Question about Cars & Trucks

Open Question

What is ignition coil resistance for a 1995 land rover discovery

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Landyman
  • 89 Answers

SOURCE: 1995 Land Rover Discovery 3.9L V8 Not Starting

Check the distributor position when the engine is turned to TDC , the rotor should be facing close to no. 1 spark plug lead.Try spray some quick start spray in the inlet and see if it takes , if so then your fuel return is dumping too much fuel.The older pressure regulators were adjustable by a small screw next to the diaphragm.

Posted on Dec 14, 2008

Ad
  • 275 Answers

SOURCE: 2004 land rover discovery, ignition

it sounds like your starter motor is faulty. first make sure the battery is fully charged, then place a screwdriver between the contacts of the solenoid on the starter motor, if it again just clicks, then you need to repair or replace the starter motor.
hope this helps

Posted on Sep 11, 2009

  • 6 Answers

SOURCE: no power to fuel pump and

Yes there is. On the firewall, right side.

Posted on Jan 06, 2010

  • 149 Answers

SOURCE: transfer case oil change- 1999 Land Rover Discovery II

No need for a diagram, to drain the oil, there's a drain plug on the bottom of the transfer box, under the handbrake drum. To fill, the fill plug is about in line with the centre of the handbrake drum and to the left. I think both plugs are 1/2" square. Fill to overflow with Texaco Multi-Gear 75W/90R. Takes about 2L or so.

Posted on Feb 25, 2010

  • 1 Answer

SOURCE: WHERE IS THE FUEL FILTER LOCATED ON LAND ROVER DISCOVERY 2000

LAND ROVER DISCOVERY II DONT HAVE FUEL FILTER, ONLY HAVE PRE FILTER IN THE FUEL PUMP

Posted on Apr 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Land rover discovery 2000 cutting out


Check your ignition coil packs (behind the intake) and check your fuel pressure. Also check / change spark plugs and wires.

Nov 07, 2015 | 2000 Land Rover Discovery

1 Answer

Im looking for an on-line firing order diagram for a 1997 land rover disco with a 4.0 v-8


Telephone: Fax: VAT Registration No.:
Notes Specified value Measured value
Ignition system
Ignition coil Make Bosch
Ignition coil Type 0 221 122 392
Ignition coil supply voltage + with ballast V 11,0
Primary resistance Ohm 0,67-0,82
Firing order 1-8-4-3-6-5-7-2
Distributor (ECM) Make Lucas
Distributor (ECM) No. 42583A
Contact breaker gap/trigger air gap mm 0,20-0,35
Cylinder layout

Manufacturer: Land Rover Model: Discovery (90-98) 3,9 Engine code: Output: 134 (182) 4750 Tuned for: R-Cat Year: 1994-98
© Autodata Limited 2007 14/05/2011 V6.410-

8 7
6 5
4 3
2 1
looking from front of disco

May 14, 2011 | 1997 Land Rover Discovery

1 Answer

Spark plug location on ignition coil 2003 land rover discovery II


If you have individual cylinder coil pack, remove the coil pack and the spark plug will be under it. There is a spark plug boot on the bottom of the pack that plugs directly onto the spark plug.

Jan 29, 2011 | Land Rover Discovery Cars & Trucks

1 Answer

Default code P1451 Land Rover Discovery II


The code P1451 on a Land Rover is "Leakage Detection Module Motor power stage error Drive cycle A:Signal out of range - above maximum". This is an OBD-II diagnostic system code. As far as I know, a 1995 Land Rover Discovery does not use a OBD-II system. Is it possible that this rover is a later model year

Oct 11, 2009 | 1995 Land Rover Discovery

1 Answer

No spark from coil


if you have an imobiliser fitted check it is working,some of them allow engine to turn but disable ignition circuit.
next step is to get someone to try to start it in the dark while you watch-often can be a short on the top of the coil to one of the LT terminals.
hope this helps

Jun 13, 2009 | 1995 Land Rover Discovery

1 Answer

1995 Land Rover Discovery WHERE are fuel filters servicable? I need o locate and change these of possible - Rover is not starting in a rural area and am working on it myself


The fuel filter is mounted to the frame just ahead of the right rear tire. You can see it through the wheel well. The fittings are very likely to be frozen so I would soak them with some penetrating oil before you try to loosen them. if it is not starting however, I would focus more on the ignition system, the ignition module near the coil in the front left side of the engine compartment may be bad.

Mar 19, 2009 | 1995 Land Rover Discovery

1 Answer

LAND ROVER DISCOVERI 1995


The radio codes are only available from the dealer, you will need to goto your nearest dealer with your registration, they will type your vin# in there system and give you the code.
hope this helps

JPTCAT

Aug 21, 2008 | 1997 Land Rover Discovery

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...