Question about 1994 Dodge Intrepid

1 Answer

Blower motor 94 dodge intrepid inop

Where is blower motor located and how do I replace it?

Posted by on

  • ojoe86 May 11, 2010

    are you sure its not the blower motor resistor? it can cause the same prob...

  • John Jon May 11, 2010

    Why has it quit completely or do you have one or two fan blower speeds remaining??

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

1.disconect battery
2. remove lower right undre panel silencer duct
3. remove the blower moter connector from the resistor block
4. squeeze the blower moter wiring gromment and push the gromment throw the blower moter housing cover
5. remove blower moter housing
6.romove the screws holding the blower moter down
to put back on do the steps back werds

Posted on Apr 17, 2009

  • empire4209 Apr 17, 2009

    1.disconect battery

    2. remove lower right undre panel silencer duct

    3. remove the blower moter connector from the resistor block

    4. squeeze the blower moter wiring gromment and push the gromment throw the blower moter housing cover

    5. remove blower moter housing

    6.romove the screws holding the blower moter down

    to put back on do the steps back werds

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the blower motor located


      The heater blower motor resistor is located underneath the dashboard in the heater/AC compartment.

      Heater Blower Motor Resistor Replacement - YourMechanic

      https://www.yourmechanic.com/.../heater-blower-motor-resistor-replaceme...
    Feedback

    Replacing A Blower Motor That Doesn't Blow - YouTube

    ? 2:29
    https://www.youtube.com/watch?v=4edK8fa-Ypg
    Mar 9, 2011 - Uploaded by Scotty Kilmer
    Scotty Kilmer, mechanic for the last 46 years, shows how you can replace a broken blower motor in your car ...

    Blower Motor Replacement and More - YouTube

    ? 13:19
    https://www.youtube.com/watch?v=2p5QYd58sTk
    Jun 12, 2012 - Uploaded by talyn875
    Do not try this at home. For HVAC professional use only. This video shows yours truly changing a blower motor ...


Feb 09, 2016 | Cars & Trucks

1 Answer

My heater blowers dnt work and i need to knw where i can locate the resister blocks for my heater blowers so i can ghange them


Its located under dash,or near glove box.

The dash panel lower side has to be out.

HEATER BLOWER MOTOR


Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is working.


It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced.


=======

For blower motor testing and replacing, check the link below: ----

Blower motor Testing/replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------

These will help.

Thanks.

Nov 28, 2012 | Cars & Trucks

2 Answers

98 century heater blower motor resistor location


look under the passenger side of the dash. There will be a plastic trim panel that will need to be removed. Once its out of the way you will see the blower motor. The resistor will be just to the drivers side of the blower motor.

Nov 15, 2011 | 1998 Buick Century

2 Answers

My blower motor only works on 1 & 2 & 3 speeds dont work on 4 & 5. I was told to buy a blower motor. Need to know where this is located to replace on my 2005 Chevrolet Trailblazer


If your blower works at some speeds and not others, the likelihood of the blower motor needing to be replaced is low. The more common problems would be either the switch or the resister that regulates the motor speed. The resistor is usually located in the air duct under the dash.

Jun 17, 2011 | 2005 Chevrolet TrailBlazer

1 Answer

1989 Mercedes-Benz 300-Class


There is a Blower Motor Relay in that system. It is located behind the center of the instrument panel, on connector i27.If it's not the faulty relay, then it is the blower motor .

The blower is controlled by the blower motor in the unit.The blower motor needs to be checked and replaced. The blower motor. The brushes are probably worn and the brushes, or the motor, needs to be replaced. It is located under the front cowl. Check out.Thanks.

Jul 23, 2010 | 1989 Mercedes-Benz 300-Class

1 Answer

Replace switch but the heat won't turn on.and it's not the fuse..95 jeep cherokee sport


Most likely the blower motor,it has gone out,some times,not always,you can bump the blower motor with your hand,and it will start to run,or it will try,if so,replace the blower motor,otherwise,check the voltage at the blower motor,if it has voltage,replace the blower motor,if it has no voltage at the blower motor,then replace the blower relay,located near the blower motor.

Jan 09, 2010 | 1995 Jeep Cherokee

1 Answer

Access location of front heater blower motor


It located behind the dash on the Passenger side.
And yes you can easily do this yourself saving you alot of money! Have you first checked the Front Blower Motor Relay located in the IPM Relay and Fuse Box located inside the engine compartment? Remove the cover. The location identification is located on the back (inside) side of the Cover. You can switch-out a similiar size and shape Relay and check the operation. If the Blower now works then the Relay was bad and needs to be replaced. The Motor and Resistor cost alot more money than the Relay.
Before we do this: What is the Motor doing? Nothing? OR DOES IT WORK ON HIGH ONLY? If the Motor works on High only then it is not the Motor but the Blower (Fan) Motor Resistor. This is located near the Motor. It is identified by 3 to 4 wires going into it. Remove the two (2) retaining nuts/metal screws and remove. Disconnect the wiring connection and replace. I don't want you to replace the Motor and find out you wasted your money when it was the Resistor.
It could be also both the Motor and the Resistor.
Direction to remove/replace the Blower Motor:
1. Disconnect the Negative cable from the Battery and wait two minutes. This is to de-energize the Air Bag System which you will be working near.
2. Remove the Glovebox.
3. Remove the four (4) hex screws holding on the Blower Motor Cover.
4. Remove the three (3) nuts/screws holding in the Blower Motor. Make sure you support the Motor, as it will drop down.
5. Disconnect the electrical connection.
Installation is the reverse of the above.
Check operations before putting the Glove Box Back on.

Jan 09, 2010 | 1999 Plymouth Grand Voyager

2 Answers

Where is the hvac blower motor located? If you replace the blower motor do you need to replace the resistor too?


Dear Blower Motor Searcher,
The blower motor is located under the dash on the pass side in front.Open the pass front door , get on your knees, and look up under the dash, you will see the flying saucer looking object, that is the blower motor.Right next to it is where the resistor is located, and yes it is recomended that you replace the resistor also because that is where the main current flows thru to get to the blower motor.That actually controls the current of the motor, which controls the speed of the motor, low, med, high, recirc, etc....any other questions get back to me, TX!! HOPE I COULD HELP!!!

Nov 20, 2009 | 2003 Pontiac Aztek

1 Answer

Follow up question for 2000 Saturn Blower Motor Issue


The thermistor is in the winding of the blower motor. Letting it cool down will let it run, but probably not long. the thermistor is not replaceable, replace blower motor

Feb 27, 2017 | 2000 Saturn SL

Not finding what you are looking for?
1994 Dodge Intrepid Logo

551 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...