Question about Lincoln Cars & Trucks

1 Answer

How do I remove the inner door panel for a mitsubishi magna 2003?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 645 Answers

Insert the tip of your panel tool behind the edge of the plastic screw cover on the front edge of the door panel. Pry the screw cover off.Pry off the two screw covers on the back edge of the door panel. Remove the Phillips screw behind each cover.Loosen and remove a single Phillips screw from the trim surrounding the door release handle. Pull the trim piece off the door panel after the screw has been released.
hope it can help you! and if you need an auto tool you can click here: great tools

Posted on Oct 31, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: how to remove drivers inner

how to remove drivers inner door panel on 2003 cadillac deville dhs to repair window trac

Posted on Dec 28, 2008

  • 295 Answers

SOURCE: how remove the rear inside door panel on a 2001 oldmobile aurora

The inner door panel is held in by clips and screw.
Look at the door near the door handle there should be screws holding it in and along the outer edge of the door. Once loose, and the door handle removed or the arm rest removed. The door panel then prys out , because of the clips that hold it on. Then pops out by applying pressure to the panel upward to the top of the door. The clips always break because of the design and plastic.

Good luck

Posted on Mar 21, 2009

  • 1986 Answers

SOURCE: 2003 ford thunderbird how do you remove inner door panel?

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

  • 1986 Answers

SOURCE: Remove right rear door panel 2003 Buick LaSabre

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

  • 1986 Answers

SOURCE: 94 LeSabre inner door panel removal

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls

Posted on Sep 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I install the exterior front door handle?


Take out inner door handle bezel-1 philips screw. Then remove 2 large screws under inner door handle. The lower light lens can then be removed exposing 2 small philips screws. Remove those and take out light assy and unplug. Use a screwdriver to pry gently on window-lock control switch assy. Remove and unplug. Then gently pry inner door panel off. The inner door handle and cables can be moves by sliding plastic assy back and out. Then you can remove the plastic rainliner exposing the door handle assy. 2 10mm bolts hold it in. Theres also to rods to remove by releasing clips and sliding rods out.

Feb 11, 2015 | 2004 Mitsubishi Endeavor

1 Answer

How to remove a manual window winder from a 1997 mitsubishi magna sedan


There is a spring clip (kinda like a c-clip) underneath the crank handle, holding it fast to the stub shaft it sits on. There is a special hand tool made for window crank handle removal-a couple of dollars should buy one. But you can also use a rag to get the handle off. Slip the rag underneath the edge of the crank handle, get it between the handle and the door panel, and saw the rag back and forth under the handle. The rag will catch the ends of the c-clip and push them back so the handle can be removed. You may have to slip the rag around the handle till you catch the ends of the spring clip.

Nov 14, 2012 | 1997 Mitsubishi Magna

1 Answer

How to remove door panel on 2003 grand caravan



  1. Remove the plug and remove screw attaching door pull cup to inner door panel.
  2. Remove the switch bezel and then disconnect the power window-memory switch.
  3. Now you need to remove the screws attaching the trim panel to the door from below map pocket.
  4. If you have a window crank remove this now.
  5. Remove the screw holding the door trim to the door panel from behind -inside latch release handle .
  6. Now disengage the clips attaching the door trim to the door frame around the outside of the panel.
  7. Lift the trim panel upward to disengage the flange from the inner belt molding at the top of the door.
  8. Now tilt the top of trim panel away from door to gain access to the linkage on the latch.
  9. Now you need to disengage the clip that attaches the linkage rod to the inside latch release handle - this is the inside door handle linkage.
  10. Now just separate the linkage rod from the latch handle.
  11. Now you disconnect the power door switch and the courtesy lamp connectors.
  12. Now you can remove the door trim panel up and out.


  • Hope this helps and thank you for using FixYa.

Regards, Tony

Jul 23, 2011 | 2003 Dodge Caravan

1 Answer

How to change side view mirror on Mitsubishi lancer 2003


remove inner arm rest and and panel take three bolts out of back side of mirror and disconnect connector reverse install

May 28, 2011 | 2003 Mitsubishi Lancer

1 Answer

How do I remove driver side door window


You need to remove inner door panel by unscrewing the screws on inner door handle and take a flat screw driver wedge it between the panel and door use flash light to see the clips along the sides and lower part of door and pry them free. then look through the inner door cut outs to find window track. Once you see it use ratchet or screw driver and loosen the window free form track. Then carefully remove window.

Apr 01, 2010 | 2003 Mazda MPV

1 Answer

2003 ford thunderbird how do you remove inner door panel?


You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Jun 12, 2009 | 2003 Ford Thunderbird

1 Answer

Door panel removal


there are a few screws you need to remove before pulling off the panel. one is in the inner door handle, the other is behind the inner door release handle and there may be one in the very top left of door panel

Dec 30, 2008 | 2005 Jeep Liberty

2 Answers

Mitsubishi 2003 Magan v6


Magna (not magan) THis is the performance Australian version. Pretty much the same a the american one (I think it has like 5 to 10 more hp)

Dec 02, 2008 | 2003 Mitsubishi Diamante

1 Answer

How to remove drivers inner door panel on 2003 cadillac deville dts to repair window trac


how to remove drivers inner door panel on 2003 cadillac deville dhs to repair window trac

Jul 26, 2008 | 2004 Cadillac Deville

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

593 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

80637 Answers

fordexpert

Level 3 Expert

5687 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...