the pulley. Have them put your old pulley on the alternator you are buying.
Take it home, put it in, tension the belt to approximately where it was. Start the car.
I hope that this helps you.
Posted on Nov 25, 2009
Testimonial: "Thank you so much for taking your time to help me. I am on the path so I hope it works."
Tips for a great answer:
Oct 02, 2014 | 1997 Honda Civic
Jul 03, 2012 | 1989 Honda Civic
Nov 25, 2010 | 1998 Honda Civic
Mar 12, 2010 | 1996 Honda Civic
Mar 10, 2010 | 2000 Honda Civic
Nov 25, 2009 | Honda Civic Cars & Trucks
Sep 01, 2009 | 1995 Honda Civic
Apr 13, 2009 | 2001 Honda Civic
Oct 08, 2008 | 1996 Honda Civic
77 people viewed this question
Usually answered in minutes!