Question about Dodge Cars & Trucks

1 Answer

Ok.. I just purchased a 06 Dodge Magnum SXT from my brother w/ only 87,000 miles on it. But the problem is that the car barely turns over, and when it does it only runs for a few seconds and then stalls. The check engine light as well as the lightning bolt between ) ( is flashing. The battery is also dying on it so I have to get a jump every time I have something done to the car. 1st took it to my a recommended mechanic and he told me that the

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,212 Answers

Start with a good battery. Then try starting it and let it run for a few minutes if it will. Then retrieve the error codes by first, shutting off all accesories, then turn the key to "on"- without starting it. then "off" then :"on": then "off" and then back to "on" and leave it so the OBD can read out the error codes in the odometer location. You should see 3 or 4 codes. Write them down and address them in that order. Sometimes repairing one item will correct multiple codes. Doing the key thing should take less than 5 seconds before it starts to display the codes. It will read "Done" when it reaches the end.

Posted on Oct 31, 2012

  • kalunji_hash
    kalunji_hash Nov 08, 2012

    Update: Ok, I went and bought a new battery & had it installed. Then I was able to finally pull codes by doing the "key dance" and 2 came up. P0688, & P2101. I know that the 2101 code is a thrttle body issue so I got mines cleaned 1st to see if I'll help but it's still cutting off on me plus the code is still coming up, so I've ordered another one. Now as far as the 0688 code I know its the ASD relay issue so I bought a new relay and I'm going to install it in the morning due to the fact its raining right now.. I'll keep you guys posted on what happens..

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 398 Answers

SOURCE: 1987 F150 302 ci. EFI, Automatic,

try over riding the starter relay on the fender ,it has one there right?. dont go to a mechanic yet. the engine aint seized. if it doesnt have this relay then i would get the alternator tested. if you want to test it yourself it can be costly for the right equip. autozone usually tests for free. i dont know were you live so if theres not an autozone. let me know if you cant get it tested.

Posted on Mar 27, 2009

  • 1 Answer

SOURCE: 2004 dodge ram 1500 5.7 hemi 4x4 4 door 90k miles

Take throttle body off, clean Throttle Body with Carburator cleaner. I had same problem and its the ethynol in fuel that creates a build up in the throttle body which creates this problem. I did what a friend of mine said to do (service manager at Dodge Dealership) it hasnt happened again.

Posted on Dec 29, 2008

  • 1118 Answers

SOURCE: Stalling on our 96 Dodge Caravan

Once a filter plugs its pluged. You drop that much pressure its time for a new fuel pump.

Posted on Mar 21, 2009

  • 83 Answers

SOURCE: Check engine light/2004 Audi A6 Quattro/3.0L

hi, if you still have time to take it back to the dealer. take it to them.

Posted on Apr 26, 2009

  • 2 Answers

SOURCE: 2005 Dodge Neon SXT P0700 error code

check to see if your tentioner spring loaded pulley is operating properly.
i.e. you can move it with hand pressure it can be to hard to move or too easy.
both can cause this problem. loosen or tighten the retainer bolt.

Posted on Jul 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I hooked my battery up backwards in my 06 dodge magnum sxt awd.now it wont shift and nothing on the steering colum works anyone got any ideas on what I should do ?


Take it to the dealer or a very knowledgeable, reputable mechanic, and be prepared to spend a lot of money for trashed electronic components.

Nov 12, 2016 | Dodge Cars & Trucks

1 Answer

05 Magnum sxt 3.5l, CEL came on/ code P0128. I changed the thermostat,coolant sensor,new coolant reset the code. I went about 100 miles and the CEL came on with the same Code P0128.Bleed the system reset...


Therm. is being held open causing the engine to not heat up to a full 190 degrees. make sure you put in a 190 degree therm. and unhook the negative battery cable for at least 5 minutes to clear the code. the system could need a flush too, with over 100,000 miles or 5 years

Feb 18, 2015 | 2005 Dodge Magnum SXT

1 Answer

My alarm system is tuck on my 2006 dodge magnum and I need to reset it?


turn your key on and off about 6 or 8 times.. should reset it.

Jan 24, 2015 | 2006 Dodge Magnum SXT

1 Answer

What cause my transmission to lock in park


check if your brake lights are working if not replace fuse if fuse is good replace switch .if your brake lights work you should be able to put car in gear. if this was helpful please leave feed back

Sep 17, 2014 | Cars & Trucks

1 Answer

How do I get to the front/side blinker bulb on my 2006 dodge magnum sxt


There go

Remove the entire lamp assy

Been that way for 20 years

Aug 25, 2014 | 2006 Dodge Magnum SXT

2 Answers

How do I reset the engine light on my 06 magnum sxt?


u can do it with a scanner or try disconnecting the battery for 3 minutes

Oct 02, 2010 | 2006 Dodge Magnum

1 Answer

My 06 magnum sxt won't shift out of park, tried the release in the console. still no good, now I can't remove the key had to disconnect the battery,.


If its anything like my old VW car it may be the stearing lock thats preventing the car key from turning. Pull the stearing wheel one way as hard as you can then the other way then jiggle it while trying to get the key out of the ignition. Nothing to worry about, the lock in there just gets stuck sometimes.

Jun 26, 2009 | 2007 Dodge Magnum SRT8 Wagon

1 Answer

2005 Magnum Noise on Cold Start


lack of oil in top end, on start up ! running 0-20 synth oil right, I add some LUKAS oil treatment,

Dec 14, 2008 | 2005 Dodge Magnum

1 Answer

Noise at strart


The tapping, I think, from the limited information, is the Valves not getting the Oil due to low oil pressure. Once the engine warms up, and the Oil pump starts to flow the oil, the tapping stops. Many vehicles, do this. I would not be overly concerned about the tapping, but I would be concerned about the coolant leak. An easy way to see if you have an external leak is to go to a local parts store, and purchase a leak test kit, which usually is a dye, which can be seen with a blacklight. Take vehicle to repair facility and have a Carbon Block Test done

Nov 24, 2008 | 2005 Dodge Magnum

1 Answer

Window problems with 2006 Dodge Magnum SXT


You may want to try and pull fuse 11 or unplug the negative battery terminal for 10-15 seconds and reconnecting/inserting.  You can also try a key dance to check for an internal errors, im not sure if a window motor would throw any however. 
http://www.custommagnums.com/forums/misc-mods/1361-how-check-obd-2-codes.html

Jul 15, 2008 | 2006 Dodge Magnum

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...