Question about Jeep Cars & Trucks
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
P0700 means there is a transmission fault code in the transmission controller. Since the transmission controller doesn't have a light attached, it tells the engine controller to turn the light on using this code. You'll have to access the transmission controller to further diagnose the problem.
Posted on Jun 14, 2009
Every morning at lunch time and evening my jeep won't start. It doesn't grind but the electrical goes crazy. After a couple of trys it finally starts. Help
Posted on Aug 20, 2009
There are two parts to it, a voltage resistor, and the EL panel itself.
You need to remove the console first. There are 2 screws under the front rubber pad, two under the cup holder, two in the bin. Remove those six first, take the storage bin out, then slide the rear cupholder out, remove the two screws under the cup holder, and one in front of it.
There are a total of 6 flat screws, and 3 self tapping screws you have removed.
Put the parking brake on, shift the tranny to N, and the transfer case to the middle position if equipped.
Remove the entire console. Slide the shifter beezel as far up vertically as you can. There are 4 clips you ned to remove to do it.
You will see a blue and black wire running into the back. Follow those wires to the resistor. You will see a transparent EL panel attatched to the resistor by two clips.
Usually, one or both of these clips has come loose, causing the light to work intermittantly. Clip them back on, and turn on the headlights to confirm that the light works correctly now.
Re-install everything in the opposite order.
Posted on Oct 11, 2009
Implausible fuel volume is the code,but it most likely was set from a bad ignition switch.It has to do with the malfunction of the switch,really setting a false code,and there might be another one also,but the ignition switch will correct the problem.
Posted on Jan 22, 2010
Tips for a great answer:
Sep 18, 2012 | 1999 Jeep Grand Cherokee
Sep 30, 2010 | 1999 Jeep Grand Cherokee
Apr 16, 2010 | 1999 Jeep Grand Cherokee
Mar 05, 2010 | 1999 Jeep Grand Cherokee
Oct 23, 2009 | 1999 Jeep Grand Cherokee
Oct 07, 2009 | 1999 Jeep Grand Cherokee
Sep 25, 2009 | 2004 Jeep Grand Cherokee
Aug 01, 2008 | 1993 Jeep Grand Cherokee
May 29, 2018 | Jeep Cars & Trucks
57 people viewed this question
Usually answered in minutes!