Question about Cars & Trucks

1 Answer

Where is the oil pressure switch located on a 202 monte carlo ss 3800

Need to know where the oil pressure switch located on a 202 monte carlo ss 3800 engine ?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 2,101 Answers

It is just above the oil filter. it is easy to see if you pull off the right front tire

Posted on Oct 31, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

judd0081
  • 334 Answers

SOURCE: I have a 2000 monte carlo ss 3800 series.

The problem might be your Vats security system. This causes the car to either "not start" or "shut down" while running, or start for 5 seconds and then die. (depending on the system) If the security light flashes, i guarantee that this is what the problem is. 1st trick, (if not starting) turn the key forward 2 clicks till right before it would normally start, leave like that for 10 minutes. ( no less ) After 10 minutes, turn key back then forward and your car might start. I did this in my regal for more than a year.

Cheap fix: Bypass the chip in your key. Temporary, but effective.
----- http://vats.likeabigdog.com/


Never worry again fix: Bypass the whole VATS/Passlock/passkey I or passkey II system entirely. Literally take it out, and throw it away. I just did this in my Regal. Took about an hour. Took longer to find the thing than it did to fix the problem. For a list of cars effected by this problem. See the NEWROCKIES link on the right side of their page.........
----- http://newrockies.ca?ap_id=judd0081
----- With this fix, you can take that whole Vats, passlock, passkey **** system out of your car all together. Good info on both sites

Posted on Jan 16, 2011

  • 1 Answer

SOURCE: i need serpentine drive belt diagram for 2004

Here is a diagram i have.
If it's to small just let me know.
2004 Monte Carlo with 3.8

Posted on Aug 04, 2009

  • 295 Answers

SOURCE: My 2000 monte carlo ss with a 3800 engine tends to

I believe the codes are emmission related. I would have the fuel pump pressure checked. The fuel filter and fuel pressure regulator seems to be the failrue. The restarting of the engine several times is making the system build up enough pressure to start running . I would take to a shop to have the fuel pressure checked.

Posted on Mar 15, 2009

ginko
  • 19396 Answers

SOURCE: 2002 monte carlo ss

The fuel filter is located in the pressure line that runs from the fuel tank to the engine, near to the fuel tank.
Keep the engine off for few hours before replacing the filter, to get rid of some pressure in the lines.

Posted on Feb 27, 2009

bibleman01
  • 334 Answers

SOURCE: 2002 Monte Carlo SS starting when it wants

The Starter silenoid is probably what the problem is. And the knocking could that be a loose starter? The two problems doesn't seem connected.
God Bless Greg

Posted on Nov 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

04 monte carlo ss engine temp slowly goes up and oil pressure gage bottoms out at idle. Drive and engine temp stops raising and starts to slowly decrease. Next stop, at idle cycle continues. Oil pressure...


Sounds like you need to replace thermostat assy and add new antifreeze and as far as your oil gauge, replace the "oil pressure sending unit". That should solve your problem

Mar 12, 2015 | 2004 Chevrolet Monte Carlo

1 Answer

Where is the fuel pump restart switch on a chevy


Assuming this is a fuel injected car the Fuel pump reset is usually in the trunk usually the same side where the fuel filler cap is.

Sep 17, 2014 | 2002 Chevrolet Monte Carlo

1 Answer

Where is the fuel pump restart switch on a chevy


How can you tell if you're timing chain need to be replaced?? On my 2002 Monte just keep turning

Sep 17, 2014 | 2002 Chevrolet Monte Carlo

1 Answer

202 monte carlo ss put new battery in now it's dead then i recharged it now it's dead again after running the car


Check all the light in the car, one must be on. Check the sun visor lights first. Others include under-hood light, trunk lights and interior lights that come on by themselves due to faulty switches. Other reasons are a bad diode in the alternator, disconnect it and see what happens..

Oct 31, 2012 | Cars & Trucks

1 Answer

Why water mix with the oil in a 202 monte carlo ss 3800 engine


you have a blown head gasket or leak at the intake gasket 9 out of 10 it the head gasket good luck....

Oct 31, 2012 | Cars & Trucks

1 Answer

Oil gauge on a 02 monte carlo ss when the engine is started up the oil gauge goes from L to H & when i idela thje engine it stays on HIGH /


Have your mechanic check the oil pressere with a scanner or a manual gauge if pressure is different from gauge it needs a sender or the gauge needs replaced

Oct 20, 2012 | Cars & Trucks

1 Answer

Oil gauge on 02 monte carlo ss


Sounds like the oil pressure sending unit is bad.

Oct 19, 2012 | Cars & Trucks

1 Answer

Is it normaol for the oil pressure gague to go up when excelerating in a monte carlo ss 2001


yes it is. this is typical of most cars - the oil pump is gear driven, as your RPMs go up so does the oil pressure.

May 14, 2010 | 2004 Chevrolet Monte Carlo

2 Answers

My 2000 monte carlo ss with a 3800 engine tends to start and stall about six times befor running, I pulled 3 codes 0108, 0404, and 1404 from the the computer .


I believe the codes are emmission related. I would have the fuel pump pressure checked. The fuel filter and fuel pressure regulator seems to be the failrue. The restarting of the engine several times is making the system build up enough pressure to start running . I would take to a shop to have the fuel pressure checked.

Mar 15, 2009 | 2000 Chevrolet Monte Carlo

1 Answer

2002 monte carlo ss


The fuel filter is located in the pressure line that runs from the fuel tank to the engine, near to the fuel tank.
Keep the engine off for few hours before replacing the filter, to get rid of some pressure in the lines.

Feb 27, 2009 | 2002 Chevrolet Monte Carlo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

360 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...