Question about Cars & Trucks

Open Question

How do I remove the starter on a ford transit 2.4 duratorq

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Diagram of Location of a Starter Motor on Ford Transit 2002/2003

i have a 2001y reg transit tipper and i think the starter motor is going when i go to start it like grinds then some times it starts perfect

Posted on Jan 25, 2009

Ad

SOURCE: I wish to adjust the idle tickover speed a wee bit

First ensure that the throttle interior is really clean, a surface layer of grime can upset the ECU's ability to meter and govern the air entering the engine. If the throttle body interior is found to be really oily and dirty check on the idle air control valve and make sure that it too is cleaned up. Next put the ignition switch in position 2 (on, but no start) and depress the accelerator fully and release. If there is an issue with the throttle position sensor this procedure can help the ECU relocate the throttle plate position. Start the engine and if it is still hunting locate the air mass meter (AMM) on the air ducting immediately next to the air filter and disconnect the electrical connection. Does this remove the hunting aspect?... the rev speed might change but for the moment concentrate on the evenness of the tick-over. If the idle is even when the AMM is disconnected but hunts when connected then look at replacing your AMM. Try spraying the AMM with no residue electrical cleaning spray to see if this improves matters.

Posted on Dec 02, 2010

jasonburchel
  • 24 Answers

SOURCE: ford transit starter motor removal

disconnect battery earth leadlocate starter motor (by gearbox and engine)start undoing boltspull out starter motorreverse the steps to put back in

Posted on Jul 08, 2012

Testimonial: "Good thinking about following lead.I shall go and try that method "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to acces the 4 nuts on a ford transit starter motor as u tube suggest cuting a hole in the body of my van ,are there special tools to do it


which mark version /model /year transit van do you have

most starter motors for the ford transit diesel or petrol
show pictures as only two bolts to hold them on
between exhaust and motor/gearbox housing

Ford Transit Starter Motor Starter Motor For Sale New and Used

this one with three bolts may be a bit of a problem


FORD TRANSIT MK3 MK4 MK5 2.5 D Di TD 2.5 DIESEL NEW RMFD STARTER MOTOR 86-00


26387587-dgghzwtl0kutpuyxiasdr24z-2-0.jpg

Dec 06, 2016 | Ford Cars & Trucks

1 Answer

Ford transit 2.4 duratorq won't switch on


I am sure depends on year they have a fuses earth strap run a jump lead from Earth on battery to a good earth on body and try that

Jan 24, 2015 | Ford Cars & Trucks

1 Answer

Ford transit starter motor removal


disconnect battery earth leadlocate starter motor (by gearbox and engine)start undoing boltspull out starter motorreverse the steps to put back in

Jul 08, 2012 | Cars & Trucks

1 Answer

Deisel ford transit, turn the key to start and will usual start, on occasions turn the keyand engine does not turn over but get a clicking sound from under the bonnet, will start with a push or jump start...


titen the cables at batt posts and maybe at the starter motor--cud be corrosion also--the starter may be a lemon--ask dealer or go online for any service bullitins

Jun 14, 2011 | 2011 Ford Transit Connect

1 Answer

I wish to adjust the idle tickover speed a wee bit on a 2007 Ford Transit 2.2 Duratorq engine. It is currenlty ticking over at approx 800 rpm and is hunting at this rev. If I could raise it a wee as I do...


First ensure that the throttle interior is really clean, a surface layer of grime can upset the ECU's ability to meter and govern the air entering the engine. If the throttle body interior is found to be really oily and dirty check on the idle air control valve and make sure that it too is cleaned up. Next put the ignition switch in position 2 (on, but no start) and depress the accelerator fully and release. If there is an issue with the throttle position sensor this procedure can help the ECU relocate the throttle plate position. Start the engine and if it is still hunting locate the air mass meter (AMM) on the air ducting immediately next to the air filter and disconnect the electrical connection. Does this remove the hunting aspect?... the rev speed might change but for the moment concentrate on the evenness of the tick-over. If the idle is even when the AMM is disconnected but hunts when connected then look at replacing your AMM. Try spraying the AMM with no residue electrical cleaning spray to see if this improves matters.

Dec 02, 2010 | Ford Transit Connect Cars & Trucks

1 Answer

Should i raise the vehicle slightly to remove the starter motor or struggle underneath(im not fat)its a transit connect not focus.how many bolts and where are they.what size are they.how long to do it.


Yes, raise the car, put some jack stands under there. Get a piece of cardboard to lay on. 2 bolts and 1 or 2 wires. The bolts are 14 mm and about 2 1/2 inches long. Not a hard job, Some starters have the bolts going up and some in the end. Pull the hot lead off the battery before starting.

Feb 24, 2010 | Ford Focus Cars & Trucks

2 Answers

Diagram of Location of a Starter Motor on Ford Transit 2002/2003


i have a 2001y reg transit tipper and i think the starter motor is going when i go to start it like grinds then some times it starts perfect

Nov 24, 2008 | Ford Festiva Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

212 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...