Question about Buick Cars & Trucks

Open Question

2001 buick lesabre replace evap vent solenoid

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 19 Answers

SOURCE: Replacing front wheel bearing

The brake rotor needs to be removed, drive shaft nut in center of hub then 3 bolts hold the hub assembly to spindle from back side. if it has abs unplug it then some work will need to be done with a hammer and chisel to work the bearing out of spindle and axle shaft from bearing

Posted on Oct 16, 2008

jpstuhr
  • 49 Answers

SOURCE: Troubleshooting code: P0442

Here ya go

6b631d6.jpg

Posted on Feb 11, 2009

  • 312 Answers

SOURCE: 2001 buick lesabre gas cap loose warning light

GM vehicles are fmaous for this warning. I had the same problem in my GM vehicle and had to replace the EVAP vent solenoid. Are you getting a DTC yet or just the tighten gas cap message? INspect the fuel cap to make sure it is not damaged and is installed properly. If it's damaged replace it. If all is good on the cap just wait for the DTC to show up but most likely you'll need to replace that solenoid.

Posted on Dec 22, 2009

Testimonial: "very helpful"

ZJLimited
  • 17970 Answers

SOURCE: I need a diagram to replace the serpentine belt on

2001 BUICK LESABRE - V6 3.8L 231ci GAS FI N K

Belt Routing Diagram - Multiple Accesory
bfe315e.jpg

From DAYCO Catalogue

Hope help with this (remember rated this) Good luck.

Posted on Feb 08, 2010

  • 7 Answers

SOURCE: Bad Evap Vent Solenoid

On the passenger side of the car there it a canister next to the gas tank (right infront of the rear wheel) it's right there. You don't need to pull the wheels to access it.

Posted on Jun 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Code 1675 car stalls when slowing down


EVAP vent solenoid problem. Probably stalling from fuel vapors making mixture over rich . Have EVAP solenoid tested as it or the PCM can be bad.

Nov 17, 2015 | 1997 Buick LeSabre

1 Answer

Computer code 455


Possible causes - Missing or loose fuel cap
- Incorrect fuel filler cap used
- Fuel filler cap remains open or fails to close
- Foreign matter caught in fuel filler cap
- EVAP canister or fuel tank leaks
- EVAP system hose leaking
- Fuel tank leaking The P0455 it's a very common code, because the code is set if the gas cap is loose or missing. Start by tighten the gas cap and clearing the code. In most cases the code can be clear by disconnecting the car battery for about 30 minutes.

When is the code detected? EVAP control system has a very large leak such as fuel filler cap fell off, EVAP control system does not operate properly. Possible symptoms - Engine Light ON (or Service Engine Soon Warning Light)
- Possible a noticeable fuel odor caused by the release of fuel vapors P0455 Buick Description This diagnosis detects leaks in the Evaporative Emission System (EVAP) purge line using engine intake manifold vacuum. If pressure does not increase, the Engine Control Module (ECM) will check for leaks in the line between the fuel tank and EVAP canister purge volume control solenoid valve under the following vacuum test condition. The vacuum cut valve bypass valve is opened to clear the line between the fuel tank and the EVAP canister purge volume control solenoid valve. The EVAP canister vent control valve will then be closed to shut the EVAP purge line off. The EVAP canister purge volume control solenoid valve is opened to depressurize the EVAP purge line using intake manifold vacuum. After this depressurization is implemented, the EVAP canister purge volume control solenoid valve will be closed.
if tightening the cap or replacing the cap does not help take your car to a shop to have it diagnosed as it requires special tools/equipment to test this and get an accurate results to find what needs replacing.

Oct 10, 2014 | 2004 Buick LeSabre

2 Answers

What does code p0446 mean on a 2001 Buick Centry?


P0446 Evaporative Emission Control System Vent Control Circuit Malfunction The code P0446 is set when the engine computer recognizes a fault or restriction at the vent control part of the Evaporative emission control system (EVAP). The description of the fault varies between different car manufacturers, but one thing is common, the code P0446 doesn't directly point to a defective part; some testing might be required to pinpoint the faulty component. What can cause the code P0446: - faulty vent control valve - blockage at the vent hose, vent filter or vent control valve - open or short in the vent control valve circuit - bad charcoal canister - EVAP system leak - faulty EVAP system pressure sensor - bad vacuum switching valve (VSV) - stuck open purge valve (solenoid)

Aug 13, 2014 | 2001 Buick Century

3 Answers

Have a code p0449 have. already changed the evap vent solenoid . any suggestions?


P0449....Evaporative Emission Control System Vent Valve/Solenoid Circuit could be the engine breather

Dec 24, 2010 | 2002 Buick LeSabre

1 Answer

I have a 04 buick rend and i'm getting the p 0449 code how can i find out what it is and where


CODE PO449 - EVAP VENT SOLENOID CONTROL CIRCUIT MALFUNCTION CONDITION. FIRST CHECK EVAP SOLENOID FUSE.IF ALL IS GOOD EVAP VENT SOLENOID LOCATED ON A BRACKET NEXT TO FUEL TANK.

Oct 13, 2010 | 2006 Kia Spectra

3 Answers

2001 buick lesabre gas cap loose warning light continues to stay on after being replaced


GM vehicles are fmaous for this warning. I had the same problem in my GM vehicle and had to replace the EVAP vent solenoid. Are you getting a DTC yet or just the tighten gas cap message? INspect the fuel cap to make sure it is not damaged and is installed properly. If it's damaged replace it. If all is good on the cap just wait for the DTC to show up but most likely you'll need to replace that solenoid.

Dec 22, 2009 | 2001 Buick LeSabre

1 Answer

Check engine soon light. diagnosed as troble shooting codepo44


Change the evap vent solenoid canister located near the master cylinder on the right side of the engine or your hoses may be cracked. Good luck!

Nov 16, 2008 | 1994 Buick LeSabre

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...