Question about Jeep Cars & Trucks

Open Question

How do I replace a starter in an 07 Jeep Commander?

I've heard the starter is fairly easy to replace, but that the location is in a tricky spot. Where is it located and how should I replace it?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
pal03246
  • 726 Answers

SOURCE: Starter replace

Your starter is below the air box, where air filter is. Remove air box and you will se the starter. Unplug battery. Remove nut (with 12mm wrench) which is connected to the starter, Nut is hidden under a rubber boot to prevent shorting out. unplug a single wire connector, which comes out of the starter solenoid. Starter is beeing held by 2 bolts. Remove 2 bolts, which you will be able to see and take out starter. Reverse procedure to install new starter. Reconnect battery.Start vehicle. The whole procedure should take under 1.0 hours.

Posted on Jul 27, 2008

Ad
  • 1 Answer

SOURCE: location of oil dipstick

The oil dipstick is located at the back of the engine.  If you look at the engine from a top view it is located at about 11 o'clock.  It's black.

Posted on Dec 22, 2008

  • 6982 Answers

SOURCE: im trying to locate the starter for 1994 jeep grand cherokee , see if its easy to replace, and also the location of the starter relay

starter relay is in power distribution center near battery. don't know which engine you have, but if you flollow the positive cable on the battery, it will lead you to the starter. Most are not difficult to replace, depends on how much experience you have. One tip...dont overtighten wire connections on starter the solenoid cover is plastic and can break.

Posted on May 07, 2009

  • 19 Answers

SOURCE: Can't locate air filter...

1. Loosen clamp (1) and disconnect air duct at air cleaner cover (3). 2. Pry over 4 spring clips (5) from housing cover (spring clips retain cover to housing). 3. Release housing cover (3) from locating tabs on housing and remove cover (3). 4. Remove air cleaner element (filter) from housing.
cecdf0c.jpg

Posted on Jun 30, 2009

  • 22 Answers

SOURCE: Where is my starter located on my 2001 Nissan

usually i is under the engine

Posted on Aug 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My jeep would not start or even turn over but radio,lights all work


Any clicking noises? My first thought is lithe starter has failed. Typically if all the other accessories are working and the starter doesn't when you turn the key it's likely the starter. Usually an a single click is heard everytime you turn the key to the start position. If you heard a series of rapid clicks when you try to start you likely have a weak battery. A jump start may get you going.

Apr 11, 2013 | 2006 Jeep Commander

1 Answer

I have a 2000 Grand Cherokee Limited. the drivers rear turn signal isn't working. i've checked/replaced the bulb, bulb holder, whole taillight assembly, and turn signal switch.


This happened to me to. Eventually, the left turn signal didn't work at all, but luckily, there was an easy solution for this.
Replace the Flasher Relay, located in the fuse panel under the driver's side dash; it's fairly high up there as well. You can get the part at any auto parts store for about $35.


I hope this helps....Good Luck!

Feb 17, 2013 | 2000 Jeep Grand Cherokee Limited

1 Answer

I've gone thru 3 starters in less than a year. What can cause this to happen?


Where did you get these starters from? Many rebuilts from places like Autozone are very low quality. Stay with Jeep factory rebuilts or ACDelco. They are the best choice.

Oct 08, 2012 | 2006 Jeep Commander

1 Answer

Can locate the fuse for heat seat for 07 jeep commander


its in the FSM book,,
posted over 300 times here.
here it is again, chapter 8w covers every wire and fuse.
totally, WK jeep, that be it. 8w page 63-8 see it, i do...
cb 8, (circuit breaker 8) in the JB.
http://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#service

Oct 22, 2011 | 2006 Jeep Commander

1 Answer

Where is the speedometer cable located on a 07' jeep commander 4.7l v8 on the transmission? Please be specific as possible. Thank You


Your Jeep doe not have a speedometer cable. The speed is calculated by the PCM ( vehicle computer) by input values that are received from the vehicle speed sensor. This issue is most likely not repairable by the average person without the proper scan tool required to do so.

Jun 01, 2011 | 2006 Jeep Commander

1 Answer

Starter repair estimate 2006 jeep commander


Check here for parts replacement and "How to": Jeep/Commander/Replacement/Starter

Hope helps (remember rated this).

Jul 07, 2010 | 2006 Jeep Commander

2 Answers

2006 Jeep Commander...cant find the starter???


iTS LOCATED AT THE BOTTOM OF THE ENGINE,AT THE REAR ON DRIVERSIDE,IN FRONT OF TRANY, HRERS A DIAGRAM TO SHOW YOU. HOPE THIS HELPS.3539ac6.gif

Mar 16, 2010 | 2006 Jeep Commander

2 Answers

Jeep commander clicks once and won't start. It is


The starting issue is the same I had on my 2005 Grand Cherokee. The wire coming from the ignition (key area) to the Starter the connection is bad. The shop replaced the lead and it is perfectly fine... it cost $70. I dont know the techincal terms.. but it was easy to fix- the problem is water and junk gets splashed up by the front tire and corroded the wire into the sarter.... that's all it was.
Good luck.

Sep 05, 2009 | 2006 Jeep Commander

4 Answers

2007 Jeep Commander will not start


Check the battery cables, then go to the starter relay, then the starter, (If the lights are bright when you turn them on)

Aug 01, 2009 | 2007 Jeep Commander Rocky Mountain

1 Answer

Will not start but equipment panel well lit good


tap starter with hammer if no avail change starter.

Mar 30, 2009 | 2006 Jeep Commander

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

119 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...